service MERCEDES-BENZ M-Class 2001 W163 Comand Manual

2
IntroductionAudio Telephone Navigation Index
S y s te m s e ttin g s
Operation - MCS and telephone
MCS navigation supplies you with information to help
you select your route more easily and guides you conve-
niently and safely to your destination. For safety’s sake,
you should not use some of the functions, such as enter-
ing the destination, unless your vehicle is stationary
(electronic key in the steering lock at position 1).
The navigation system does not supply any informa-
tions on stop signs, yield signs, traffic regulations or
traffic safety rules or changes in roads. This always
remains your personal responsibility.Operation safetyG
Warning!
In order to avoid distractions which could lead to
an accident, system settings should be entered with
the vehicle at standstill and the system should be
operated by the driver only when traffic conditions
permit.
Bear in mind that at a speed of just 30 m.p.h.
(approximately 50 km/h), your car is covering a
distance of 50 feet (approximately 14 m) every sec-
ond.
G
Warning!
Any alterations made to electronic components and
the software can cause malfunctions.
The radio, amplifier, CD changer and telephone are
interconnected. Therefore, when one of the compo-
nents is not operating properly or has not been
repaired , it may impair the function of other com-
ponents.
This condition might seriously impair the operat-
ing safety of your vehicle.
We recommend that you have any service work or
alternations to electronic components done in an
authorized Mercedes-Benz Center. Introduction

4
IntroductionAudio Telephone Navigation Index
S y s te m s e ttin g s
Te l e p h o n e
Before you use the telephone............................................61
Operating and display elements - telephone ................. 63
Menu overview - Telephone ............................................. 64
Switching telephone operation on and off ..................... 66
Incoming calls .................................................................... 68
Outgoing calls..................................................................... 70
Dialing a telephone number ............................................ 70
Dialing a number from the phone book ......................... 72
Redial ....................................................................................74
Speed-dialing ...................................................................... 75
Quick-dialing .......................................................................76
Emergency call ....................................................................76
Requesting and displaying Info Services ....................... 79Navigation
Before you use the navigation system ............................ 82
Operating and display elements - Navigation................ 85
Menu overview - Navigation ............................................. 86
Switching navigation operation on and off .................... 88
Inserting or ejecting a navigation CD ............................. 89
Entering destination address ........................................... 90
Saving the current vehicle position .............................. 109
Address Book .....................................................................110
Today’s Plan .......................................................................115
Recent Route editing ....................................................... 120
The principle of route guidance..................................... 122
Route guidance ................................................................. 124
Mute voice instructions................................................... 127
Altering the map scale .................................................... 128
Break off route guidance ................................................ 128
Changing the route calculation mode
during guidance ........................................................... 129
Viewing the Maneuver List during guidance .............. 130
Road obstructed ................................................................ 131
Detour function ................................................................ 134
Setting voice prompt type/frequency ........................... 135 Introductions

42
IntroductionAudioTelephone Navigation Index
S y s te m s e ttin g s
General information on CD playbackLoad the single CD player and the CD changer with 12-
cm CDs only, do not use 8-cm CDs.
Note:
An 8-cm CD adapter may cause damage to the single CD
player or the CD changer and should not be used.G
Wa r n i n g !
The single CD player and CD changer are Class 1
laser products. There is a danger of invisible laser
radiation if the cover is opened or damaged.
Do not remove the cover. The single CD player and
the CD changer do not contain any parts which can
be serviced by the user. For safety reasons, have
any service work which may be necessary per-
formed only by qualified personnel. CD operation

60
Introduction AudioTe l e p h o n eNavigation Index
S y s te m s e ttin g s
Before you use the telephone............................................61
Operating and display elements - telephone ................. 63
Menu overview - Telephone ............................................. 64
Switching telephone on and off ....................................... 66
Incoming calls .................................................................... 68
Outgoing calls..................................................................... 70
Dialing a telephone number ............................................ 70
Dialing a number from the phone book ......................... 72
Redial ....................................................................................74
Speed-dialing ...................................................................... 75
Quick-dialing .......................................................................76
Emergency call ....................................................................76
Requesting and displaying Info Services ....................... 79 Contents - Telephone

62
Introduction AudioTe l e p h o n eNavigation Index
S y s te m s e ttin g s
In the following situations, it is not possible or not yet
possible to use the telephone:
• the telephone is already unlocked but is not (yet)
registered in a network. The message “NO SER-
VICE” is displayed. The telephone will try to register
into a network. If there is no network available, no
phone service, including the emergency number
into memory location 1, will be available. If the net-
work is available, the telephone will be registered.
The above message also appears if the network is no
longer receivable because of weak receiving condi-
tions. The message “NO SERVICE” is displayed if
you try to make a call.
• The message “TELEPHONE NOT ATTACHED” is dis-
played. Please attach the telephone.
• The message “PHONE IS OFF ...” is displayed. Please
switch on the telephone.In the following situations, it is only possible to access
the emergency number programmed into memory loca-
tion 1:
• The unlock code has not yet been entered.
• The unlock code was entered incorrectly.
In the following situations these messages indicate that
it is not possible to make a call:
• “SYSTEM BUSY” - dialing has failed because the cel-
lular system is busy.
• “NO SERVICE” - dialing has failed because network
cannot be received.“ Notes

63
Introduction AudioTe l e p h o n eNavigation Index
S y s te m s e ttin g s
Operating and display elements - telephone
1Switching telephone operation on, page 66
2Color display with main menu
3Sets the volume for handsfree operation of the tele-
phone, page 694Enter the unlock code, page 66
Enter the telephone number, page 70
Speed-dialing: Activates number stored in the phone
book with a maximum of 2 digits, page 75
Quick-dialing: Activates the first ten numbers stored
with one digit, page 76
Enter the emergency call, page 76
5Push joystick to : Scroll list down, page 72
Push joystick to : Scroll list up, page 72
Push joystick to : Select name or number,
page 72
Push joystick to : Select name or number,
page 72
6Softkeys for:’
“SVC“: Info service, page 79
“NUM”: Phone book with numbers list, page 72
“NAME”: Phone book with names list, page 72
7Accepting an incoming call, page 68
Send a call, page 70
8Ending a call
P82.85-4981-26
Telephone

65
Introduction AudioTe l e p h o n eNavigation Index
S y s te m s e ttin g s
1Unlock code menu, page 66
2Main telephone menu
3S: Signal, page 67
R: Roaming, page 67
R (highlighted): Roaming on non-home type system
4Reception indicator, page 695Incoming call, page 68
6Alphanumeric phone book, page 70
7Numeric phone book, page 72
8Info Service, page 79
Telephone

67
Introduction AudioTe l e p h o n eNavigation Index
S y s te m s e ttin g s
Note:
Your unlock code prevents unauthorized persons from
using your telephone. Be sure to memorize this code
carefully. The code is a three digit number.
If you enter an incorrect code, the system returns to the
menu for entering the unlock code.
The unlock code must be entered when the telephone is
switched on for the first time (if phone is in lock mode),
but not if you switch to it from another system (i.e.
radio).
The emergency number programmed in memory loca-
tion 1 can be used even if the unlock code has not been
entered.
“NO SERVICE” - this message will appear in case the
phone is not registered in a network or the network is
no longer receivable because of bad receiving condi-
tions. In this case, the emergency call number cannot be
used.If the telephone is ready for operation “READY” will
appear. In the display the received signal is indicated by
1 to 5 bars, with 5 indicating a strong signal. If you are
not in a home network, the roaming indicator “R” will
be shown.
Outgoing calls, page 70.
P82.85-6533-26
Telephone

76
Introduction AudioTe l e p h o n eNavigation Index
S y s te m s e ttin g s
Quick-dialing
When the main telephone menu is displayed press one
of the number keys ... (e.g.: ) for longer
than 2 seconds.
The phone number or the name stored at this memory
location will appear on the screen.
When the call is initiated, the call time will appear in
the display.
End the call:
Press .Emergency call
Important!
If you press and press the number stored in
memory location 1 (default is 9-1-1) will be dialed.
Pressing and holding for more than 2 seconds will
also initiate the call.
The 9-1-1 emergency call system is a public service.
Using it without due cause is a criminal offence.
The emergency call will be placed as long as the corre-
sponding mobile communications network is available.
To do this, switch the telephone on, if you have not
already done so.
Emergency call will also be placed, if the phone is
locked.
Telephone

79
Introduction AudioTe l e p h o n eNavigation Index
S y s te m s e ttin g s
Requesting and displaying Info Services
Before you can use Info Services, Tele Aid must be acti-
vated at the Response center and the optional Info Ser-
vices selected.
Info Services categories includes news, weather, stocks,
sports and calendar reminders. Choices can be selected
via www.MBUSA.com or by calling 1-800-756-9018.When the main telephone menu is on the display press
the softkey “SVC”. The Info Services display will
appear on the display with the last update.
If there is no information stored “NO INFORMATION
STORED IN MEMORY PLEASE UPDATE“ appears on the
screen.
If there are no information stored or you want to update
the information press the softkey “UPDT“.
In the following situations it is not possible to update
and the following messages appear:
• “DATA CONNECTION CANNOT BE ESTABLISHED“ -
request has failed because Response Center cannot
be accessed.
• TELE AID PLEASE VISIT WORKSHOP“ - a hardware
error has been detected. Contact M-B center.
• “INFO SERVICE NOT ACTIVATED“ - Info Services is
not activated. You must activate Tele Aid at the
Response center and select the optional Info Ser-
vices.
In this cases press the softkey “RTN“ to return to
Info Services display.
P82.85-6545-26
Info Service