ECO mode Mercury Mystique 1996 s User Guide

Servicing Your Mystique
207
*
[SV11000(ALL)05/95]
Gasoline and gasoline blends may contain small amounts of
carcinogens, such as benzene. Long-term exposure to unleaded
gasoline vapors has caused cancer in laboratory animals.
*
[SV11100(ALL)05/95]
If you are taking the medication ªAntabuseº or other forms of
disulfiram for the treatment of alcoholism, vapor or skin contact
with a gasoline-methanol blend may cause the same kind of
adverse reaction as drinking an alcoholic beverage. In sensitive
individuals, serious personal injury or sickness could result.
Consult a physician promptly if you experience an adverse
reaction.
%*
[SV11300(ALL)05/95]
Running Out of Fuel
*
[SV11325(ALL)05/95]
NOTE: Avoid running out of fuel because this situation may
have an adverse effect on modern powertrain
components.
*
[SV11550(ALL)05/95]
You may need to crank the engine several times before the fuel
system starts to pump fuel from the tank to the engine.
*
[SV11580(ALL)01/95]
RWARNING
Never pour fuel in the throttle body or attempt to start
the engine with the air cleaner removed. Doing so could
result in fire and personal injury.
%*
[SV11600(ALL)05/95]
Fuel Economy
*
[SV11700(ALL)05/95]
Fuel economy is an estimate of the efficiency of your vehicle
and can be calculated as Miles Per Gallon (MPG) or Liters Per
100 Kilometers (L/100K).
*
[SV11725(ALL)05/95]
Do not calculate fuel economy during your vehicle's break-in
period. This would not be an accurate estimate of how much
fuel your vehicle will normally use.
File:cdsvz.ex
Update:Fri Feb 23 11:01:54 1996

250
%*
[SV42425(ALL)06/95]
Readiness for Inspection/Maintenance Testing
*
[SV42450(ALL)06/95]
In some localities it may become a legal requirement to pass an
Inspection/Maintenance (I/M) test of the On-Board Diagnostic
(OBD) II system. If the vehicle's powertrain system or its battery
has just been serviced, the OBD II system is reset to a not ready
for I/M testing condition. To prepare for I/M testing, the law
specifies a ªneed for additional mixed city and highway driving
to complete the checkº of the OBD II system. As soon as all of
the OBD II system checks are successfully completed, the OBD
II system is set to the ready condition. The amount of driving
required to reach the ready condition varies with individual
driving patterns. To complete this requirement in the minimum
amount of time, refer to the OBD II Drive Cycle defined below.
If the vehicle owner cannot or does not want to do the
additional driving required by law, a service center can perform
this drive cycle as it would any other type of repair work.
*
[SV42475(ALL)06/95]
OBD II Drive Cycle
*
[SV42501(ALL)06/95]
The following steps must be run in the order shown. If any
steps are interrupted, repeat the preceding step. Any safe
driving mode is acceptable between steps.
*
[SV42550(ALL)06/95]
Always drive vehicle in safe manner according to traffic
conditions and obey all traffic laws.
*
[SV42560(ALL)05/95]
The engine must be warmed up and at operating temperature
before proceeding with the drive modes of the following OBD II
Drive Cycle.
*
[SV42575(ALL)05/95]1.
Start the engine. Drive or idle (in neutral) the vehicle for
4 minutes.
[SV42601(ALL)05/95]2.
Idle the vehicle in Drive (Neutral for manual transaxle) for
40 seconds.
*
[SV42610(ALL)06/95]3.
Accelerate the vehicle to 45 mph (70 km/h) at 1/4 to 1/2
throttle for 10 seconds.
File:cdsvz.ex
Update:Fri Feb 23 11:01:54 1996

Servicing Your Mystique
251
*
[SV42620(ALL)06/95]4.
Drive the vehicle with a steady throttle at 45 mph
(70 km/h) for 30 seconds.
*
[SV42631(ALL)05/95]5.
Idle the vehicle in Drive (Neutral for manual transmissions)
for 40 seconds.
*
[SV42635(ALL)06/95]6.
Continue to drive the vehicle in city traffic at speeds
between 25 and 40 mph (40-60 km/h) for 15 minutes.
During the 15 minute drive cycle the following modes must
be achieved:
*
[SV42641(ALL)06/95]
a. at least 5 stop and idle modes at 10 seconds each
*
[SV42645(ALL)06/95]
b. acceleration from idles at 1/4 to 1/2 throttle position, and
*
[SV42650(ALL)06/95]
c. choose 3 different speeds to do 1.5 minute steady state
throttle drives.
*
[SV42655(ALL)06/95]7.
Accelerate the vehicle up to between 45 and 60 mph
(70-100 km/h). This should take approximately 5 minutes.
*
[SV42661(ALL)06/95]8.
Drive vehicle and hold the throttle steady at the selected
speed between 45 and 60 mph (70-100 km/h) for
approximately 5 minutes.
*
[SV42665(ALL)06/95]9.
Drive the vehicle for 5 minutes at varying speeds between
45 and 60 mph (70-100 km/h).
*
[SV42670(ALL)06/95]10.
Bring the vehicle back to idle. Idle in Drive for 40 seconds.
*
[SV42725(ALL)06/95]11.
OBD II drive cycle has been completed. Vehicle can be
turned off when convenient.
File:cdsvz.ex
Update:Fri Feb 23 11:01:54 1996