oil level MERCEDES-BENZ SPRINTER 2015 MY15 Maintenance Booklet

and/or anticorrosion/antifreeze products
other than those approved for your vehicle
are being used. You can find coolant
instructions under the "Coolant" section of the vehicle Operator's Manual. Contact an
authorized Sprinter Dealer for a list of anti-
corrosion/antifreeze products that are
approved for your vehicle. Wear parts
The maintenance computer recommends the
inspection of certain wear parts, however, it
cannot judge the condition of these wear
parts. Only qualified aftersales technicians
can determine if a wear part should be
replaced. Regular checks
In addition to the maintenance service, you
should also perform regular checks on the
following (e.g. weekly, when refueling, or
before any long journey):
R Oil level – Depending on the vehicle equip-
ment, check the oil level of the engine using either the oil dipstick or using the control
system via the multifunction steering
wheel/multifunction display. Refer to the
Operator's Manual for more information on
measuring the engine oil level.
R Coolant level – The correct procedure for
checking the coolant level is described in
the Operator's Manual.
R Brake fluid level – If the brake fluid has to
be refilled, visit an authorized Sprinter
Dealer and have the cause determined, e.g. leakage or worn brake pads.
R Windshield washer system – If the
washer fluid level falls below 1/3 full, the
warning lamp for the washer fluid level
lights up. Add washer fluid mixed with an
approved windshield washer concentrate,
test function and check wiper blades. R
Lighting system
R Tire condition and tire pressure – Check
at least once a month. Refer to the "Tires
and Wheels" section in the Operator's Man-
ual for guidelines and the correct proce-
dure for checking the tire condition and tire
pressure. Notes on the warranty
An extensive and well-equipped network of
authorized Sprinter Dealers is available to
carry out maintenance work. Your authorized
Sprinter Dealer can ensure that your vehicle
is thoroughly serviced and repaired by pro-
fessionals.
Please see the Service and Warranty Infor-
mation Booklet for detailed information on
warranty terms and coverage.
Please follow the maintenance instruc-
tions in this Maintenance Booklet, even if you allow a third party to use the vehicle
and entrust them with care of the vehicle. Only in this way will you be able to ensure
that your warranty rights are not affected.
Service, replacement, or repair of the
emission control devices and systems
can be performed by any automotive
repair establishment or individual using
certified parts.
We strongly recommend that any mainte-
nance work on your vehicle is carried out by your authorized Sprinter Dealer which
is fully equipped to perform this service.
Please note that special instructions and spe- cial measuring devices are required for serv-
icing the engines in order to comply with legal requirements concerning exhaust emissions.
Modifying or tampering with emissions com-
ponents is not permissible. Your authorized
Sprinter Dealer is familiar with the relevant
regulations. 6
IntroductionMaintenance Booklet

!
Only use DEF according to ISO 22241. Do
not add special additives to DEF or dilute it
with water. This can damage the BlueEFFI-
CIENCY ®
exhaust gas aftertreatment. Description of maintenance work for
the exhaust system
The composition of exhaust emissions is
influenced not only by the exhaust gas after-
treatment system, but also by various engine
parts and their settings.
Maintenance of the exhaust system must
therefore include these engine parts. Some
maintenance jobs are actually only tests.
They are important, however, because they
allow early detection of discrepancies which
can later lead to increased exhaust emis-
sions. It is generally less costly to adjust devi- ations of this sort immediately than to wait
until they incur high repair costs. The main-
tenance intervals have been determined so
that the vehicle, under normal operating con- ditions, should operate properly between
maintenance services. Changing the engine oil and filter
Change engine oil and replace oil filters after every 20,000 miles. If oil consumption should
increase, determine the cause and take nec-
essary corrective steps. Do not reset the ser-
vice interval display if the oil level is filled up
or the oil is changed at times other than the
recommended intervals. Replacing the air filter
Under normal dust conditions, the air filter
should be replaced every 60,000 miles. Clean
the air filter cap and housing before removing the air filter. Replacing the fuel filter
Replace the fuel filter every 20,000 miles. Checking the diesel particle filter
The level of the diesel particle filter must be
checked for the first time at 100,000 miles.
If the saturation level is still below the thresh- old value at 100,000 miles, the saturation
level of the diesel particle filter must be
checked again at each subsequent oil service
plus/maintenance service.
If the level of the diesel particle filter is above the limit value, the diesel particle filter should
be replaced.
Once the new diesel particle filter has been
installed, the checking cycle starts again after
100,000 miles. Checking and adding DEF
Check and refill DEF every 20,000 miles. Maintenance service
Vehicle maintenance work (including
exhaust system maintenance)
i The maintenance services should be car-
ried out at the specified mileage or after the specified number of years (whichever
comes first).
You can find detailed descriptions of the
maintenance services here (Y page 9).
You can find a description of the scope of
maintenance for the exhaust system here
(Y page 8). 8
Maintenance serviceMaintenance Booklet

Oil service
plus Maintenance
service Check fluid level and correct
If there is fluid loss, determine the cause and remedy
it (separate invoice) Engine cooling system: corrosion inhibitor/anti-
freeze
^
Hydraulic brake system
^ ^
Power steering
^
Auxiliary battery in the engine compartment
^
Windshield washer system
^
DEF reservoir
^ ^
Engine
Replace fuel filter with water separator (after 1 year at
the latest, observe date of installation) ^ ^
Check poly-V-belt in the visible area for signs of wear
and damage ^ ^
Chassis and body
Replace the dust filter for the heating/ventilation or
the activate charcoal/combination filter for the air-
conditioning system (after 2 years at the latest,
observe the installation date) ^
Replace the dust filter for rear compartment air con-
ditioning (after 2 years at the latest, observe instal-
lation date) ^
Test trailer hitch: check function, play and attach-
ment ^
Sliding door: check water drain bores
^
Road wheels, brakes
Check and correct tire pressures, including spare
wheel ^ ^
Tire sealant: check expiration date (renew if neces-
sary; separate invoice)
^10
Maintenance serviceMaintenance Booklet

Oil service
plus Maintenance
service Check thickness of the brake pads/linings and con-
dition of the brake discs. Vehicles with twin tires and
super-wide tires: rear wheels must be removed and
remounted (separate invoice) ^
Parking brake: check lever travel
^
Service indicator
Reset the maintenance computer
^ ^
Additional work
Once as part of the first service A (Z)
Retighten nuts and bolts
Rear axle: retighten u-bolts
Once as part of the first Service B, subsequently every 80000 miles (Z1)
Automatic transmission: oil and filter change
Every 2 years (Z2)
Hydraulic brake system: renew brake fluid
Every 3rd engine oil change (Z3)
Replace air filter element (at least every 4 years, observe installation date!)
Every fourth engine oil change (Z4)
Replace the poly-V-belt
For the first time at 100000 miles (Za)
Check saturation level of the diesel particle filter (observe installation date!)
Every ninth engine oil change/every 10 years (Z9)
Rear axle: oil change
Every ninth engine oil change/every 15 years (Z9)
Renew coolant (observe coolant mixture ratio) Maintenance service
11Maintenance Booklet