belt Mercury Villager 1996 Owner's Manuals

9
Safety Restraints
%*
[SR00600(ALL)04/95]
Important Safety Belt Information
*
[SR00700(ALL)03/95]
The use of safety belts helps to restrain you and your
passengers in case of a collision. In most states and in Canada
the law requires their use.
*
[SR00800(ALL)08/95]
Safety belts provide best restraint when:
*
[SR00900(ALL)08/95]
n
the seatback is upright
*
[SR01000(ALL)08/95]
n
the occupant is sitting upright (not slouched)
*
[SR01100(ALL)08/95]
n
the lap belt is snug and low on the hips
*
[SR01200(ALL)08/95]
n
the shoulder belt is snug against the chest
*
[SR01300(ALL)08/95]
n
the knees are straight forward
*
[SR01400(ALL)07/95]
To help you remember to fasten your safety belt, a warning
light may come on and a chime may sound. SeeSafety Belt
Warning Light and Chimein theWarning Lights and Gauges
chapter.
*
[SR01900(ALL)07/95]
See the following sections in this chapter for directions on how
to properly use these safety belts. Also seeSafety Restraints for
Childrenin this chapter for special instructions about using
safety belts for children.
%*
[SR02000(ALL)05/95]
RWARNING
Make sure that you and your passengers wear safety
belts. Always drive and ride with your seatback upright
and the lap belt snug and low across the hips.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

10
*
[SR02050(ALL)06/95]
RWARNING
Never wear the shoulder belt under the arm. Never
swing it around the neck over the inside shoulder. Never
use a single belt for more than one person or across more
than one seating position. Each seating position in your
vehicle has a specific safety belt assembly which is made
up of one buckle and one tongue that are designed to be
used as a pair. Failure to follow these precautions could
increase the risk and/or severity of injury in a collision.
*
[SR02100(ALL)06/95]
RWARNING
Never drive or ride with a twisted or jammed safety belt.
If you cannot untwist or unjam the safety belt, see the
nearest qualified technician immediately.
*
[SR02200(ALL)06/95]
RWARNING
Children should always ride with the seatback in the
fully upright position. When the seatback is not fully
upright, there is a greater risk that the child will slide
under the safety belt and be seriously injured in a
collision.
*
[SR02300(ALL)08/95]
RWARNING
Never let a passenger hold a child on his or her lap
while the vehicle is moving. The passenger cannot
protect the child from injury in a collision.
*
[SR02700(ALL)09/95]
RWARNING
Lock the doors of your vehicle before driving to lessen
the risk of the door coming open in a collision.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

Safety Restraints
11
%*
[SR10000(ALL)05/95]
Combination Lap and Shoulder Belts
[SR10050(ALL)06/95]
While your vehicle is in motion, the combination lap and
shoulder belt adjusts to your movement. However, if you brake
hard, turn hard, or if your vehicle receives an impact of 5 mph
(8 km/h) or more, the lap and shoulder belt locks and helps to
reduce your forward movement.
*
[SR10200(ALL)05/95]
After you get into your vehicle, close the door and lock it. Then
adjust the seat to the position that suits you best.
[SR10400(ALL)06/95]
To fasten the belt, pull the combination lap and shoulder belt
from the retractor so that the shoulder portion of the belt
crosses your shoulder and chest. Be sure the belt is not twisted.
If it is, remove the twist. Insert the belt tongue into the proper
buckle until you hear a snap and feel it latch. Make sure the
tongue is securely fastened to the buckle by pulling on tongue.
[SR10420(ALL)06/95]
10-1/2 pica
art:0040315-A
Fastening the front seat combination lap and shoulder belt
[SR10430(ALL)09/95]
NOTE: Be sure to read and understandImportant Safety Belt
Informationat the beginning of this chapter.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

12
[SR10450(ALL)06/95]
7-1/2 pica art:0040314-A
Unfastening the combination lap and shoulder belts Ð front and rear outboard
seating positions
[SR10500(ALL)01/93]
Third-row passengers should be aware that the proper safety
belt for their seating position is slightly behind their seat. They
should not use the second-row safety belts which are in front of
the third seat.
[SR10600(ALL)09/93]
17-1/2 pica
art:0040004-A
Fastening the rear seat combination lap and shoulder belt
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

Safety Restraints
13
*
[SR10700(ALL)05/95]
RWARNING
Use the shoulder belt on the outside shoulder only.
Never wear the shoulder belt under the arm. Never
swing it around the neck over the inside shoulder. Never
use a single belt for more than one person. Failure to
follow these precautions could increase the risk and/or
severity of injury in a collision.
*
[SR10800(ALL)05/95]
To tighten the lap portion of the belt, pull up on the shoulder
belt until it fits you snugly. The belt should rest as low on your
hips as possible.
[SR10850(ALL)02/95]
The passenger seated near the sliding door in the
three-passenger bench seat can route the safety belt webbing
under the guide located on the head restraint. This safety belt
guide is designed to help keep the safety belt webbing properly
positioned across the passenger's chest for maximum comfort.
This guide is only needed when the two-passenger second row
bench seat is removed and the three-passenger bench seat is
moved up to the second-row position.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

14
[SR10900(ALL)09/93]
27-1/2 pica
art:0040029-A
Using the seat belt guide with the three-passenger bench seat in the second row
position
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

Safety Restraints
15
[SR11100(ALL)09/95]
NOTE: The second row two-passenger bench seat has a
unique safety restraint system. If your vehicle has the
two-passenger bench seat it is very important that the
unique safety belt system is used properly. Please
readAuxiliary safety restraint system for the second
row bench seatin this section, which explains the
unique safety belt system. Be sure that you
understand it before anyone rides in the
two-passenger bench seat.
[SR11115(ALL)06/95]
Passenger Outboard Lap/Shoulder Belts
[SR11117(ALL)06/95]
All seats except the driver's seat and the third seat middle
position are equipped with a dual locking mode retractor on the
shoulder belt portion of the lap/shoulder safety belt. (The
driver's seat has only a vehicle sensitive locking mode and the
third seat middle position has a lap belt without a retractor
Ðdescription follows.)
[SR11125(ALL)06/95]
Dual Locking Mode Retractors Operate in Two Ways:
*
[SR11130(ALL)08/95]
Vehicle sensitive (emergency) locking mode
*
[SR11140(ALL)06/95]
In this operating mode, the shoulder belt retractor will allow the
occupant freedom of movement, locking tight only on hard
braking, hard cornering or impacts of approximately 5 mph
(8 km/h) or more.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

16
%*
[SR11150(ALL)08/95]
Automatic locking mode
*
[SR11160(ALL)08/95]
In this operating mode, the shoulder belt retractor will be
automatically locked and will remain locked when the
combination lap/shoulder safety belt is buckled, and does not
allow the occupant freedom of movement. This mode provides
the following:
*
[SR11163(ALL)08/95]
n
A tight lap/shoulder belt on the occupant.
*
[SR11165(ALL)08/95]
n
Child safety seat installation.
[SR11180(ALL)05/96]
RWARNING
Rear-facing infant seats or infant carriers should never be
placed in the front seats.
*
[SR11190(ALL)09/95]
This modemust be usedwhen installing a child safety seat on
the front passenger seat and rear outboard seats where dual
locking retractors are provided.
*
[SR11200(ALL)08/95]
To switch the retractor from the emergency locking mode to the
automatic locking mode, perform the following steps:
*
[SR11210(ALL)08/95]1.
Buckle the lap/shoulder combination belt.
*
[SR11220(ALL)09/95]2.
Grasp the shoulder portion of the belt and pull downward
until all of the belt is extracted and, when allowed to retract,
a clicking sound is heard. At this time, the belt retractor is in
the automatic locking mode (child restraint mode).
*
[SR11230(ALL)08/95]3.
A clicking sound will continue to be heard as the belt is
allowed to retract. This indicates that the retractor is in the
automatic locking mode.
*
[SR11240(ALL)08/95]
NOTE: When the combination lap/shoulder belt is unbuckled
and allowed to retract completely, the retractor will
switch to the vehicle sensitive (emergency) locking
mode. See the detailed instructions underSafety Seats
for Childrenin this chapter.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

Safety Restraints
17
%*
[SR11250(ALL)08/95]
Shoulder Belt Height Adjustment
*
[SR11260(ALL)08/95]
Driver and right front passenger
*
[SR11270(ALL)06/95]
You can adjust the shoulder belt height to one of five (5)
positions.
[SR11280(ALL)06/95]
To adjust the belt down, pinch the release button. To adjust the
belt up, pinch the release button and slide the adjuster up.
*
[SR11285(ALL)06/95]
Make sure the adjuster is firmly in one of the five positions. The
belt should be adjusted up or down until the belt rests on your
shoulder near your neck.
[SR11288(ALL)07/95]
10-1/2 pica
art:0040317-A
The shoulder belt height adjuster
*
[SR11290(ALL)06/95]
RWARNING
Position the shoulder belt height adjuster so that the belt
rests across the middle of your shoulder. Be sure the
shoulder belt is properly positioned on your shoulder
each time you use the belt. If the shoulder belt is off
your shoulder, on your upper arm or neck, there is a
greater risk of severe injury in a collision.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996

18
[SR11295(ALL)06/95]
Lap Belt Without a Retractor (for the three-passenger
bench seat)
[SR11300(ALL)01/93]
The center seat of the three-passenger bench seat has a lap belt
without a retractor. To make the belt longer, tip the tongue at a
right angle to the belt and pull the belt over your lap until the
tongue reaches the buckle.
*
[SR11700(ALL)06/95]
To fasten the belt, pull the belt across your hips and insert the
tongue into the correct buckle on your seat until you hear a
snap and feel it lock. Make sure the buckle is securely fastened.
*
[SR11800(ALL)05/95]
Adjust the belt so that it fits snugly and as low as possible
around the hips:
*
[SR11900(ALL)06/95]
n
If you need to lengthen the belt, unfasten it and repeat the
procedure above.
*
[SR12000(ALL)06/95]
n
If you need to shorten the belt, pull on the loose end of the
webbing.
[SR12100(ALL)01/93]
To store the belt:
[SR12200(ALL)01/93]
Fasten the center tongue and buckle when not in use. This will
prevent the belt from falling between the seat and the seatback.
[SR12205(ALL)06/95]
Auxiliary Safety Restraint System for the Second Row
Bench Seat (7 passenger vehicle)
*
[SR12210(ALL)11/93]
There is a unique safety restraint system for the outside seating
position of the second row bench seat. It is very important that
you read and understand this section before anyone rides in the
outside seating position (near the sliding door) of the
two-passenger bench seat.
[SR12215(ALL)06/95]
The two-passenger bench seat in the second row has a safety
restraint system made up of two buckles and two tongues.
There is an anchor location at the bottom of the C-pillar and
another anchor location at the top of the C-pillar that attach
each end of the seat belt webbing to the bodyside.
File:03vxsrn.ex
Update:Wed Jun 5 12:21:10 1996