tow bar MERCEDES-BENZ GL SUV 2012 User Guide

Fitting/removing th
etowing eye
Fitting th etowing eye Example: cover
sfor towin geye mountings
: Front cover
; Bac kcover
Vehicles with atrailer to whitch :ify ou intend
to use the vehicle for towing, fold out the ball
coupling (Y page 259) and con nect the tow-
bar to it.
Th eb rackets for th escrew-i ntowing eyes are
located in the bumpers. They ar eatthe front
and at the rear, under the covers.
X Remove the towing eye from the vehicle
tool kit (Y page 377).
X To ope nthe cover at the front: press the
mark on cover :inwards in th edirection
of the arrow.
X To open the cover at the rear: insert a
flat, blunt object into the cutout and lever
cover ;out of the bumper.
X Remove cover :or; from the opening.
X Screw the towing eye in clockwise to the
stop and tighten it. Removing the towing eye X
Loosen the towing eye and unscrew it.
X Attach cover :or; to the bumper and
press until it engages.
X Place the towing eye in the vehicle tool kit. Towing the vehicle with both axles on
the ground
It is important that you observe the safety
instructions when towing away your vehicle
(Y page 388).
The automatic transmission automatically
shifts to position Pwhen you open the driver's
or front-passenger door or when you remove
the key from the ignition lock.
In order to ensure that the automatic trans-
mission stays in position Nwhen towing the
vehicle, you must observe the following
points:
X Make sure that the vehicle is stationary and
that the key is in position 0in the ignition
lock.
X Turn the key to position 2in the ignition
lock.
On vehicles with KEYL ESS-GO, use the key
instead of the Start/Stop button
(Y pag e159).
X Depres sand hol dthe brake pedal.
X Shif tthe automatic transmission to posi-
tion N.
X Release the brake pedal.
X Release the electric parkin gbrake.
X Leave th ekey in position 2in the ignition
lock.
X Switch on the hazar dwarning lamps
(Y page 122).
i In order to signal achange of direction
when towing the vehicle with the hazard
warnin glamps switched on, use the com-
bination switch as usual .Inthis case ,only
the turn signals for the desired direction
flash .When you reset the combination 390
Towing and tow-startingBreakdown assistance

Trailer loads
Al
lm odels (except
AMG vehicles) Permissible trailer loa
d, unbraked 75
0kg Permissible trailer load, bra
ked(at am inimu mgradie nt-
climbin gcapability of 12 %fromas tandstill) 3500 kg
Maximum drawbar noseweight (the drawbar nose-
weight is no tincluded in th etrai ler load) 14
0kg Permissible rea
raxle loa dwhen towing atrailer 1900 kg
AMG vehicles
Permissible trailer loa
d, unbraked 75
0kg Permissible trailer load, bra
ked(at am inimu mgradie nt-
climbin gcapability of 12 %fromas tandstill) 3050 kg
Maximum drawbar noseweight (the drawbar nose-
weight is no tincluded in th etrai ler load) 14
0kg Permissible rea
raxle loa dwhen towing atrailer 1750 kg
24 GHz radar sensor system
Th e24G Hz radar sensor sys temr equires separate approval for each country. If you are driving
in ac oun tryinw hichthe radar sensor system is not approved ,you must deactivate the system
using the on-boar dcomputer (Y page 283).
The curren tcount ryoverview can be obtained from aMercedes-Ben zService Cent reor in the
In te rnet under: ht tp://www.mercedes-benz.de/betriebsanleitung.
Vehicle swithanavigation system: the radar sensor system is deactivated automatically
near radio tele scope facilities. Adisplay message appears in the multifunction display to tell
you that the radar sensor system is being switched off (Y page 310).
The cur rently active sys temsare automatically deactivated:
R DISTRONIC PLUS (Y page 198)
R Blin dSpot Assist (Y page 238)
R Activ eBlindS pot Assist (Y page 242)
R BA SP LUS (Y page 62)
R PRE-SAFE ®
Brake (Y page 68)
If th edeactiva tion does not occur automatically ,you must deactiva tethe radar sensor system
using the on-board computer (Y page 283). 24 GHz rada
rsensor system
433Technicaldata Z