buttons MERCEDES-BENZ S450 HYBRID 2010 W221 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2010, Model line: S450 HYBRID, Model: MERCEDES-BENZ S450 HYBRID 2010 W221Pages: 40, PDF Size: 1.09 MB
Page 16 of 40
Instrument clusterFunctionPage:÷ ABS/ESC warning
lamp
10,
24
;$ Brake warning lamp,
USA only24
J Brake warning lamp,
Canada only24
=é Recuperative Brake
System (RBS) warning lamp24
?Green or yellow READY
indicator lamp for the
HYBRID system16
AMultifunction display
with:
Charging level high-voltage
battery15
Control system and COMAND
iFor information on the instrument cluster
control system and COMAND operation,
refer to the Operator’s Manual.
The current operating mode of the HYBRID
system can be displayed in the multifunction
display and in the COMAND.
The COMAND can also display a chart of the
fuel consumption and the electric power that
has been generated (Y page 16).
Selecting submenu in the
multifunction display
Use the buttons on the multifunction steering
wheel.
XPress button = or ; to select the
Trip menu.
XPress button 9 or : to select the
HYBRID menu.
Selecting submenu in the COMAND
display
XSelect Vehicle Q Hybrid Q Energy.14Controls in detail221_ZA; 1; 21, en-USd2ureepe,Version: 2.11.8.12009-05-13T13:56:31+02:00 - Seite 14
Page 22 of 40
Vehicle status messages in the
multifunction display
Notes
Warning and malfunction messages appear in
the multifunction display located in the
instrument cluster. Certain warning and
malfunction messages are accompanied by
an audible signal.
High-priority messages are shown in red in
the multifunction display. Messages of lower
priority are also shown in yellow or white.
Address these messages accordingly and
follow the additional instruction given in this
Supplemental Operating Instructions Booklet
and in the Operator’s Manual.
GWarning!
All categories of messages contain important
information which should be taken note of
and, where a malfunction is indicated,
addressed as soon as possible at an
authorized Mercedes-Benz Center.
Failure to repair the condition noted may
cause damage not covered by the Mercedes-
Benz Limited Warranty, or result in property
damage or personal injury.
GWarning!
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see
information about your driving conditions,
such as
R speed
R outside temperature
Rwarning/indicator lamps
R malfunction/warning messages
R failure of any systems
Driving characteristics may be impaired.
If you must continue to drive, do so with added
caution. Contact an authorized Mercedes-
Benz Center as soon as possible.
On the pages that follow, you will find a
compilation of the warning and malfunction
messages specific to the HYBRID system. For
all other warning and malfunction messages,
refer to the Operator’s Manual.
Clearing display messages
Some display messages with low priority are
cleared from the multifunction display after
several seconds. Other display messages
remain displayed in the multifunction display
until you clear them manually.
Certain messages of high priority cannot be
cleared from the multifunction display. Such
messages will appear in the multifunction
display until the causes for these messages
have been repaired.
Use the buttons on the multifunction steering
wheel.
XClear the messages using button a or
% .
Certain messages are stored in the vehicle
status message memory. For information
on calling up vehicle malfunction, warning
and system status messages stored in
memory, refer to the Operator’s Manual.20Practical hints221_ZA; 1; 21, en-USd2ureepe,Version: 2.11.8.12009-05-13T13:56:31+02:00 - Seite 20