wheel Mercury Sable 1996 s User Guide

109 [IP27100(ALL)02/95]
one third page art:0000693-C
The autolamp system on the left side of the instrument
panel
*
[IP27400(ALL)01/95]
To set the autolamp:
*
[IP27450(ALL)08/95]
1. Make sure the headlamp knob is in the OFF
position. If the switch for the headlamps is
ON, you cancel the autolamp.
*
[IP27550(ALL)01/95]
2. Turn the ignition key to ON or start your
vehicle.
*
[IP27650(ALL)01/95]
3. Find the autolamp thumbwheel to the left of
the steering wheel on the instrument panel.
[IP27750(ALL)02/95]
4. Turn the autolamp thumbwheel past the stop
to the beginning of the MAX position. The
indicator light will come on.
*
[IP27850(ALL)01/95]
5. The autolamp automatically turns the lamps
on and off for you.
[IP27950(ALL)08/95]
Do not put any articles on top of the photocell
that is located in the top right corner of the
instrument panel. This photocell controls the
autolamp. If you cover it, the photocell reacts as
if it is nighttime, and the lamps turn on.
*
[IP28050(ALL)01/95]
To turn the autolamp off, move the thumbwheel
back to OFF.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

110
*
[IP28500(ALL)01/95]
You can set the autolamp so the headlamps stay
on for up to three minutes after you turn your
vehicle off.
*
[IP28600(ALL)01/95]
To keep the lamps on after you leave your
vehicle:
*
[IP28650(ALL)01/95]
q
Turn the thumbwheel as far into the MAX
range as you want.
*
[IP28750(ALL)01/95]
q
The further you move the thumbwheel into
the DELAY area (toward the MAX position),
the longer the lamps will stay on after you
leave your vehicle. Similarly, if you move the
thumbwheel only slightly into the DELAY
area, your lamps will stay on only for a
moment after you turn your vehicle off.
%*
[IP29800(ALL)01/95]
Lighting Up the Interior and Instrument
Panel
*
[IP30000(ALL)08/95]
With the light knob in the parking lamps or the
headlamps position, you can brighten or dim the
lights in the instrument panel. To do this, use
the thumbwheel to the left of the steering wheel.
This wheel also turns on the interior lights with
the light switch on or off.
[IP30300(ALL)02/95]
one third page art:0000692-C
The thumbwheel that controls the light on the instrument
panel
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

111 [IP30700(ALL)11/94]
To dim the instrument panel lights, rotate the
thumbwheel down. To turn on the interior
lights, turn the thumbwheel all the way up. The
interior lights also come on when any side door
or the liftgate is opened.
[IP30925(ALL)03/95]
Dome Lamps
[IP30950(ALL)03/95]
The front dome lamp is located overhead
between the driver and front passenger seats.
However, if your vehicle is equipped with a
power moon roof, the dome lamp is located
behind the moon roof.
[IP30975(ALL)11/94]
In the wagon, the rear dome lamp is located
overhead near the rear seating positions.
[IP31025(ALL)02/95]
one third page art:0001410-A
The dome/map lamp
[IP31050(ALL)03/95]
Turn the map lamps on and off with the
switches on the lamp. The dome lamp
illuminates when any door is opened. If either
the driver's or passenger's front door is opened
using the outside door handle, the light will
remain on for 25 seconds after the door has been
shut. If any other door is opened or if either of
the front doors is opened using the inside
handle, the lamp will immediately turn off when
the door is closed.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

115
Steering Column Controls
*
[SC00400(ALL)01/95]
The controls on the steering column and wheel
are designed to give you easy access to the
controls while you are driving.
%
*
[SC00500(ALL)01/95]
The Turn Signal Lever
*
[SC00600(ALL)01/95]
You can use the turn signal lever on the left side
of the steering column to:
[SC00700(ALL)03/95]
q
operate the turn signals
*
[SC00800(ALL)01/95]
q
turn the high beams on/off
*
[SC00900(ALL)01/95]
q
flash the lights
*
[SC01000(ALL)01/95]
q
turn the windshield wipers and washer
on/off
%*
[SC01100(ALL)01/95]
Turn Signals
*
[SC02201(ALL)03/95]
Move the lever up to signal a right turn. Move
it down to signal a left turn. The corresponding
indicator light in the instrument cluster will
flash.
*
[SC02401(ALL)03/95]
If the turn signal stays on after you turn, move
the lever back to the center (off) position.
*
[SC02451(ALL)03/95]
For lane changes, move the lever far enough to
signal but not to latch. The lever will return to
the off position when you release it.
%*
[SC02800(ALL)03/95]
High Beams
*
[SC03100(ALL)08/95]
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

119
*
[SC05560(ALL)03/95]
The hazard flasher serves as a warning to other
drivers to be careful when approaching or
passing your vehicle.
*
[SC05590(ALL)03/95]
The flashers work whether your vehicle is
running or not. The flashers work for up to two
hours when the battery is fully charged and in
good condition without draining the battery
excessively. If the flashers run for longer than
two hours or if the battery is not fully charged,
the battery can be drained.
%
*
[SC05600(ALL)01/95]
Horn
*
[SC05800(ALL)04/95]
To sound the horn, push the center pad area of
the steering wheel.
[SC06000(ALL)02/95]
one third page art:0001403-B
The horn on the steering wheel
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

120
%*
[SC06210(ALL)01/95]
Tilt Steering
*
[SC06400(ALL)04/95]
RWARNING
Never adjust the steering
column/wheel when the vehicle is
moving. You could lose control of the
vehicle and injure someone.
[SC06650(ALL)11/94]
one third page art:0000658-B
The lever to tilt the steering wheel
*
[SC06800(ALL)04/95]
To change the position of the steering
column/wheel, pull the release lever on the
column toward you. Tip the steering wheel to
the desired position. Release the lever to lock the
steering wheel in place.
%
*
[SC07400(ALL)03/91]
Speed Control (If equipped)
*
[SC07500(ALL)03/95]
If your vehicle has speed control, you can
automatically maintain a constant speed at or
above 30 mph (50 km/h).
*
[SC07550(ALL)03/95]
NOTE: Do not shift to N (Neutral) when using
the speed control. This will cause the
engine to overspeed.
*
[SC07600(ALL)04/95]
Use of radio transmitting equipment that is not
Federal Communications Commission (FCC)
approved may cause the speed control to
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

121
malfunction. Therefore, use only properly
installed FCC approved radio transmitting
equipment in your vehicle.
[SC08000(ALL)11/94]
one third page art:0001399-B
The speed control buttons on the steering wheel
*
[SC08200(ALL)03/95]
To set the speed control:
[SC08400(ALL)11/94]
1. Press and release the ON switch. The
CRUISE indicator light in the instrument
cluster will illuminate to indicate that speed
control is in a standby mode.
*
[SC08500(ALL)04/95]
2. Accelerate to the desired speed above
30 mph (50 km/h) using the accelerator
pedal.
*
[SC08800(ALL)03/95]
3. Press the SET ACCEL switch and release it
immediately to set your speed. If you keep
this switch pressed, your speed will continue
to increase.
*
[SC08900(ALL)03/95]
4. Take your foot off the accelerator pedal.
Your vehicle will maintain the speed you set.
*
[SC09000(ALL)01/95]
If you drive up or down a steep hill, your
vehicle may momentarily slow down or speed
up, even though the speed control is on. This is
normal.
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

137 %
*
[FV08700(ALL)02/95]
Replacing lost transmitters
*
[FV08751(ALL)02/95]
In the event a transmitter is lost, you should
take all your vehicle's transmitters to your
dealer to have the remote entry system
deprogrammed for the lost transmitter. This is
necessary to prevent further unauthorized use of
the lost transmitter.
*
[FV08800(ALL)02/95]
You can also purchase additional transmitters
(up to 4 transmitters can be used) from your
dealer. You will need to take all your
transmitters to the dealer so they can program
them to the remote entry system all at the same
time.
[FV08851(ALL)04/95]
Illuminated Entry System
*
[FV08900(ALL)04/95]
This system will provide illumination of the
vehicle's interior courtesy lamps when either
outside front door handle is pulled or when the
remote entry system is used to unlock the door
or sound the personal alarm. The system will
automatically turn off after approximately 25
seconds or when the ignition is turned to the
START or ACC position.
*
[FV08951(ALL)02/95]
NOTE: The inside lights will not turn off if
you have turned them on with the
dimmer thumbwheel or if any door is
open.
[FV09551(ALL)04/95]
Perimeter Anti-Theft System (If equipped)
*
[FV09600(ALL)04/95]
When armed, this system helps protect your
vehicle against break-ins or theft.
%*
[FV09651(ALL)04/95]
When an unauthorized entry occurs, the system
triggers and will:
*
[FV09700(ALL)02/95]
q
flash the headlamps, parking lamps, and theft
indicator lamp
*
[FV09751(ALL)04/95]
q
chirp the horn
File:fcfvs.ex
Update:Wed Dec 20 09:39:11 1995

159 [FV33100(ALL)04/95]
Using the Remote Control for the Trunk
[FV33200(ALL)04/95]
Press the remote release on the instrument panel
to the left of the steering wheel to open the
trunk.
[FV33300(ALL)11/94]
one third page art:0000434-C
The remote control for the trunk
[FV36200(ALL)05/94]
Special Features of Your Wagon
[FV36300(ALL)02/95]
Liftgate
[FV36400(ALL)01/89]
Your wagon has a two-way liftgate that lets you
either open the entire liftgate or just the
window.
[FV36450(ALL)02/95]
To open the liftgate, press the release that is
hidden under the exterior trim panel just above
the license plate. Pull up on the handle to raise
the liftgate.
[FV36500(ALL)02/95]
The liftgate willnotlock automatically when
you close it. To lock the liftgate with the key,
turn left. You can also use the central power
lock on the driver's door or the LOCK button on
the remote entry keyfob, if your vehicle is so
equipped.
[FV36550(ALL)02/95]
When the liftgate is locked, the window will also
lock.
File:fcfvs.ex
Update:Wed Dec 20 09:39:11 1995

195
*
[DR06100(ALL)04/95]
When to use 1 (First)
*
[DR06200(ALL)11/94]
Use 1 (First) when added engine braking is
desired when descending steep hills.
*
[DR06220(ALL)11/94]
The automatic transaxle will shift to the proper
gear to ascend any grade without any need to
shift to 1 (First).
[DR06300(ALL)04/95]
Do not go faster than 38 mph (61 km/h) in this
gear. You can upshift from 1 (First) to D (Drive)
or from 1 (First) toj(Overdrive) at any speed.
*
[DR06400(ALL)01/95]
P (Park)
*
[DR06500(ALL)11/94]
Always come to a complete stop before you shift
into P (Park). Make sure that the gearshift is
securely latched in P (Park). This locks the
transaxle and prevents the front wheels from
rotating.
*
[DR06600(ALL)01/95]
RWARNING
Do not use the P (Park) position in
place of the parking brake. Always
set the parking brake fully and make
sure that the gearshift is securely
latched in P (Park).
*
[DR06625(ALL)03/95]
Always turn off the ignition
whenever you leave your vehicle. Do
not leave your vehicle unattended
while the engine is running.
*
[DR06650(ALL)01/95]
If you do not take these precautions,
your vehicle may move unexpectedly
and injure someone.
[DR06700(ALL)11/94]
You can tell a column-mounted gearshift is
securely latched in P (Park) if you cannot move
it without pulling it toward you and rotating it
downward.
File:fcdrs.ex
Update:Wed Dec 20 09:31:15 1995