fuse MERCEDES-BENZ S-Class 2008 W221 Comand Manual

Contents
Flat tire .............................................. 723
Preparing the vehicle ................... 723
Mounting the spare wheel............ 723
Batteries ............................................ 729
Disconnecting starter battery ...... 731
Removing starter battery ............. 732
Charging battery .......................... 732
Reinstalling starter battery........... 733
Reconnecting starter battery ....... 733
Jump starting ..................................... 734
Towing the vehicle ............................. 737
Towing with front wheels raised ... 738
Towing with all wheels
on the ground............................... 739
Installing towing eye bolt ............. 740
Fuses ................................................. 741
Fuse boxes in
engine compartment .................... 742
Fuse boxes in
passenger compartment .............. 743
Emergency engine shut-down ...... 744
Technical data.................................. 745
Parts service....................................... 746
Warranty coverage ............................. 747
Loss of Service and Warranty
Information Booklet ...................... 747
Identification labels ............................ 748
Layout of poly-V-belt drive .................. 750
S 450 4MATIC, S 550 and
S 550 4MATIC............................... 750
S 63 AMG ..................................... 750
S 600 and S 65 AMG .................... 750
Engine ................................................ 751
Rims and tires .................................... 754
Same size tires ............................. 755
Mixed size tires ............................. 757
Spare wheel .................................. 759
Electrical system ................................ 760
Main dimensions and weights ............ 762
Main dimensions........................... 762
Weights ......................................... 763Fuels, coolants, lubricants, etc. .......... 764
Capacities ..................................... 764
Engine oils .................................... 769
Engine oil additives ....................... 769
Air conditioning refrigerant ........... 769
Brake fluid .................................... 769
Premium unleaded gasoline.......... 770
Fuel requirements......................... 770
Gasoline additives......................... 771
Coolants ....................................... 771
Windshield washer system and
headlamp cleaning system ........... 774
Index................................................. 775

279 Control systems
COMAND automatic climate control
Adjusting air flow from air vents
The “Airflow” setting defines air distribu-
tion and air volume in automatic mode:

“Focused” (default setting, increased
air flow)


“Medium” (reduced air flow)


“Diffuse” (minimal air flow)

Select climate control settings
Cen-
tral climate control menu
“Airflow”.
A selection list appears.
The current setting is indicated by a
dotR.

Changing air flow: Slide qmr or
rotateymz.

Confirming selection: Press n.Operating rear climate control* from
the front
The “Rear)” function is used to oper-
ate the rear climate control via COMAND
and the buttons on the center console con-
trol unit (
page 510).
Switching on rear climate control oper-
ation from the front

Select climate control settings
Cen-
tral climate control menu.

Selecting “Rear)”: Slide qmr or
rotate ymz.

Confirming selection: Press n.
i
In automatic mode, this setting optimizes
the air flow when outside temperatures are high.
i
When the interior ambient temperature of
the vehicle is very hot and the automatic climate
control is cooling the interior, the setting for air
flow is temporarily overridden.


460 Controls in detailDriving systemsStopping
When DISTRONIC Plus detects that the ve-
hicle in front of you is stopping, the vehicle
brakes until it also stops.
Once DISTRONIC Plus has stopped your
vehicle and it is at a standstill, it remains
stationary; the brake pedal does not need
to be depressed.Setting the current speed

Accelerate or decelerate to the desired
speed.

Briefly lift the DISTRONIC Plus lever in
the direction of arrow1 or depress in
the direction of arrow2.
DISTRONIC Plus is activated and the
current speed is set.

Remove your foot from the accelerator
pedal.
Warning!
G
DISTRONIC Plus’s braking effect is canceled
and the vehicle can start to roll if

DISTRONIC Plus is switched off using
the DISTRONIC Plus lever


you accelerate


the system or the power supply is mal-
functioning, e.g. due to battery failure


the electrical components in the engine
compartment or the fuses have been
manipulated


the battery is disconnected
Warning!
G
Never get out of the vehicle while
DISTRONIC Plus is switched on!
DISTRONIC Plus must never be operated or
switched off by passengers or from outside
the vehicle.
DISTRONIC Plus is not a substitute for the
electronic parking brake and may not be
used for parking.
When you get out of the vehicle or switch off
the engine, deactivate DISTRONIC Plus and
secure the vehicle from rolling away by en-
gaging the electronic parking brake.
i
After a short while, your vehicle is secured in
place by the electronic parking brake so that the
operating brake can be relieved of load.
i
Depending on the following distance set us-
ing the distance setting switch on the
DISTRONIC Plus lever, your vehicle will stop ap-
proximately 13.1 ft away from the vehicle in
front of you.

617 Operation
Vehicle care
Engine cleaning
Prior to cleaning the engine compartment,
make sure to protect electrical compo-
nents and connectors from contact with
water and cleaning agents.
Corrosion protection, such as
MB Anticorrosion Wax, should be applied
to the engine compartment after every
engine cleaning. Before applying, all
control linkage bushings and joints should
be lubricated. The poly-V-belt and all pul-
leys should be protected from any wax.
Vehicle washing
In the winter, thoroughly remove all traces
of road salt as soon as possible.
When washing the vehicle underbody, do
not forget to clean the inner sides of the
wheels.Hand-wash
Do not use hot water or wash your vehicle
in direct sunlight.

Only use a mild car wash detergent,
such as Mercedes-Benz approved Car
Shampoo.

Thoroughly spray the vehicle with a dif-
fused jet of water.
Direct only a very weak spray towards
the ventilation intake.

Use plenty of water and rinse the
sponge and chamois frequently.

Rinse with clean water and thoroughly
dry with a chamois.
Do not allow cleaning agents to dry on
the finish.Automatic car wash
You can have your car washed in an auto-
matic car wash from the start. Automatic
car washes without brushes are prefera-
ble.

To protect the filter system, switch the
automatic climate control to air recir-
culation mode (
page 506).
If the vehicle is very dirty, prewash it be-
fore running it through the automatic car
wash.
i
Vehicles with KEYLESS-GO*:
If a door handle is hit by a strong jet of water, and
a SmartKey with KEYLESS-GO* is in close prox-
imity, i.e. within approximately 3 ft (approxi-
mately 1 m), the vehicle could be inadvertently
locked or unlocked.
!
Do not use scouring agents on these parts.
Never apply strong force and only use a soft,
non-scratching cloth when cleaning the vehicle.
Do not attempt to wipe the surface with a dry
cloth or sponge.
Otherwise you may scratch or damage the paint.
!
Do not clean your vehicle in an automatic
touchless car wash which uses caustic spray.
Otherwise the caustic spray will damage the
paint or ornamental moldings.
!
Make sure that the windshield wiper switch
is set to0 (
page 408). Otherwise, e.g. the rain
sensor could activate and cause the wipers to
move unintentionally. This may lead to vehicle
damage.
Due to the width of the vehicle, fold in exterior
rear view mirrors prior to running the vehicle
through an automatic car wash to prevent dam-
age to the mirrors.

627 Practical hints
What to do if …?
Where will I find ...?
Unlocking/locking in an emergency
Resetting activated head restraints
Replacing SmartKey batteries
Replacing bulbs
Replacing wiper blades
Flat tire
Batteries
Jump starting
Towing the vehicle
Fuses

705 Practical hints
Where will I find ...?
Where will I find ...?
First aid kit
The first aid kit is located in the storage
compartment under the front passenger
seat.
1Tab
2Cover
Pull tab1 upward.

Fold the covering forward in the direc-
tion of arrow.

Remove the first aid kit.
Vehicle jack, vehicle tool kit, luggage
bowl, Minispare wheel
The vehicle jack, Minispare wheel, the ve-
hicle tools, and the luggage bowl are
stored in the compartment underneath the
trunk floor.
Lift up trunk floor cover and engage
trunk floor handle in upper edge of
trunk.
You can now remove the tools and ac-
cessories.The vehicle tool kit includes:


Towing eye bolt


Wheel wrench with socket wrench


Alignment bolt


Pair of gloves


Fuse chart for the main fuse box


Collapsible wheel chock


Release tool for mechanically releasing
the electronic parking brake
The spare wheel bolts are fixed at the
Minispare wheel.
!
Always keep the storage compartment un-
der the front passenger seat closed while the ve-
hicle is in motion.
i
Check expiration dates and contents for
completeness at least once a year and replace
missing/expired items.
!
To prevent damage, always disengage trunk
floor handle from trunk lid and lower trunk floor
before closing the trunk.

741 Practical hintsFuses
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the component(s) and
systems secured by that fuse will stop op-
erating.
If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
A fuse chart explains the fuse allocation
and fuse amperages. It is located in the
trunk with the vehicle tool kit
(
page 705).The electrical fuses are located in different
fuse boxes:


in the dashboard on the passenger side
(page 743)


in the dashboard on the driver’s side
(page 743)


behind the rear center armrest
(page 744)


on the driver’s side of the engine com-
partment (
page 742)


on the passenger side of the engine
compartment (
page 743)
Warning!
G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.!
Switch off the vehicle’s internal electrical
functions (
page 732) when you are working on
the fuses.
i
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to advise
you on this subject.
i
In case of a blown fuse contact Roadside As-
sistance or an authorized Mercedes-Benz
Center.

742 Practical hintsFusesBefore replacing fuses:
Engage the electronic parking brake
(page 422).

Make sure the automatic transmission
is set to park positionP (
page 426).
The gear position indicator in the multi-
function display should be on park po-
sition P.

Turn off all electrical consumers.

Turn off the engine (
page 424).

Switch off the vehicle’s internal electri-
cal functions (
page 732).
Fuse boxes in engine compartment
Open the hood (
page 573).
Box on the driver’s side
Example illustration from S 55014 screws
2Cover
3JumperOpening

Take the crank from the Operator’s
Manual pouch.

Loosen screws1 with crank.

Remove jumper3.

Remove cover2.
Closing

Attach cover2.

Attach jumper3.

Tighten screws1 with crank.
!
The cover must fit properly, as otherwise
moisture or dirt may impair the functionality of
the fuses.

743 Practical hintsFuses
Box on the front passenger sideExample illustration from S 5501Retaining lugs
2Cover
Opening
Press retaining lugs1.

Remove cover2.
Closing

Attach cover2.

Press cover2 down manually.
Fuse boxes in passenger compartment
Fuse boxes in dashboard
1Cover1Cover
Opening

Open the respective door.

Using your hands, pull cover1 in the
direction of the arrow and remove.
Closing

Hook cover1 into the opening at the
front.

Press cover1 back on until it
engages.
!
The cover must fit properly, as otherwise
moisture or dirt may impair the functionality of
the fuses.
!
Do not use sharp objects such as a screw
driver to open the fuse box cover in the dash-
board, as this could damage it.

744 Practical hintsFusesFuse box in the rear passenger
compartment
1CoverOpening

Swing down center armrest.

Open cover behind center armrest.

Pull cover1 forward in direction of ar-
row.
Closing

Press cover1 backward and engage.
Emergency engine shut-down
If the engine cannot be turned off as de-
scribed in the “Turning off the engine” sec-
tion (
page 424), you may use the
following emergency procedure.

Take the fuse chart and the fuse extrac-
tor from the vehicle tool kit
(page 705).

Find row “Emergency engine
shut-down” in the fuse chart table to
identify the fuses that have to removed
as well as their locations.

Remove the respective fuses.
!
Make sure that the seal in the cover is not
damaged during opening or closing.