ignition Mercury Sable 1996 Owner's Manuals

31 %
*
[SR18450(ALL)03/95]
The air bag system uses a readiness light on the
instrument cluster and a tone to indicate the
condition of the system. When you turn the
ignition key to the ON position, this light will
illuminate for approximately six (6) seconds and
then turn off. This indicates that the system is
operating normally. NOTE: Maintenance of the
air bag system is not required.
*
[SR18475(ALL)03/95]
A problem with the system is indicated by one
or more of the following:
*
[SR18501(ALL)03/95]
q
the readiness light will either flash or stay lit,
*
[SR18525(ALL)03/95]
q
or it will not light immediately after ignition
is turned on,
*
[SR18550(ALL)03/95]
q
or a group of five beeps will be heard. The
tone pattern will repeat periodically until the
problem and light are repaired.
*
[SR18575(ALL)03/95]
If any of these things happen, have the air bag
system serviced at your Ford or Lincoln-Mercury
dealer immediately. Unless serviced, the Air Bag
Supplemental Restraint System may not function
properly in the event of a collision.
*
[SR18601(ALL)01/95]
RWARNING
Do not attempt to service, repair, or
modify the Air Bag Supplemental
Restraint System; tampering could
cause activation of the system and
increase the risk of personal injury.
DO NOT REPLACE OR
OTHERWISE TAMPER WITH THE
AIR BAG FUSES. For servicing of
the Air Bag Supplemental Restraint
System, see your Ford or
Lincoln-Mercury dealer.
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

33
*
[SR20650(ALL)02/95]
RWARNING
When possible, put children in the
rear seat of your vehicle. Accident
statistics suggest that children are
safer when properly restrained in the
rear seating positions than in the
front seating positions.
*
[SR20700(ALL)01/95]
RWARNING
When using any infant or child
restraint system, it is important that
you follow the instructions and
warnings provided by the
manufacturer concerning its
installation and use. Failure to follow
each of the restraint manufacturer's
instructions could increase the risk or
severity of an injury in the event of
a collision or sudden stop.
*
[SR20900(ALL)01/95]
Safety belts and seats can become hot
in a vehicle that has been closed up
in sunny weather; they could burn a
small child. Check seat covers and
buckles before you place a child
anywhere near them.
*
[SR21000(ALL)01/95]
RWARNING
Never leave a child unattended in
your vehicle. Always remove the key
from the ignition and take it with
you.
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

61
Starting Your Sable
*
[ST03300(ALL)03/95]
Ignition
%*
[ST03400(ALL)01/95]
Understanding the Positions of the Ignition
[ST03725(ALL)11/94]
quarter page art:0000017-D
The positions of the key in the ignition
%*
[ST04050(ALL)03/95]
ACCESSORY allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
[ST04100(ALL)10/89]
LOCK locks the steering wheel. It also locks the
gearshift for all vehicles with an automatic
transaxle.
[ST04175(ALL)03/95]
The automatic transaxle gearshift must be in P
(Park) to move the key to the LOCK position.
File:fcsts.ex
Update:Wed Dec 20 09:34:24 1995

62 %
*
[ST04200(ALL)01/95]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
%*
[ST04300(ALL)03/95]
If the key is stuck in the LOCK position, move
your steering wheel left or right until the key
turns freely.
[ST04325(ALL)04/95]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transaxle gearshift lever.
*
[ST04350(ALL)03/95]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
*
[ST04375(ALL)03/95]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake warning light.
*
[ST04500(ALL)02/95]
Removing the Key From the Ignition
[ST06000(ALL)02/95]
Procedures for removing the key from the
ignition will be the same for both the column-
and console-mounted gearshifts.
*
[ST06300(ALL)03/95]
1. Put the gearshift in P (Park).
*
[ST06400(ALL)01/95]
2. Set the parking brake fully.
[ST06500(ALL)11/94]
3. Turn the ignition to the LOCK position.
*
[ST06600(ALL)03/95]
4. Remove the key.
[ST07310(ALL)12/94]
If you have difficulty in turning the key, rotate
the steering wheel slightly because it may be
binding.
%*
[ST07520(ALL)03/95]
If the driver's door is open while the key is still
in the ignition, a warning chime sounds.
File:fcsts.ex
Update:Wed Dec 20 09:34:24 1995

64
*
[ST08200(ALL)03/95]
Starting Your Vehicle
*
[ST08300(ALL)05/94]
Preparing to Start Your Vehicle
*
[ST08350(ALL)02/95]
RWARNING
Do not start your vehicle in a closed
garage or other enclosed area.
Exhaust fumes are toxic. Always open
the garage door before you start the
engine. SeeGuarding Against Exhaust
Fumesin this chapter for more
instructions.
*
[ST08400(ALL)01/95]
Before you start your vehicle, do the following:
*
[ST08500(ALL)01/95]
1. Make sure you and all your passengers
buckle your safety belts. SeeSafety Restraints
in the Index for more details.
*
[ST08600(ALL)03/95]
2. Make sure your headlamps and other
accessories are turned off and the parking
brake is set.
[ST08850(ALL)11/94]
3. Make sure that the gearshift is in P (Park)
before you turn the key.
*
[ST09150(ALL)03/95]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to theWarning
Lights and Gaugeschapter.
%*
[ST09310(ALL)02/95]
Starting Your Engine
*
[ST09320(ALL)02/95]
To start your engine:
*
[ST09330(ALL)03/95]
1. Follow the steps underPreparing to Start
Your Vehicleat the beginning of this section.
*
[ST09340(ALL)03/95]
2. Turn the ignition key to the ON position.
*
[ST09350(ALL)03/95]
3. DO NOT depress the accelerator pedal when
starting your engine. DO NOT use the
accelerator while the vehicle is parked.
File:fcsts.ex
Update:Wed Dec 20 09:34:24 1995

66 [ST09420(ALL)11/94]NOTE: Your vehicle is equipped with an
automatic transaxle and has an
interlock that prevents you from
shifting out of P (Park) unless your
foot is on the brake pedal.
*
[ST09480(ALL)04/95]
If the engine does not start after two attempts:
*
[ST09492(ALL)04/95]
1. Turn the ignition key to the OFF position.
*
[ST09494(ALL)04/95]
2. Press the accelerator all the way to the floor
and hold it.
*
[ST09496(ALL)04/95]
3. Turn the ignition key to the START position.
*
[ST09497(ALL)04/95]
4. Release the ignition key when the engine
starts.
*
[ST09498(ALL)04/95]
5. Release the accelerator gradually as the
engine speeds up. Then drive away in the
normal manner.
*
[ST09500(ALL)04/95]
If the engine still does not start, the fuel pump
shut-off switch may have been triggered. For
directions on how to reset the switch seeFuel
Pump Shut-Off Switchlater in this chapter.
%*
[ST10200(ALL)04/95]
A computer system controls the engine's idle
speed. When you start your vehicle, the engine's
idle speed normally runs high. These faster
engine speeds will make your vehicle move
slightly faster than its normal idle speed. It
should, however, slow down after a short time.
If it does not, have the idle speed checked.
File:fcsts.ex
Update:Wed Dec 20 09:34:24 1995

70
*
[ST11800(ALL)03/95]
RWARNING
If you see or smell fuel, do not reset
the switch or try to start your vehicle.
You could injure yourself or others.
Have all the passengers get out of
the vehicle and call the local fire
department or a towing service.
*
[ST11900(ALL)03/95]
If your engine cranks but does not start after a
collision or substantial jolt:
*
[ST11950(ALL)04/95]
1. Turn the ignition key to the OFF position.
*
[ST12000(ALL)03/95]
2. Check under the vehicle for leaking fuel.
*
[ST12050(ALL)01/95]
3. If you do not see or smell fuel, push the red
reset button on the fuel pump shut-off
switch down.
*
[ST12100(ALL)03/95]
4. Turn the ignition key to the ON position for
a few seconds, then turn it to the OFF
position.
*
[ST12150(ALL)03/95]
5. Check under the vehicle again for leaking
fuel.If you see or smell fuel, do not start
your vehicle again.If you do not see or
smell fuel, you can try to start your vehicle
again.
*
[ST12200(ALL)03/95]
6. Check all vehicle warning lights before
driving the vehicle.
*
[ST12225(ALL)01/95]
Pushing
*
[ST12250(ALL)11/94]
Vehicles with automatic transaxles cannot be
started by pushing. Follow the directions under
If Your Vehicle Needs a Jump-Startin theRoadside
EmergenciesChapter.
File:fcsts.ex
Update:Wed Dec 20 09:34:24 1995

95 [IP04001(ALL)04/95]
P(Floor and defrost)
[IP04050(ALL)04/95]
This brings in outside air through the floor ducts
and the windshield defroster ducts. It can be
used for heating or ventilation.
[IP04100(ALL)04/95]
V(Defrost)
[IP04150(ALL)04/95]
This brings in outside air through the
windshield defroster ducts. It can be used to
clear ice or fog from the windshield.
[IP04200(ALL)03/95]
Temperature control knob
[IP04250(ALL)03/95]
The temperature control knob may be adjusted
from cool (blue range) to warm (red range).
%*
[IP04700(ALL)04/95]
Electronic Automatic Temperature Control
System
*
[IP04725(ALL)02/95]
The control for your Electronic Automatic
Temperature Control (EATC) is located at the
center of the instrument panel in the Integrated
Control Panel and will operate only when the
ignition is turned on to the ON position.
*
[IP04825(ALL)02/95]
The EATC feature will maintain the temperature
you select and automatically control the airflow
for your comfort. It also allows you to override
the automatic operation with manual override
buttons.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

105 [IP22300(ALL)04/95]
Clear away any snow that is on the rear
window and side view mirrors before using the
defroster. With the engine running, push the
defrost button. After 10 minutes, the defroster
will turn off. If the window and mirrors are still
not clear, push the defroster button again. The
defroster will turn off when the ignition key is
turned to the OFF position.
%*
[IP23000(ALL)03/94]
NOTE: Never use sharp instruments or
window cleaners with abrasives to
clean the inside of your rear window.
If you do, you may damage the heating
elements that are bonded to the inside
of the rear window and cause damage
to the rear window defroster.
[IP23200(ALL)04/95]
Liftgate Window Wiper and Washer (If
equipped)
[IP23401(ALL)04/95]
quarter page art:0000696-E
The liftgate window wiper and washer switches
[IP23500(ALL)04/95]
To turn on the liftgate window wiper, press the
bswitch. To turn the liftgate window wiper
off, press the switch again.
[IP23550(ALL)04/95]
To turn on the liftgate window washer, press the
dswitch. When thedswitch is pressed, it also
turns on the liftgate wiper.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

108
*
[IP25638(ALL)01/95]
RWARNING
When the Daytime Running Light
(DRL) system is active the tail lamps,
parking lamps and side markers on
your vehicle will not be illuminated.
It is necessary to turn on your
headlamps at dusk. Failure to do so
may result in a collision, possibly
injuring yourself and others.
%*
[IP25640(ALL)04/95]
Cleaning the Exterior Lamps
*
[IP25650(ALL)04/95]
Do not use dry paper towel, chemical solvents
or abrasive cleaners to clean the lamps, as these
may cause scratches or crack the lamps.
%*
[IP26600(ALL)02/95]
Setting the Autolamp Delay System
(If equipped)
*
[IP26700(ALL)02/95]
The autolamp sets the headlamps to turn on and
off automatically. You can use the autolamp to:
*
[IP26800(ALL)01/95]
q
turn on the lamps automatically at night
*
[IP26900(ALL)01/95]
q
turn off the lamps automatically during
daylight
[IP27000(ALL)11/94]
q
keep the lamps on for up to three minutes
after you turn the ignition to the OFF
position.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995