change wheel Mercury Sable 1996 Owner's Manuals

115
Steering Column Controls
*
[SC00400(ALL)01/95]
The controls on the steering column and wheel
are designed to give you easy access to the
controls while you are driving.
%
*
[SC00500(ALL)01/95]
The Turn Signal Lever
*
[SC00600(ALL)01/95]
You can use the turn signal lever on the left side
of the steering column to:
[SC00700(ALL)03/95]
q
operate the turn signals
*
[SC00800(ALL)01/95]
q
turn the high beams on/off
*
[SC00900(ALL)01/95]
q
flash the lights
*
[SC01000(ALL)01/95]
q
turn the windshield wipers and washer
on/off
%*
[SC01100(ALL)01/95]
Turn Signals
*
[SC02201(ALL)03/95]
Move the lever up to signal a right turn. Move
it down to signal a left turn. The corresponding
indicator light in the instrument cluster will
flash.
*
[SC02401(ALL)03/95]
If the turn signal stays on after you turn, move
the lever back to the center (off) position.
*
[SC02451(ALL)03/95]
For lane changes, move the lever far enough to
signal but not to latch. The lever will return to
the off position when you release it.
%*
[SC02800(ALL)03/95]
High Beams
*
[SC03100(ALL)08/95]
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

120
%*
[SC06210(ALL)01/95]
Tilt Steering
*
[SC06400(ALL)04/95]
RWARNING
Never adjust the steering
column/wheel when the vehicle is
moving. You could lose control of the
vehicle and injure someone.
[SC06650(ALL)11/94]
one third page art:0000658-B
The lever to tilt the steering wheel
*
[SC06800(ALL)04/95]
To change the position of the steering
column/wheel, pull the release lever on the
column toward you. Tip the steering wheel to
the desired position. Release the lever to lock the
steering wheel in place.
%
*
[SC07400(ALL)03/91]
Speed Control (If equipped)
*
[SC07500(ALL)03/95]
If your vehicle has speed control, you can
automatically maintain a constant speed at or
above 30 mph (50 km/h).
*
[SC07550(ALL)03/95]
NOTE: Do not shift to N (Neutral) when using
the speed control. This will cause the
engine to overspeed.
*
[SC07600(ALL)04/95]
Use of radio transmitting equipment that is not
Federal Communications Commission (FCC)
approved may cause the speed control to
File:fcscs.ex
Update:Tue Aug 8 11:05:58 1995

214
*
[DR26580(ALL)01/95]
RWARNING
Do not tow a trailer when the
temporary spare tire is being used.
Tire failure, loss of vehicle control,
and possible injury to vehicle
occupants could result.
*
[DR26600(ALL)01/95]
Ten to 15% of the loaded trailer's weight should
be on the tongue. However, the tongue load
should never exceed 10% of the maximum
weight that your vehicle can safely tow.
*
[DR28500(ALL)01/95]
Preparing to Tow
*
[DR28600(ALL)01/95]
For your safety and for the good of your
vehicle, use the right equipment for the type of
trailer you tow. Also, make sure that all towing
equipment is properly attached to your vehicle.
If you are not certain that you are using the
right equipment in the proper manner, see your
Ford or Lincoln-Mercury dealer.
*
[DR28700(ALL)01/95]
Do not use hitches that clamp onto your
vehicle's bumper. The bumper is not designed to
bear the load.
%*
[DR28750(ALL)01/95]
Using the hitch
*
[DR28800(ALL)05/94]
Your vehicle uses a load carrying hitch. Because
this type of hitch places the tongue load of a
trailer on the rear wheels of your vehicle, you
must distribute the load in your trailer so that
10 to 15% of the total weight of the trailer is on
the tongue.
*
[DR28900(ALL)01/95]
Tie down the load so that it does not shift and
change the weight on the hitch. This will
prevent damage to your vehicle and make your
vehicle easier to handle.
File:fcdrs.ex
Update:Wed Dec 20 09:31:15 1995

224 [RE06400(ALL)02/95]
one third page art:0000392-BThe temporary spare tire in the wagon
[RE06700(ALL)11/94]
To remove the cover for the temporary spare
tire in the wagon:
[RE06800(ALL)04/95]
1. Twist the three fasteners 90 degrees into a
vertical position.
[RE06900(ALL)02/95]
2. Lift the the cover to disengage the three
retainers.
[RE07000(ALL)05/94]
3. Pull the front of the cover out slightly and
remove the cover by sliding it toward the
front of the vehicle.
[RE07100(ALL)01/89]
4. Lift out the spare tire, jack, and lug wrench.
%*
[RE07400(ALL)03/95]
Preparing to Change the Tire
*
[RE07500(ALL)05/94]
You should only raise your vehicle with a jack
properly placed at the front or rear jacking
points.
*
[RE07600(ALL)03/95]
1. Make sure that your vehicle will not move
or roll. Put the gearshift in P (Park). Set the
parking brake and block the wheel that is
diagonally opposite the tire that you are
changing.
File:fcres.ex
Update:Tue Aug 8 11:02:29 1995

225
*
[RE08400(ALL)11/94]
RWARNING
When one of the front wheels is off
the ground, the transaxle alone will
not prevent the vehicle from moving
or slipping off the jack, even if the
vehicle is in P (Park). To prevent the
vehicle from moving when you
change a tire, block (in both
directions) the wheel that is
diagonally opposite to the tire being
changed. If the vehicle slips off the
jack, you or someone else could be
seriously injured.
*
[RE08800(ALL)02/95]
2. Get out the spare tire and jack.
*
[RE08850(ALL)05/94]
RWARNING
To avoid injury, never run the engine
with one wheel off the ground when
changing a tire, or at any other time.
The wheel still on the ground could
cause the vehicle to move.
[RE08900(ALL)02/93]
3. Remove wheel covers or aluminum wheel
ornaments with the tapered end of a wheel
nut wrench. Insert the handle of the wrench
between the wheel and ornament and twist
it against the inner wheel cover flange.
*
[RE09200(ALL)01/95]
4. Loosen each wheel lug nut one-half turn
counterclockwise, but do not remove them
until the tire is raised off the ground. You
should pull up on the handle rather than
push to develop maximum force to loosen
wheel lug nuts. SeeAnti-Theft Wheel Lug
Nutslater in this chapter for information on
removing anti-theft lug nuts.
File:fcres.ex
Update:Tue Aug 8 11:02:29 1995