lights Mercury Villager 1998 s User Guide

Using the Panic Alarm
If you are near your vehicle and feel threatened, you may
activate the alarm to call attention to it.
To activate the PANIC alarm, push and hold the PANIC button
on the remote for longer than 1.5 seconds. The horn will sound and
the headlamps and tail lights will flash for thirty (30) seconds.
To turn off the alarm, press the LOCK or UNLOCK buttons or hold
the PANIC button down for longer than 1.5 seconds.
Replacing the Batteries
The remote entry transmitter is powered by two coin type Sanyo
CR2016 3 volt batteries (included). If you notice a significant
decrease in operating range, the batteries should be replaced.
Replacement batteries can be purchased at most pharmacies, watch
stores or at your Ford or Lincoln-Mercury dealer.
NOTE: The operating range of the remote entry system can
also be affected by weather conditions (such as very
cold temperatures) or structures around the vehicle
(buildings, other vehicles, radio and TV towers,
etc.). Typical operating range will allow you to be up to
49 feet (15 meters) away from your vehicle.
Replacing the batteries
11 4

ID Code Programming Procedure
NOTE: All transmitters must be programmed (or
reprogrammed) at the same time. If the programming
mode is entered and the transmitters are not programmed
(or reprogrammed) at the same time, they will not
operate with the system.
1. Enter vehicle and close and lock all doors.
2. Insert and remove key from ignition six times within ten (10)
seconds. The instrument panel lights will flash twice.
3. Turn ignition key to the ACC position.
4. Press the LOCK button on the remote transmitter once.
5. To enter additional remote controllers (including the original),
unlock, then lock the driver door using the power door lock
switch.
6. Press the LOCK button on a new remote transmitter. The
instrument panel lights will flash twice, indicating code is
entered.
7. Repeat steps 5 and 6 as needed (up to four remote transmitters
may be programmed).
Anti-Theft System (If equipped)
This system helps protect your vehicle against break-ins or theft
by monitoring all doors, the hood and the liftgate lock
cylinder.
When an unauthorized entry occurs, the system triggers and will:
mflash the headlamps and hazard lamps
mhonk the horn
mdisable the starting circuit to prevent the vehicle from being
started
11 6

To arm the system
1. Remove the key from the ignition.
2. Lock the doors by using either the power door lock switch or
by turning the key in either the driver or passenger door lock
cylinder. The parking lights will flash and the horn chirps
to let you know that the system has been armed. The anti-theft
indicator light on the right side of the steering wheel will
light and remain on.
NOTE: If your vehicle is equipped with a factory installed
remote keyless entry system, the system can be armed
by closing all the doors and pressing the LOCK
button on the remote transmitter.
3. Close all doors. The anti-theft indicator light will stay on for
approximately 30 seconds and then flash once every 2.5
seconds.
Anti-theft indicator light
Controls and Features
11 7

Disarming a triggered anti-theft system
The alarm can be disarmed by:
munlocking the driver or passenger doors
munlocking the doors with the remote keyless entry transmitter
(if equipped)
mputting the key in the ignition and turning it to the ACC
position
NOTE: The flashing lights and honking horn will shut off
automatically within 2 minutes 30 seconds after the
system is triggered. It will trigger again if another
intrusion occurs. However, the starter circuit remains
disabled until the system is disarmed.
NOTE: Factory installed remote keyless entry systems will only
operate with the ignition in the OFF position.
Controls and Features
11 9

Fuel-Injected Engines
When starting a fuel-injected engine,the most important thing to
remember is to avoid pressing down on the accelerator
before or during starting. Only use the accelerator when you
have problems getting your vehicle started. SeeStarting Your Engine
in this chapter for details about when to use the accelerator
while you start your vehicle.
Starting Your Vehicle
Preparing to Start Your Vehicle
WARNING
Do not start your vehicle in a closed garage or in other
enclosed areas. Exhaust fumes can be toxic. Always open the
garage door before you start the engine.
Before you start your vehicle, always:
1. Make sure you and all your passengers buckle your safety
belts. SeeSafety beltsin the Index for more details.
2. Make sure the headlamps and other accessories are turned off
when starting.
3. Make sure that the gearshift is in P (Park) and the parking
brake is set before you turn the key.
4. Observe the warning lights on the instrument cluster to make
sure they work. Refer to theInstrumentationchapter.
Starting Your Engine
To start your engine:
1. Follow the steps underPreparing to Start Your Vehicleat the
beginning of this section.
Starting
207

5. Check under the vehicle again for leaking fuel. If you see or
smell fuel, do not start your vehicle again. If there is no
fuel, you can try to start your vehicle again.
6. Check all vehicle warning lights before driving your vehicle.
Guarding Against Exhaust Fumes
Carbon monoxide, although colorless and odorless, is present in
exhaust fumes. Take precautions to avoid its dangerous
effects.
WARNING
Do not start your vehicle in a closed garage or in other
enclosed areas. Exhaust fumes can be toxic. Always open the
garage door before you start the engine.
WARNING
If you ever smell exhaust fumes of any kind inside your
vehicle, have your dealer inspect and fix your vehicle
immediately. Do not drive if you smell exhaust fumes.
These fumes are harmful and could kill you.
Have the exhaust and body ventilation systems checked by a
qualified technician whenever:
myour vehicle is raised for service
mthe sound of the exhaust system changes
myour vehicle has been damaged in an accident
Improve your ventilation by keeping all air intake vents clear of
snow, leaves, and other objects.
If the engine is idling while you are stopped in an open area for
long periods of time, open the windows at least one inch (2.5
cm). Also, adjust the heating or air conditioning system to bring
in outside air.
212

Jump-Starting Your Battery
Your vehicle's battery may discharge if you leave the lights or
any electrical equipment on after you turn the engine off. If this
happens, you may be able to jump-start from a booster
battery to start your vehicle.
WARNING
The gases around the battery can explode if exposed to
flames, sparks, or lit cigarettes. An explosion could result
in injury or vehicle damage.
WARNING
To protect yourself when charging a battery, always shield
your face and eyes. Make sure that you can breathe
fresh air.
WARNING
Applying too much pressure on the ends when lifting a
battery could cause acid to spill. Lift the battery with a
carrier or with your hands on the opposite corners.
WARNING
Batteries contain sulfuric acid which burns skin, eyes, and
clothing.
If the acid touches someone's skin, eyes, or clothing, immediately
flush the area with water for at least 15 minutes. If someone
swallows the acid, have him or her drink lots of milk or water
first, then Milk of Magnesia, a beaten egg, or vegetable oil. Call a
doctor immediately.
268

To avoid damaging your vehicle or your battery, and to avoid
injury to yourself, follow these directions for preparing your vehicle
to jump-start and connecting the jumper cables in the order
they are given. If in doubt, call for road service.
Preparing Your Vehicle
1. Your vehicle has a 12-volt starting system, so you need to use
a 12-volt jumper system. You will damage your starting
motor, ignition system, and other electrical parts if you connect
them to a 24-volt power supply (either two 12-volt batteries
in series or a 24-volt generator set).
2. Do not disconnect the battery of the disabled vehicle. You
could damage the vehicle's electrical system.
3. Park the booster vehicle close to the hood of the disabled
vehicle.Make sure the vehicles do not touch each other.Set the
parking brake on both vehicles and stay clear of the engine
cooling fan and other moving parts.
4. Check all battery terminals and remove any excessive
corrosion before you attach the jumper cables.
5. Turn on the heater blower in both vehicles. Turn off all other
switches and lights in both vehicles to prevent possible
damage to either vehicle's electrical systems.
Roadside Emergencies
269

7. Refill the engine with a CERTIFIED engine oil of the preferred
viscosity. Start the engine and check for leaks. Follow
directions inChecking and adding engine oilto be sure the
engine is filled to the proper level.
WARNING
Continuous contact with USED motor oil has caused
cancer in laboratory mice.
Protect your skin by washing with soap and water.
Brake Fluid
Your vehicle is equipped with a brake fluid level indicator in the
master cylinder which lights the BRAKE warning light on the
instrument panel when the brake fluid level is low.
Under normal circumstances, your vehicle should not use up
brake fluid rapidly. However, expect the level of the brake fluid
to slowly fall as you put more mileage on your vehicle and
the brake pads wear.
Check the brake fluid at least once a year. You can do this by
looking at the fluid level in the plastic brake fluid reservoir on the
master cylinder. The fluid level should be at or near the MAX
mark.
WARNING
Brake fluid is toxic.
If brake fluid contacts eyes, flush eyes with running water for 15
minutes. Get medical attention if irritation persists. If taken
internally, drink water and induce vomiting. Get medical attention
immediately.
282

Lights and Bulb Replacement
It is a good idea to check the operation of the following lights
frequently:
mheadlamps
mhigh-mount brakelamp
mtail lamps
mbrakelamps
mcornering lamps
mhazard flasher
mturn signals
mlicense plate lamps
The alignment of your headlamps should be checked if:
moncoming motorists frequently signal you to turn off your
vehicle's high beams when you do not have the high
beams on
mthe headlamps do not seem to give you enough light to see
clearly at night
mthe headlamp beams are not pointed slightly down and to the
right
Headlamp Bulb
The headlamps on your vehicle use replaceable bulbs. When the
lamp burns out, simply replace the bulb, rather than the
whole lamp.
316