stop start MERCEDES-BENZ SLK55AMG 2006 R171 User Guide

377 Practical hints
What to do if …
Display symbol
Display message
Possible cause/consequence
Possible solution
Ï
Coolant
Stop, engine off
The coolant is too hot.

Stop the vehicle and turn off the engine.

Only start the engine again after the mes-
sage disappears. You could otherwise dam-
age the engine.
/
Coolant
Check level
The coolant level is too low.

Add coolant (
page 313).

If you have to add coolant frequently, have
the cooling system checked by an autho-
rized Mercedes-Benz Center.
Warning!
G
Driving when your engine is badly overheat-
ed can cause some fluids which may have
leaked into the engine compartment to
catch fire. You could be seriously burned.
Steam from an overheated engine can cause
serious burns and can occur just by opening
the hood. Stay away from the engine if you
see or hear steam coming from it. Turn off
the engine, get out of the vehicle and do not
stand near the vehicle until the engine has
cooled down.
The engine should not be operated with the
coolant temperature above 248°F (120°C).
Doing so may cause serious engine damage
which is not covered by the Mercedes-Benz
Limited Warranty.Warning!
G
Do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts. You can be seriously burned.
!Do not ignore the low engine coolant
level warning. Extended driving with
this message and symbol displayed
may cause serious engine damage not
covered by the Mercedes-Benz Limited
Warranty.
Do not drive without sufficient amount
of coolant in the cooling system. The
engine will overheat, causing major en-
gine damage.

386 Practical hintsWhat to do if ….
Turn off
lights
You have forgotten to switch off the
headlamps when exiting the vehicle
and no SmartKey is in the starter
switch.

Switch off the headlamps.
Turn signal in
mirror, left
T h e l e f t t u r n s i g n a l i n t h e s i d e m i r r o r
is malfunctioning. This message will
only appear if a critical number of
LEDs have stopped working.

Visit an authorized Mercedes-Benz Center
as soon as possible.
Turn signal in
mirror, right
The right turn signal in the side mir-
ror is malfunctioning. This message
will only appear if a critical number
of LEDs have stopped working.

Visit an authorized Mercedes-Benz Center
as soon as possible.
Turn signal
,
front left
The left front turn signal is malfunc-
tioning.

Replace the bulb as soon as possible.
Turn signal
,
front right
The right front turn signal is mal-
functioning.

Replace the bulb as soon as possible.
Rear left turn signal
Back-up lamp on
The left rear turn signal is malfunc-
tioning. A backup bulb has been
brought into use.

Replace the bulb as soon as possible.
Rear right turn signal
Back-up lamp on
The right rear turn signal is malfunc-
tioning. A backup bulb has been
brought into use.

Replace the bulb as soon as possible.
Display symbol
Display message
Possible cause/consequence
Possible solution

394 Practical hintsUnlocking/locking in an emergencyUnlocking the vehicle
If you cannot unlock the vehicle with the
SmartKey, open the driver’s door and the
trunk using the mechanical key. Removing the mechanical key
1Mechanical key locking tab
2Mechanical key

Move locking tab1 direction of arrow.

Slide mechanical key2 out of the
housing.Unlocking the driver’s door
1Unlocking

Insert the mechanical key into the
driver’s door lock until it stops.

Turn the mechanical key counterclock-
wise to position1.
The driver’s door is unlocked.
iUnlocking and opening the driver’s
door and/or the trunk with the me-
chanical key will trigger the anti-theft
alarm system.
To cancel the alarm, do one of the
following:

Press buttonŒor‹on the
SmartKey.


Insert the SmartKey in the starter
switch.

428 Practical hintsTowing the vehicleInstalling towing eye bolt
The towing eye bolt is supplied with the ve-
hicle tool kit, located in the compartment
underneath the trunk floor (
page 388).
The towing eyes are located on the passen-
ger side in the front and rear bumper.

Take vehicle tool kit out of trunk
(page 388).Front cover
1Cover in front bumper
Removing

Press mark on cover1.

Cover1 springs open at the top right
corner.

Pull at the protruding part of cover1
and fold cover down to reveal the
threaded hole for the towing eye bolt.
Do not disconnect cover1 from its
check strap.

Screw towing eye bolt in to its end stop
and tighten with lug wrench.Installing

Unscrew the towing eye bolt using the
lug wrench.

To reinstall cover1, tilt the marked
lower left corner towards the opening.

Maintaining its tilted position, insert
cover1 by applying the latches at the
top left and lower right corner into the
opening.

To close cover1, press on the diago-
nal opposite side of the marked corner
until it fully engages.
iThe gear selector lever* will remain
locked in positionP (vehicles with au-
tomatic transmission*) and the
SmartKey will not turn in the starter
switch if the battery is disconnected or
discharged. See notes on the battery
(page 421) or on jump starting
(page 424).
Vehicles with automatic transmission*:
For information on manual unlocking of
gear selector lever, see (
page 396).
iMake sure the cover’s check strap
does not get caught when closing.