flat tire MERCEDES-BENZ G500 2004 W463 User Guide

307 Practical hints
Flat tire
Mounting the spare wheel
Prepare the vehicle (
page 306).
Lifting the vehicle

Prevent the vehicle from rolling away
by blocking wheels with wheel chocks
(not included) or other sizable objects.
When changing wheel on a level surface:

Place one chock in front of and one be-
hind the wheel that is diagonally oppo-
site to the wheel being changed.
When changing wheel on a hill:

Place chocks on the downhill side
blocking both wheels of the other axle.
Wheel wrench
On wheel to be changed, loosen but do
not yet remove the wheel bolts (ap-
proximately one full turn with wrench).
Warning!
G
The jack is designed exclusively for jacking
up the vehicle under the axle housing. To
help avoid personal injury, use the jack only
to lift the vehicle during a wheel change.
Never get beneath the vehicle while it is sup-
ported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always firmly set parking brake and block
wheels before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on level surface. Make sure the jack is posi-
tioned correctly under the axle housing. Al-
ways lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.
If the vehicle is not raised as described, it
could slip off the jack as a result of vibra-
tions (e.g. opening or closing a door or the
tailgate).

308 Practical hintsFlat tirePump handle (three pieces)1Indent for activation of release bolt2
Assemble the pump handle for the
jack. The pump handle is located in the
vehicle tool kit.
Jack2Release bolt
Close release bolt2.
To do so, turn indent1 to the right in
the pump lever until its stop.

Place jack on firm ground.

Position jack under the axle housing,
so that it is always vertical (plumb-line)
as seen from the side, even if the vehi-
cle is parked on an incline.
Be certain the jack arm is positioned
correctly under the axle housing (axle
must fall into jack contour).

Jack up the vehicle by pumping (arrow)
until the wheel is clear of the ground.
Never start engine while vehicle is
raised.
iNever turn release bolt2 more than
one or two revolutions. Hydraulic fluid
can otherwise escape.

309 Practical hints
Flat tire
Removing the wheel
Remove the wheel bolts.

Remove the wheel.Mounting the new wheel

Clean contact surfaces of wheel and
wheel hub.

Push the wheel onto the wheel hub and
press firmly.

Insert wheel bolts and tighten them
slightly.
!Do not place wheel bolts in sand or dirt.
This could result in damage to the bolt
and wheel hub threads.Warning!
G
Make sure no one is injured when removing
the wheel.
Grip wheel from the sides.
Keep hands from beneath the wheel.
Warning!
G
Always replace wheel bolts that are dam-
aged or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be re-
paired immediately. Do not continue to drive
under these circumstances! Contact an au-
thorized Mercedes-Benz Light Truck Center
or call Roadside Assistance.
Incorrect wheel bolts or improperly tight-
ened wheel bolts can cause the wheel to
come off. This could cause an accident.
Make sure to use the correct wheel bolts.
Warning!
G
Use only genuine equipment
Mercedes-Benz wheel bolts. Other wheel
bolts may come loose.
Do not tighten the wheel bolts when the ve-
hicle is raised. Otherwise the vehicle could
tip over.

310 Practical hintsFlat tireLowering the vehicle
Using the pump lever, open the lower-
ing screw on the jack approximately
one turn (
page 308).
The vehicle is resting fully on its own
weight.

Remove the jack.
After use, disassemble pump handle
(page 308) and store jack in the des-
ignated storage compartment
(page 284).
1-5 Wheel bolts

Tighten the five wheel bolts evenly, fol-
lowing the diagonal sequence illustrat-
ed (1 to 5), until all bolts are tight.
Observe a tightening torque of 97 lb-ft
(130 Nm).

Press the jack piston in again and close
the lowering screw. Store the jack
(page 284) and the other vehicle
tools (
page 283).

After changing the wheel, secure the
damaged wheel on the spare wheel
mounting bracket (
page 286). Make
sure the wheel cannot come loose.

Check the tire inflation pressure and
correct it if necessary.
A table with the tire pressure values for
your vehicle is located on the fuel filler
flap.
Warning!
G
Have the tightening torque checked after
changing a wheel as soon as possible. The
wheels could come loose if they are not
tightened to a torque of 97 lb-ft (130 Nm).

329 Technical data
Rims and tires
Rims and tires
Use only tires and rims which have been
specifically developed for your vehicle and
tested and approved by Mercedes-Benz.
Other tires and rims can have detrimental
effects, such as

poor handling characteristics


increased noise


increased fuel consumption
Rims and Tires
!Moreover, tires and rims not approved
by Mercedes-Benz may, under load, ex-
hibit dimensional variations and differ-
ent tire deformation characteristics
that could cause them to come into
contact with the vehicle body or axle
parts. This may result in damage to the
tires or the vehicle.
iFurther information on tires and rims is
available at any authorized
Mercedes-Benz Light Truck Center. A
tire inflation pressure table is located
on the fuel filler flap of the vehicle. The
tire pressure should be checked regu-
larly and should only be adjusted on
cold tires. Follow tire manufacturer’s
maintenance recommendation includ-
ed with vehicle.
G500
G55AMG
Rims (light alloy)
71/2 J x18 H2
91/2 J x 18 EH2
Wheel offset
1.69 in (43 mm)
1.97 in (50 mm)
All season tires (radial-ply tires)
265/60 R18 110V
285/55 R18 113V

341 Technical data
Consumer information
Temperature
The temperature grades are A (the high-
est), B, and C, representing the tire’s resis-
tance to the generation of heat and its
ability to dissipate heat when tested under
controlled conditions on a specified indoor
laboratory test wheel. Sustained high tem-
perature can cause the material of the tire
to degenerate and reduce tire life, and ex-
cessive temperature can lead to sudden
tire failure. Grade C corresponds to a level
of performance which all passenger car
tires must meet under the Federal Motor
Vehicle Safety Standard No. 109. Grades B
and A represent higher levels of perfor-
mance on the laboratory test wheel than
the minimum required by law.
Warning!
G
The temperature grade for this tire is estab-
lished for a tire that is properly inflated and
not overloaded. Excessive speed, underin-
flation, or excessive loading, either sepa-
rately or in combination, can cause
excessive heat build-up and possible tire
failure.

349 Index
A
ABS 25, 74, 343
LOW RANGE mode 75
Malfunction indicator lamp 252, 253
Messages in display 261
Warning lamp 252, 253
Accelerator position, automatic
transmission 144
Accident
In case of 50
Activating
Air conditioning (cooling) 162
Air recirculation mode 160
Anti-theft alarm system 82
Central locking (control system) 133
Defrost 160
Easy-entry/exit feature 133
ESP 81
Exterior headlamps 46
Exterior lamps 105
Exterior rear view mirror parking
position 153Hazard warning flasher 108
Headlamps 46
High beams 108
Ignition 33
Rear fog lamp 106
Rear window defroster 155
Windshield wipers 47
Adding
Coolant 233
Engine oil 231
Additional turn signals 295
Adjusting 34
Air distribution 159
Air volume 159
Backrest tilt 36
Exterior rear view mirror 38
Head restraint height 36
Head restraint height, rear seats 96
Head restraint tilt 36
Instrument cluster illumination 112Interior rear view mirror 38
Mirrors 38
Multicontour seat* 97
Seat cushion length 97
Seat cushion tilt 36
Seat fore and aft adjustment 35
Seat height 36
Seats 34
Steering column in/out 37
Steering column up/down 37
Steering wheel 37
Air conditioning (cooling)
Turning off 162
Turning on 162
Air conditioning refrigerant 335
Air distribution
Adjusting 159
Air pressure see Tire inflation pressure
Air recirculation mode 160
Activating 160
Deactivating 161

356 IndexEmergency operation (Limp Home
Mode) 144
Emergency operations
Closing sliding/pop-up roof 292
Locking the vehicle 288
Opening sliding/pop-up roof 292
Remote door unlock 197
Unlocking the tailgate 287
Unlocking the vehicle 287
Emergency tensioning device see ETD
Emission control 222
Emission control label 326
Ending
A call (telephone) 138
Engine
Compartment 227
Message in display 256
Starting with the key 44
Technical data 328
Turning off with the key 52
Engine cleaning 246Engine compartment 227
Hood 227
Engine malfunction indicator lamp 25,
256
Engine number 344
Engine oil 228, 334
Adding 231
Additives 335, 340
Checking level 228
Consumption 228
Display messages 272
Messages in display 229, 271
Oil dipstick 232
Viscosity 344
Engine oil level see Oil level
Enlarged cargo compartment 176
ESP 25, 74, 78, 344
Messages in display 263
Switching off 79
Switching on 81
Synchronizing 263
Warning lamp 257ETD 56, 65, 344
Safety guidelines 60
Exterior lamp switch 104
Exterior lamps
Delayed switch-off 131
Exterior rear view mirrors
Adjusting 38
Parking position for 135
F
Fahrenheit
Setting temperature units 127
Fastening the seat belts 40
Fine adjustment
Cruise control 171
First aid kit 283
Flat tire 306
Lowering the vehicle 310
Mounting the spare wheel 307
Spare wheel 285

371 Index
Tightening torque (Wheel bolts) 310
Time
Setting display mode 127
Time display mode
Setting 127
Tire inflation pressure
Checking 237
Tire speed rating 211, 347
Tire traction 211
Tires 236, 329
Direction of rotation 237
Driving instructions 210
Retreads 236
Rims and tires 329
Service life 237
Temperature 238
Temperature grades 341
Tread depth 240
Wear pattern 238
Winter 240Tools 283
Tow-away alarm 27, 83
Arming 83
Disarming 83
Disarming for transport 83
Tow-away alarm system
Canceling alarm 84
Towing eye, front 318
Towing eye, rear 318
Towing the vehicle 315
Stranded vehicle 318
Towing the vehicle - various problem
scenarios 317
Tracking services
For stolen vehicle 197
Traction 340, 347
Transfer case 145, 347
Gear range 145
Messages in the multifunction
display 146
Switching 145Transfer case differential lock
Switching on 150
Transmission gear selector lever 290
Unlocking manually 290
Transmission see Automatic transmission
Tread depth (tires) 240
Treadwear 340
Trip computer 136
Trip odometer
Resetting 113
Trunk see Cargo compartment
Turn signal lamps
Replacing bulbs 295, 296
Turn signals 23, 46
Additional in mirrors 295
Cleaning lenses 246
Front bulbs 295
Indicator lamps 25
Rear bulbs 296
Turning off
Engine 52