manual transmission MERCEDES-BENZ E WAGON 2005 S211 Owner's Manual

184 Controls in detailAutomatic transmission1Current gear range/gear selector lever
position
2Current program mode
The current gear range/gear selector lever
position and program mode (
C/S) appear
in the multifunction display.An additional indication of the current gear
selector lever position can be found on the
cover of the shifting-gate.
The indicators come on when you activate
a switch (e.g. unlocking the vehicle or
opening a door) and go out after approxi-
mately 15 minutes.
When the gear selector lever is in
positionD, you can influence transmission
shifting by:


limiting the gear range


changing gears manually
Warning!
G
It is dangerous to shift the gear selector
lever out ofP orN if the engine speed is
higher than idle speed. If your foot is not
firmly on the brake pedal, the vehicle could
accelerate quickly forward or reverse. You
could lose control of the vehicle and hit
someone or something. Only shift into gear
when the engine is idling normally and when
your right foot is firmly on the brake pedal.
!Allow engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature
has been reached.
Shift into reverse gearR or parking
positionP only when the vehicle is
stopped.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces. This may cause
serious damage to the drivetrain which
is not covered by the Mercedes-Benz
Limited Warranty.

185 Controls in detail
Automatic transmission
One-touch gearshifting
Even with an automatic transmission you
can change the gears manually when the
gear selector lever is in positionD.
Downshifting
Briefly press the gear selector lever to
the left in theD-direction.
The transmission will shift from the current
gear to the next lower gear. This action
simultaneously limits the gear range of the
transmission (
page 186).Upshifting

Briefly press the gear selector lever to
the right in theD+direction.
The transmission will shift from the current
gear to the next higher gear as permitted
by the shift program. This action simul-
taneously extends the gear range of the
transmission.Canceling gear range limit

Press and hold the gear selector lever
in theD+direction until
D reappears in
the multifunction display.
The transmission will shift from the current
gear range directly to gear rangeD.
Shifting into optimal gear range

Press and hold the gear selector lever
in theD-direction.
The transmission will automatically select
the gear range suited for optimal
acceleration and deceleration. This will
involve shifting down one or more gears.
Warning!
G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced
vehicle control. Your vehicle’s ABS will not
prevent this type of loss of control.
iTo avoid overrevving the engine when
the gear selector lever is moved to
theD-direction, the transmission will
not shift to a lower gear if the engine’s
max. speed would be exceeded.

319 Operation
Tires and wheels

Switch on the ignition (
page 34).

Press buttonè orÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu ap-
pears in the multifunction display
(page 158).

Press the j or k button until the
current inflation pressures for each tire
appear in the multifunction display.iPossible differences between the read-
ings of a tire inflation pressure gauge of
an air hose, e.g. gas station equipment,
and the vehicle’s control system can
occur. The readings issued by the con-
trol system are more precise.
Warning!
G
When the tire pressure monitoring system*
warning light is lit, one or more of your tires
is significantly under-inflated. You should
stop and check your tires as soon as possi-
ble, and inflate them to the proper pressure
as indicated on the vehicle’s tire information
placard. Driving on a significantly under-in-
flated tire causes the tire to overheat and
can lead to tire failure. Under-inflation also
reduces fuel efficiency and tire tread life,
and may affect the vehicle’s handling and
stopping ability. Each tire, including the
spare, should be checked monthly when
cold and set to the recommended inflation
pressure as specified in the vehicle placard
and Operator’s Manual.iThe recommended tire inflation pres-
sures for your vehicle can be found on
the placard of the driver’s door B-pillar
or the inside of the fuel filler flap, not in
the Operator’s Manual.
Warning!
G
The tire pressure monitoring system* does
not indicate a warning for wrongly selected
inflation pressures. Always adjust tire infla-
tion pressure according to the placard of the
driver’s door B-pillar or the inside of the fuel
filler flap.
The tire pressure monitoring system* is not
able to issue a warning due to a sudden dra-
matic loss of pressure (e.g. tire blowout
caused by a foreign object). In this case
bring the vehicle to a halt by carefully apply-
ing the brakes and avoiding abrupt steering
maneuvers.iOperating radio transmission equip-
ment (e.g. wireless headsets, two-way
radios) in or near the vehicle could
cause the tire pressure monitoring sys-
tem* to malfunction.

432 Practical hintsTowing the vehicle
iTo signal turns while being towed with
the hazard warning flasher in use, turn
SmartKey in starter switch to
position2 and activate the combina-
tion switch for the left or right turn sig-
nal in the usual manner – only the
selected turn signal will operate.
Upon canceling the turn signal, the haz-
ard warning flasher will operate again.
!When towing the vehicle with all wheels
on the ground, please note the follow-
ing:
With the automatic central locking acti-
vated and the SmartKey in starter
switch position2, or KEYLESS-GO*
start / stop button in position2, the ve-
hicle doors lock if the left front wheel
as well as the right rear wheel are turn-
ing at vehicle speeds of approximately
9mph (15km/h) or more.
Switch off the tow-away alarm
(page 99).
To prevent the vehicle door locks from
locking, deactivate the automatic cen-
tral locking (
page 122).
Towing of the vehicle should only be
done using the properly installed tow-
ing eye bolt. Never attach tow cable,
tow rope or tow rod to the vehicle chas-
sis, frame or suspension parts.
iThe selector lever will remain locked in
positionP and the SmartKey will not
turn in the starter switch if the battery
is disconnected or discharged. For
more information, see “Battery”
(page 424) and “Jump starting”
(page 428).
For information on manual unlocking of
the transmission selector lever, see
(page 405).

463 Technical terms
Power train
Collective term designating all compo-
nents used to generate and transmit
motive power to the drive axles, includ-
ing:


Engine


Clutch/torque converter


Transmission


Transfer case*


Drive shaft


Axle shafts/axles
Production options weight
(
page 334)
PSI
(Pounds per s
quare i
nch)
(
page 334)Program mode selector switch
Used to switch the automatic transmis-
sion between standard operationS and
operationC.
E 55 AMG with steering wheel gearshift
control and manual shift program: in
addition to S and C (for sporty S or
comfortable C operation), you can use
M for manual shift program.
Restraint systems
Seat belts, belt tensioners, air bags and
child restraint systems. As indepen-
dent systems, their protective func-
tions complement one another.
Rim
(
page 334)RON
(R
esearch O
ctane N
umber)
The Research Octane Number for gaso-
line as determined by a standardized
method. It is an indication of a gaso-
line's ability to resist undesired detona-
tion (knocking). The average of both
the ->MON (Motor Octane Number)
and RON (Research Octane Number) is
posted at the pump, also known as
ANTI-KNOCK INDEX.
SBC
(S
ensotronic B
rake C
ontrol)
Electronically controlled hydraulic
braking system for increased braking
safety and comfort.
Shift lock
When the vehicle is parked, this lock
prevents the transmission selector le-
ver from being moved out of positionP
without the ignition or engine on and
brake pedal depressed.

467 Index
Automatic transmission 183
Comfort program mode 188
Emergency operation (Limp Home
Mode) 190
Gear ranges 186
Gear selector lever position 187
Gear shifting malfunctions 190
Manual shifting 185
One-touch gearshifting 185
Program mode selector switch 188
Selector lever position 183
Starting the engine 47
Automatic transmission*
Accelerator position 189
Kickdown 189
B
Backrest
Folding forward 247
Folding rearward 248
Bar 333
BAS 89, 459
Batteries, SmartKey
Changing 408, 409
Check lamp 105, 111
Checking 106, 112Batteries, SmartKey with KEYLESS-GO*
Changing 408, 409
Batteries, vehicle
Charging 427
Disconnecting 426
Reconnecting 427
Removing 426
Service 424
Battery discharged
Jump starting 428
Bead 333
Belt reel 254
Bi-Xenon headlamps* 459
Block heater* 338
Blocking
Rear window operation 84
Brake assist system (BAS) 459
Brake fluid 297, 377
Brake pads
Message in display 375
Brakes
Brake fluid 298
Warning lamp 354
Break-in period 284Bulbs, replacing
Additional turn signals 410
Fog lamps 410
Front lamps 410, 413
High beam 411
High mounted brake lamp 411
License plate lamps 411, 415
Low beam 411
Parking lamps 411
Side marker lamps 410, 415
Standing lamps 411
Tail lamp 411
Tail lamp assemblies 415
Turn signal lamp 410
C
CAC (Customer Assistance Center) 459
Calling up
Distronic* settings 160
Maintenance service indicator 341
Range (distance to empty) 179
CAN system 459
Cargo compartment
Fuse box 435
Cargo compartment cover 257
Cargo management system* 252
Cargo net 256

479 Index
Power tilt /sliding sunroof* 225
Closing 225
Opening 225
Stopping 227
Power tilt /sliding sunroof**
Synchronizing 227
Power train 463
Power washer 345
Power windows 221
Blocking of rear window operation 84
Convenience closing feature 224
Summer opening feature 223
Synchronizing 223
Practical hints
Collapsible wheel chock 403
First aid kit 401
Jump starting 428
Lamp in center console 360
Lamps in instrument cluster 352
Spare wheel 402
Vehicle status messages in the multi-
function display 362
Vehicle tool kit 403
Problems
While driving 55
With vehicle 17Product information 9
Production options weight 334
Program mode selector switch 463
Automatic transmission 188
PSI 334
PULSE function (Massage function) 131
Q
Quick search
Phone book* 181
R
Radio
Selecting stations 158
Selecting stations (satellite*) 159
Radio transmitters, control and
operation 293
Range (distance to empty)
Calling up 179
Rear bench seat
Foldable 247
Rear doors
Opening from inside vehicle 115
Rear fog lamp
Bulb 410
Switching on 145
Rear interior lighting 148Rear lamp bulbs 411
Rear lamps see Tail lamps
Rear outer seats
Adjusting head restraint height 128
Rear passenger compartment
Adjustable air vents 219
Rear reading lamps 149
Rear seat head restraints
Adjusting manually 129
Folding back manually 127
Folding back with switch in the center
console 127
Installing 130
Outer seats 129
Removing 129
Rear view mirrors see Mirrors 191
Rear window
Blocking operation 84
Rear window defroster 195
Activating 195
Deactivating 195
Rear window sunshade* 194
Recommended inflation pressure 334
Reconnecting
Vehicle battery 427