Mercury Sable 1996 Owner's Manuals

324
%*
[SV41000(ALL)03/95]
Emission Control System
*
[SV41100(ALL)03/95]
Your vehicle is equipped with a catalytic
converter which enables your vehicle to comply
with applicable exhaust emissions requirements.
*
[SV41200(ALL)01/95]
RWARNING
It is important for your safety and
the efficient operation of your
vehicle that the engine and exhaust
system operate properly. Exhaust
leaks may result in the entry of
harmful and potentially lethal fumes,
particularly carbon monoxide, into
the passenger compartment. In
addition, malfunctions in the engine
or exhaust system can result in
excessive exhaust system
temperatures. Under extreme
conditions (for example, towing a
trailer up a steep hill on a very hot
day with a malfunctioning engine or
exhaust system), excessive exhaust
temperatures could damage the fuel
system, the interior floor covering, or
other vehicle components, possibly
causing a fire and resulting in
personal injury.
*
[SV41300(ALL)01/95]
To make sure that the catalytic converter and the
other emissions control parts continue to work
properly:
*
[SV41400(ALL)01/95]
q
Use only unleaded fuel.
*
[SV41500(ALL)01/95]
q
Avoid running out of fuel.
*
[SV41600(ALL)01/95]
q
Do not turn off the ignition while your
vehicle is moving, especially at high speeds.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

325
*
[SV41700(ALL)03/95]
q
Have the services listed in yourMaintenance
Schedule and Recordbooklet performed
according to the specified schedule.
*
[SV41710(ALL)03/95]
The Scheduled Maintenance Services listed in the
Maintenance Schedule and Recordbooklet are
required because they are considered essential to
the life and performance of your vehicle and to
its emissions system.
%*
[SV41720(ALL)03/95]
Ford strongly recommends the use of genuine
Ford replacement parts. If other than Ford or
Motorcraft parts or Ford authorized
remanufactured parts are used for maintenance
replacements or for the service of components
affecting emissions control, such non-Ford parts
should be equivalent to genuine Ford Motor
Company parts in performance and durability. It
is the owner's responsibility to determine the
equivalency of such parts. Please consult your
warranty booklet for complete warranty
information.
*
[SV41800(ALL)03/95]
RWARNING
Do not park, idle, or drive your
vehicle in dry grass or other dry
ground cover. The emissions system
heats up the engine compartment and
exhaust system, which can start a
fire.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

326 [SV41900(ALL)04/95]Watch for fluid leaks, strange odors, smoke, loss
of oil pressure, the charging system warning
light, the service engine soon light, or the
temperature warning light. These sometimes
indicate that the emissions system is not
working properly.
*
[SV42000(ALL)01/95]
Do not make any unauthorized changes to your
vehicle or engine. Changes that cause more
unburned fuel to reach the exhaust system can
increase the temperature of the engine or
exhaust system.
*
[SV42100(ALL)01/95]
By law, anyone who manufactures, repairs,
services, sells, leases, trades vehicles, or
supervises a fleet of vehicles is not permitted to
intentionally remove an emission control device
or prevent it from working. In some of the
United States and in Canada, vehicle owners
may be liable if their emission control device is
removed or is prevented from working.
*
[SV42200(ALL)02/92]
Never use a metal exhaust collector when you
service your vehicle. If the metal collector
contacts any of your vehicle's plastic trim or
bumper parts they could melt or deform.
*
[SV42300(ALL)01/95]
Do not drive your vehicle if it does not operate
properly. See your dealer if the engine runs on
for more than five seconds after you shut it off
or if it misfires, surges, stalls, or backfires.
%*
[SV42400(ALL)02/95]
Information about your vehicle's emission
control system is on the Vehicle Emission
Control Information decal located on or near the
engine. This decal identifies engine displacement
and gives some tune-up specifications.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

327 %
*
[SV42405(ALL)03/95]
Readiness for Inspection/Maintenance
Testing
*
[SV42410(ALL)03/95]
In some localities it may become a legal
requirement to pass an
Inspection/Maintenance (I/M) test of the
On-Board Diagnostic (OBD) II system. If the
vehicle's powertrain system or its battery has
just been serviced, the OBD II system is reset to
a not ready for I/M testing condition. To
prepare for I/M testing, the law specifies a
ªneed for additional mixed city and highway
driving to complete the checkº of the OBD II
system. As soon as all of the OBD II system
checks are successfully completed, the OBD II
system is set to the ready condition. The amount
of driving required to reach the ready condition
varies with individual driving patterns. To
complete this requirement in the minimum
amount of time, refer to the OBD II Drive Cycle
defined below. If the vehicle owner cannot or
does not want to do the additional driving
required by law, a service center can perform
this drive cycle as it would any other type of
repair work.
*
[SV42420(ALL)03/95]
OBD II Drive Cycle
*
[SV42430(ALL)04/95]
The following steps must be run in the order
shown. If any steps are interrupted, repeat the
preceding step. Any safe driving mode is
acceptable between steps.
*
[SV42440(ALL)03/95]
Always drive vehicle in safe manner according
to traffic conditions and obey all traffic laws.
[SV42445(ALL)04/95]
The engine must be warmed up and at
operating temperature before proceeding with
the drive modes of the following OBD II Drive
Cycle.
*
[SV42450(ALL)04/95]
1. Start the engine. Drive or idle (in neutral)
the vehicle for 4 minutes.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

328
*
[SV42460(ALL)04/95]
2. Idle the vehicle in Drive for 40 seconds.
*
[SV42465(ALL)04/95]
3. Accelerate the vehicle to 45 mph (72 km/h)
at 1/4 to 1/2 throttle for 10 seconds.
*
[SV42471(ALL)04/95]
4. Drive the vehicle with a steady throttle at
45 mph (72 km/h) for 30 seconds.
[SV42475(ALL)04/95]
5. Idle the vehicle in drive for 40 seconds.
*
[SV42481(ALL)04/95]
6. Continue to drive the vehicle in city traffic at
speeds between 25 and 40 mph
(40-64 km/h) for 15 minutes. During the 15
minute drive cycle the following modes must
be achieved:
*
[SV42485(ALL)04/95]
a. at least 5 stop and idle modes at 10
seconds each
*
[SV42491(ALL)04/95]
b. acceleration from idles at 1/4 to 1/2
throttle position, and
*
[SV42495(ALL)04/95]
c. choose 3 different speeds to do 1.5
minute steady state throttle drives.
*
[SV42500(ALL)04/95]
7. Accelerate the vehicle up to between 45 and
60 mph (72-97 km/h). This should take
approximately 5 minutes.
*
[SV42505(ALL)04/95]
8. Drive vehicle and hold the throttle steady at
the selected speed between 45 and 60 mph
(72-97 km/h) for approximately 5 minutes.
*
[SV42510(ALL)04/95]
9. Drive the vehicle for 5 minutes at varying
speeds between 45 and 60 mph
(72-97 km/h).
*
[SV42515(ALL)04/95]
10. Bring the vehicle back to idle. Idle in drive
for 40 seconds.
*
[SV42601(ALL)04/95]
11. OBD II drive cycle has been completed.
Vehicle can be turned off when convenient.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

329
*
[SV42650(ALL)03/95]
Refill Capacities, Motorcraft Parts,
and Lubricant Specifications
%*
[SV42700(ALL)03/95]
Refill Capacities
[SV42730(ALL)04/95]
twenty-two pica chart:0000328-LFile:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

330 %
*
[SV42800(ALL)01/95]
Motorcraft Parts
[SV42930(ALL)04/95]
eighteen pica chart:0000330-KFile:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

331 %
*
[SV42980(ALL)03/95]
Lubricant Specifications
[SV43000(ALL)04/95]
twenty-two pica chart:0000720-SFile:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

332
%*
[SV44000(ALL)01/95]
Vehicle Storage
*
[SV44100(ALL)01/95]
Maintenance Tips
*
[SV44150(ALL)01/95]
If you plan on storing your vehicle for an
extended period of time (60 days or more), refer
to the following maintenance recommendations
to ensure your vehicle stays in good operating
condition.
*
[SV44200(ALL)01/95]
General
*
[SV44300(ALL)01/95]
q
Store all vehicles in a dry, ventilated place.
*
[SV44400(ALL)01/95]
q
Protect from sunlight, if possible.
*
[SV44500(ALL)01/95]
q
If vehicles are stored outside, they require
regular maintenance to protect against rust
and damage.
*
[SV44600(ALL)01/95]
Body
*
[SV44700(ALL)01/95]
q
Wash vehicle thoroughly to remove dirt,
grease, oil, tar or mud from exterior surfaces,
rear wheel housing and underside of front
fenders.
*
[SV44800(ALL)01/95]
q
Periodically wash vehicles stored in exposed
locations.
*
[SV44900(ALL)01/95]
q
Touch-up raw or primed metal to prevent
rust.
*
[SV45000(ALL)01/95]
q
Cover chrome and stainless steel parts with a
thick coat of auto wax to prevent
discoloration. Re-wax as necessary when the
vehicle is washed.
[SV45100(ALL)04/95]
q
Lubricate all hood, door and trunk latches
with a light grade oil.
[SV45150(ALL)04/95]
q
Lubricate trunk lid or wagon liftgate hinges
with a light grade oil. (Do not lubricate hood
and door hinges.)
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

333
*
[SV45200(ALL)01/95]
q
Cover interior soft trim to prevent fading.
*
[SV45300(ALL)01/95]
q
Keep all rubber parts free from oil and
solvents.
%*
[SV45350(ALL)01/95]
Engine
*
[SV45400(ALL)01/95]
q
Start engine every 15 days. Run at fast idle
until it reaches normal operating temperature.
*
[SV45500(ALL)01/95]
q
With your foot on the brake, shift through all
the gears while the engine is running.
%*
[SV45600(ALL)01/95]
Fuel system
*
[SV45700(ALL)07/94]
q
Fill fuel tank with high-quality unleaded fuel
until the first automatic shutoff of the fuel
pump nozzle.
*
[SV45900(ALL)03/95]
NOTE: During extended periods of vehicle
storage (60 days or more), fuel may
deteriorate due to oxidation. This can
damage rubber and other polymers in
the fuel system and may also clog
small orifices.
*
[SV46000(ALL)01/95]
Ford Gas Stabilizer should be added whenever
actual or expected storage periods exceed 60
days. Follow the instructions on the label. The
vehicle should then be operated at idle speed to
circulate the additive throughout the fuel system.
*
[SV46100(ALL)01/95]
A volatile corrosion inhibitor added to the fuel
system will protect the fuel system's inner
surfaces from corrosion. Follow the instructions
packaged with the product.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995