tow Mercury Sable 1996 s User Guide

81 [LG07800(ALL)02/95]
one inch art:0000282-B
Service engine soon light
[LG07825(ALL)03/95]
This light comes on when you turn the ignition
key to ON, but should turn off when the engine
starts. If the light does not come on when you
turn the ignition to ON or if it comes on and
stays on when you are driving, have your
vehicle serviced as soon as possible. This
indicates a possible problem with one of the
vehicle's emission control systems. You do not
need to have your vehicle towed in.
[LG07851(ALL)04/95]
If the light turns on and off at one (1) second
intervals while you are driving the vehicle, it
means that the engine is misfiring. If this
condition persists, damage could occur to the
engine or catalytic converter. Avoid heavy
acceleration and have your vehicle serviced at
the first opportunity. You do not need to have
your vehicle towed in.
*
[LG07875(ALL)03/95]
If the light turns on and off on rare occasions
while you are driving, it means that a
malfunction occurred and the condition corrected
itself.
[LG07900(ALL)03/95]
An example of a condition which corrects itself
occurs when an engine running out of fuel
begins to misfire. In this case, the Service Engine
Soon Warning Light may turn on and will then
set a Diagnostic Trouble Code indicating that the
engine was misfiring while the last of the fuel
was being consumed. After refueling, the Service
Engine Soon Warning Light will turn off after
the vehicle has completed three consecutive
File:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

91
Instrument Panel Controls
%*
[IP00400(ALL)04/95]
The main controls for the climate control system,
clock, and radio are in the oval Integrated
Control Panel on the instrument panel.
[IP00410(ALL)04/95]
The controls for the lights and climate control air
registers are also on the instrument panel.
*
[IP00420(ALL)03/95]
Clean the instrument panel lens and woodtone
trim with a soft cloth and a glass cleaner. Do
not use paper towel or any abrasive cleaner to
clean either the lens or the woodtone trim as
these may cause scratches.
%*
[IP00430(ALL)04/95]
NOTE: Any cleaner or polish that increases the
gloss (shine) of the upper part of the
instrument panel should be avoided.
The dull finish in this area is to help
protect the driver from undesirable
windshield reflection.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

107 [IP25250(ALL)02/89]
To change your headlamps from low to high
beam, push the turn signal lever away from you.
To change them back to low beam, pull the
lever toward you.
*
[IP25300(ALL)03/93]
For more information about how the high beam
headlamps work, seeSteering column controlsin
the Index.
%*
[IP25605(ALL)01/95]
Daytime Running Light System
[IP25610(ALL)03/95]
(Canadian and fleet vehicles only)
*
[IP25615(ALL)03/95]
The Daytime Running Light (DRL) system is
designed to turn the high beam headlamps on,
with a reduced light output and without
illuminating the high beam indicator lamp in the
instrument panel. The DRL system operates
when all of the following conditions are met:
*
[IP25620(ALL)03/95]
q
The vehicle is ªrunning.º
*
[IP25625(ALL)01/95]
q
The vehicle has a fully released parking
brake.
*
[IP25630(ALL)03/95]
q
The headlamp system is in the OFF position.
*
[IP25635(ALL)01/95]
NOTE: If you have a vehicle with an
automatic lighting system, the DRL
system is active until the automatic
system turns on the headlamps.
*
[IP25636(ALL)10/94]
NOTE: The high beam indicator will not turn
on in the flash-to-pass mode during
nighttime driving.
[IP25637(ALL)01/95]
You may notice that the lights flicker when the
vehicle is turned on or off. This is a normal
condition.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

108
*
[IP25638(ALL)01/95]
RWARNING
When the Daytime Running Light
(DRL) system is active the tail lamps,
parking lamps and side markers on
your vehicle will not be illuminated.
It is necessary to turn on your
headlamps at dusk. Failure to do so
may result in a collision, possibly
injuring yourself and others.
%*
[IP25640(ALL)04/95]
Cleaning the Exterior Lamps
*
[IP25650(ALL)04/95]
Do not use dry paper towel, chemical solvents
or abrasive cleaners to clean the lamps, as these
may cause scratches or crack the lamps.
%*
[IP26600(ALL)02/95]
Setting the Autolamp Delay System
(If equipped)
*
[IP26700(ALL)02/95]
The autolamp sets the headlamps to turn on and
off automatically. You can use the autolamp to:
*
[IP26800(ALL)01/95]
q
turn on the lamps automatically at night
*
[IP26900(ALL)01/95]
q
turn off the lamps automatically during
daylight
[IP27000(ALL)11/94]
q
keep the lamps on for up to three minutes
after you turn the ignition to the OFF
position.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

110
*
[IP28500(ALL)01/95]
You can set the autolamp so the headlamps stay
on for up to three minutes after you turn your
vehicle off.
*
[IP28600(ALL)01/95]
To keep the lamps on after you leave your
vehicle:
*
[IP28650(ALL)01/95]
q
Turn the thumbwheel as far into the MAX
range as you want.
*
[IP28750(ALL)01/95]
q
The further you move the thumbwheel into
the DELAY area (toward the MAX position),
the longer the lamps will stay on after you
leave your vehicle. Similarly, if you move the
thumbwheel only slightly into the DELAY
area, your lamps will stay on only for a
moment after you turn your vehicle off.
%*
[IP29800(ALL)01/95]
Lighting Up the Interior and Instrument
Panel
*
[IP30000(ALL)08/95]
With the light knob in the parking lamps or the
headlamps position, you can brighten or dim the
lights in the instrument panel. To do this, use
the thumbwheel to the left of the steering wheel.
This wheel also turns on the interior lights with
the light switch on or off.
[IP30300(ALL)02/95]
one third page art:0000692-C
The thumbwheel that controls the light on the instrument
panel
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

116
*
[SC03200(ALL)03/95]
To turn off the high beams, pull the lever
toward you until it latches. The high beam
indicator light turns off.
%*
[SC03300(ALL)03/95]
Flashing the Lights
*
[SC03400(ALL)08/95]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is on or off.
[SC03450(ALL)04/95]
one third page art:0001411-B
The turn signal lever
%*
[SC03500(ALL)03/95]
Windshield Wipers and Washer
*
[SC03600(ALL)03/95]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
[SC03900(ALL)05/94]
Turn the knob on the end of the turn signal
lever away from you to activate the wipers. The
first seven detents are interval wipe positions,
the eighth detent is the LO position, and the
ninth detent is the HI position.
*
[SC04000(ALL)01/95]
To turn the wipers off, turn the knob toward
you to the OFF position.
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

117 %
*
[SC04100(ALL)03/95]
Variable Interval Wipers
*
[SC04300(ALL)01/95]
In addition to two speed wipers, your vehicle
has wipers that you can set to operate at
varying intervals. For example, you can set the
interval so they wipe less often when it drizzles
or more often in heavier rain.
[SC04500(ALL)04/95]
one third page art:0001412-B
The variable interval wiper on the turn signal lever
*
[SC04925(ALL)03/94]
To set the interval wipers, turn the knob at the
end of the turn signal lever toward or away
from you until the wipers are going at the
desired interval.
*
[SC04950(ALL)03/95]
Windshield Washer
[SC05000(ALL)05/94]
To clean the windshield, push in the end of the
wiper switch knob. For a constant spray, keep
the knob pushed in. After you release the knob,
the wipers operate for two to three cycles before
turning off (if the wipers were off) or returning
to HI, LO, or the interval setting selected.
[SC05050(ALL)04/95]
For information about the rear washer on the
wagon, seeWindshield washer fluid and wipersin
the Index.
*
[SC05100(ALL)03/95]
If the washer does not work, check the washer
fluid level and fill it if it is low. See theServicing
Your Sablechapter. If there is enough fluid,
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

120
%*
[SC06210(ALL)01/95]
Tilt Steering
*
[SC06400(ALL)04/95]
RWARNING
Never adjust the steering
column/wheel when the vehicle is
moving. You could lose control of the
vehicle and injure someone.
[SC06650(ALL)11/94]
one third page art:0000658-B
The lever to tilt the steering wheel
*
[SC06800(ALL)04/95]
To change the position of the steering
column/wheel, pull the release lever on the
column toward you. Tip the steering wheel to
the desired position. Release the lever to lock the
steering wheel in place.
%
*
[SC07400(ALL)03/91]
Speed Control (If equipped)
*
[SC07500(ALL)03/95]
If your vehicle has speed control, you can
automatically maintain a constant speed at or
above 30 mph (50 km/h).
*
[SC07550(ALL)03/95]
NOTE: Do not shift to N (Neutral) when using
the speed control. This will cause the
engine to overspeed.
*
[SC07600(ALL)04/95]
Use of radio transmitting equipment that is not
Federal Communications Commission (FCC)
approved may cause the speed control to
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

127 [FV04010(ALL)04/95]
Central Locking
[FV04020(ALL)04/95]
When you are unlocking the driver or front
passenger door with the key, turn it once
toward the front of the vehicle to unlock that
door only. Turn the key a second time to unlock
all doors. Turn the key once toward the rear of
the vehicle to lock all doors.
[FV04050(ALL)04/95]
Lock Disable
[FV04075(ALL)03/95]
The lock disable feature helps prevent you from
locking the keys in your vehicle. With the key in
the ignition (in any switch position) and the
driver's door open, the driver's door cannot be
locked using the front door power lock switch.
[FV04100(ALL)02/95]
Your vehicle can still be locked, while the key is
in the ignition, by manually pressing down the
lock button.
[FV04125(ALL)02/95]
Power liftgate lock Ð wagon (If equipped)
[FV04150(ALL)02/95]
The power liftgate lock is on the right inside
trim panel in the cargo area. When this lock is
pressed, all doors and the liftgate lock.
[FV04175(ALL)02/95]
one inch art:0001407-A
The power liftgate lock
File:fcfvs.ex
Update:Wed Dec 20 09:39:11 1995

136
*
[FV08400(ALL)04/95]
The remote entry system may not arm and
disarm non-factory installed anti-theft systems.
%*
[FV08451(ALL)02/95]
Replacing the batteries
*
[FV08500(ALL)02/95]
The remote entry transmitter is powered by two
coin type three-volt lithium 2016
batteries (included) that should last for several
years of normal use. If you notice a significant
decrease in operating range, the batteries should
be replaced. Replacement batteries can be
purchased at most pharmacies, watch stores or
at your Ford or Lincoln-Mercury dealer.
*
[FV08551(ALL)02/95]
NOTE: The operating range of the remote
entry system can also be affected by
weather conditions (such as very cold
temperatures) or structures around the
vehicle (buildings, other vehicles, radio
and TV towers, etc.). Typical operating
range will allow you to be up to 33
feet (10 meters) away from your
vehicle.
*
[FV08600(ALL)02/95]
The transmitter can be snapped apart to replace
the batteries by twisting a thin coin between the
two halves of the transmitter. DO NOT TAKE
THE FRONT PART OF THE TRANSMITTER
APART. When installing the new batteries, be
sure to place the positive (+) side down as
marked. Snap the two halves back together.
[FV08651(ALL)02/95]
quarter page art:0020790-A
Replacing the batteries
File:fcfvs.ex
Update:Wed Dec 20 09:39:11 1995