headlamp Mercury Villager 1997 Owner's Manuals

Instrumentation
17
%*
[IS06100(ALL)12/95]
Low Washer Fluid Light
[IS06200(ALL)01/96]
The low washer fluid light will remain illuminated when the
washer fluid sensor indicates that the washer fluid level is low.
[IS06300(ALL)01/96]
6 pica art:0040059-A
Low washer fluid light
%*
[IS06400(ALL)05/96]
High Beam Light
*
[IS06500(ALL)03/96]
This light illuminates when the headlamps are turned to high
beam or when you flash the lights.
[IS06600(ALL)01/96]
6 pica art:0040065-A
High beam light
%*
[IS06700(ALL)03/96]
ªHeadlamps Onº Alert Chime
[IS06800(ALL)01/96]
This chime will sound if you open the door while the
headlamps or parking lamps are on.
%*
[IS06820(ALL)01/96]
Ignition Key Chime
[IS06830(ALL)01/96]
The chime will sound if you open the driver's door while the
key is in the ignition. Never leave your vehicle unattended with
the key in the ignition.
File:03vxisn.ex
Update:Thu May 30 09:45:36 1996

56
[CF00600(ALL)01/96]
The controls for the climate control systems, headlamps, clock,
radio, rear window washer and wiper, hazard flasher, power
switch, and speed control are all on the instrument panel.
%*
[CF00700(ALL)01/96]
Climate Control Systems
[CF00800(ALL)03/96]
13-1/2 pica
art:0040301-B
Climate control system panel
[CF00900(ALL)01/96]
Function Selector Buttons
[CF00950(ALL)03/96]
There are six function selector buttons: OFF, Mix, Defrost, Panel,
Panel/Floor, and Floor. When you press a function selector
button, the indicator light on the button will illuminate. If your
vehicle is equipped with a rear passenger compartment climate
control system, the instrument panel will also include a rear seat
function selector.
[CF01000(ALL)01/96]
n
The OFF button shuts off the air supply to all outlets and
stops all fan operations. Use this setting when driving
through an area where outside air is unpleasant or dusty.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

76
[CF13500(ALL)01/96]
To activate the rear washer, press the RR WASH switch. For a
constant spray, hold the switch for a few seconds. For less
washer fluid, press the switch once and release it. When you
activate the washer, the wiper will cycle twice and then stop.
*
[CF13600(ALL)01/96]
Do not activate the washer for longer than fifteen seconds
continuously. This could damage the washer pump system.
%*
[CF13650(ALL)01/96]
Hazard Flasher Switch
[CF13655(ALL)03/96]
The hazard flasher switch is located on the instrument panel to
the right of the steering column. For more information, refer to
theRoadside Emergencieschapter.
[CF13700(ALL)01/96]
Interior and Exterior Lights
*
[CF13800(ALL)05/96]
To turn on the headlamps, parking lamps, marker lamps, tail
lamps, license plate lamps and instrument panel lamps, use the
headlamp knob, to the left of the instrument cluster.
*
[CF13900(ALL)05/96]1.
Turn the headlamp knob to the first position to turn on the
parking lamps, tail lamps, license plate lamps, marker lamps
and instrument panel lamps.
*
[CF13950(ALL)05/96]2.
Turn the headlamp knob to the second position to turn on
the headlamps in addition to the parking lamps, tail lamps,
license plate lamps, marker lamps and instrument panel
lamps.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
77
[CF14000(ALL)01/96]
13-1/2 pica art:0040074-E
The headlamp control knob
[CF14100(ALL)01/96]
A chime will sound if any of the exterior lamps are on when
the driver's door is opened.
%*
[CF14400(ALL)01/96]
Daytime Running Light (DRL) System
(Canadian vehicles only)
*
[CF14500(ALL)03/96]
The Daytime Running Light (DRL) system turns the high beam
headlamps on, with a reduced light output, when:
*
[CF14600(ALL)01/96]
n
the vehicle is ªrunningº
*
[CF14700(ALL)02/96]
n
the vehicle has a fully released parking brake
*
[CF14800(ALL)01/96]
n
the headlamp system is in the OFF position
*
[CF14900(ALL)01/96]
NOTE: You may notice that the lights flicker when the engine
is turned on or off. This is a normal condition.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

78
*
[CF15000(ALL)03/96]
RWARNING
The Daytime Running Light (DRL) system will not
illuminate the tail lamps and parking lamps. Turn on
your headlamps at dusk. Failure to do so may result in a
collision.
%*
[CF15100(ALL)01/96]
Lighting Up the Instrument Panel
[CF15200(ALL)01/96]
The instrument panel lights can be turned on by turning the
headlamp control knob to either the first or second position.
You can brighten or dim the instrument panel lights with the
DIM switch. The DIM switch is located near the headlamp
controls.
[CF15300(ALL)01/96]
Pushing and holding the right side of the switch will continue
to brighten the lights until the maximum brightness is reached.
Release the switch to maintain the desired brightness. The DIM
feature works similarly to dim the instrument panel lights when
the left side of the switch is pushed.
[CF15400(ALL)01/96]
7-1/2 pica art:0040076-B
The instrument panel brightness control
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
79
[CF15500(ALL)01/96]
Autolamp On/Off Delay System (If equipped)
*
[CF15600(ALL)01/96]
The autolamp sets the headlamps to turn on and off
automatically. You can use the autolamp to:
*
[CF15700(ALL)01/96]
n
turn on the headlamps automatically at night
*
[CF15800(ALL)01/96]
n
turn off the headlamps automatically during daylight
[CF15900(ALL)05/96]
n
keep the headlamps on for approximately three minutes after
you turn the key to OFF
*
[CF15950(ALL)01/96]
To set the autolamp:
[CF16000(ALL)01/96]1.
Make sure the headlamp control knob is in the OFF position.
If the knob for the headlamps is on, the autolamp system is
canceled.
[CF16100(ALL)05/96]2.
Turn the ignition key to start your vehicle.
[CF16200(ALL)01/96]3.
Use the autolamp thumbwheel to activate the autolamp
feature. It is located to the left of the instrument cluster. The
white mark indicates the approximate center of the
thumbwheel.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

80
[CF16300(ALL)01/96]
13-1/2 pica
art:0040077-B
Autolamp thumbwheel location
[CF16400(ALL)01/96]4.
Move the thumbwheel all the way to the right. The
autolamp will automatically turn the lamps on and off.
[CF16500(ALL)01/96]
NOTE: Be sure that you do not put anything on top of the
photodiode located in the top right side of the
instrument panel speaker grille. The photodiode
controls the autolamp; if it is covered, the photodiode
reacts as if it is nighttime, and the headlamps will be
illuminated.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
81
[CF16600(ALL)01/96]
13-1/2 pica
art:0040081-B
Autolamp photodiode location
[CF16700(ALL)01/96]
To turn the autolamp off, move the thumbwheel all the way to
the left.
[CF16800(ALL)01/96]
You can set the autolamp so the headlamps stay on for
approximately three minutes after you turn off your ignition.
The farther the thumbwheel is moved to the right, the longer
the headlamps stay on.
[CF16900(ALL)01/96]
The chime will sound when the autolamp system turns the
headlamps on and the driver's door is open.
[CF17000(ALL)04/96]
Interior Lamps
[CF17100(ALL)01/96]
The front dome lamp is located overhead between the driver
and front passenger seats. However, if your vehicle is equipped
with a power sunroof, the dome lamp is located behind the
driver's seat.
[CF17200(ALL)01/96]
The rear dome lamp is located overhead near the rear seating
positions.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
87
[CF19900(ALL)01/96]
START cranks the engine. Release the key once the engine starts
so that you don't damage the starter. The key should return to
the ON position when you release it.
*
[CF20000(ALL)01/96]
Turn Signal Lever
*
[CF20100(ALL)02/96]
You can use the turn signal lever on the left side of the steering
column to:
*
[CF20200(ALL)01/96]
n
operate the turn signals.
*
[CF20250(ALL)01/96]
n
turn the headlamps to high beam.
*
[CF20300(ALL)01/96]
n
flash the headlamps.
*
[CF20400(ALL)01/96]
n
turn the windshield wipers and washer on/off.
%*
[CF20500(ALL)01/96]
Turn Signals
*
[CF20600(ALL)01/96]
Move the lever up to signal a right turn. Move it down to
signal a left turn. The corresponding indicator light in the
instrument cluster will flash.
*
[CF20700(ALL)01/96]
7-1/2 pica art:0040085-D
The turn signal lever
*
[CF20800(ALL)01/96]
If the turn signal stays on after you turn, move the lever back
to the center (off) position.
*
[CF20900(ALL)01/96]
For lane changes, move the lever far enough to signal but not to
latch. The lever will return to the off position when you release
it.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

88
*
[CF21000(ALL)01/96]
If the turn indicator light in the instrument panel does not
illuminate or remains on (does not flash) when you signal a
turn, the turn signaling system is malfunctioning. Have this
condition corrected as soon as possible, and use the accepted
hand signals until the turn signal system is repaired.
[CF21100(ALL)01/96]
Cornering Lights
[CF21200(ALL)01/96]
Your vehicle is equipped with special cornering lights designed
to provide additional illumination toward the direction you are
turning. The corresponding light comes on when a turn is
signaled.
*
[CF21300(ALL)08/95]
High Beams and Flashing the Lamps
*
[CF21400(ALL)01/96]
To turn on the high beams, turn the headlamps on and push
the turn signal lever away from you until it latches. When the
high beams are on, the high beam indicator light on the
instrument panel is illuminated.
*
[CF21500(ALL)01/96]
To return to the low beam setting, pull the turn signal lever
toward you until it latches back into the neutral position. The
high beam indicator light turns off.
*
[CF21600(ALL)01/96]
7-1/2 pica art:0040086-D
High beam and flash-to-pass operation
*
[CF21700(ALL)01/96]
To flash the headlamps, pull the turn signal lever toward you
for a moment and then release it. The high beam headlamps
will flash whether the headlamps are on or off.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996