window Mercury Villager 1998 s User Guide

Press this button to obtain maximum airflow to the windshield.
Adjust the temperature setting as required for defrosting. The
indicator light illuminates and the display window shows
the set temperature. When the outside temperature is about 50É F
(10É C) the air conditioning functions in order to dehumidify
the air to prevent window fogging.
Push this button to select airflow through the instrument panel
registers. The
indicator light illuminates and the display
window shows the set temperature. The ATC heats the air if the
selected temperature is warmer than the outside air coming
into the vehicle. However, the air is not cooled below the
temperature outside of the vehicle regardless of the temperature
setting unless the A/C button is pushed.
Push this button for air from the floor and instrument panel
registers at the same time. The
indicator light illuminates and
the display window shows the set temperature. The ATC heats
the air if the selected temperature is warmer than the outside air
coming into the vehicle. However, the air is not cooled below
the temperature outside of the vehicle regardless of the temperature
setting unless the A/C button is pushed.
Push this button to direct airflow to the floor. Theindicator light
illuminates and the display window shows the set temperature.
The ATC heats the air if the selected temperature is warmer than the
outside air coming into the vehicle. However, the air is not cooled
below the temperature outside of the vehicle regardless of the
temperature setting unless the A/C button is pushed.
72

Liftgate Window Features
Rear Window Defogger (If equipped)
The defogger for the rear liftgate window clears frost, fog, or thin
ice from both the inside and outside of the rear window. The
defogger operates with the ignition in the ON position.
If your vehicle is equipped with heated rearview mirrors, they
activate when the rear window defogger is switched on.
The control switch is located on the instrument panel to the right
of the steering column.
Before using the defogger, clear away any snow that is on the rear
window and outside rearview mirrors. With the engine
running, push the defroster button.
After approximately 10 minutes, the defroster will turn off. If the
window or mirrors are still not clear, turn the defroster on
again.
Rear window defogger switch location
Controls and Features
75

The defroster will turn off when the ignition key is turned to the
OFF or START position.
Never use sharp instruments or abrasive window cleaners to
clean the inside of your rear window. If you do, you may damage
the wires that are bonded to the inside of the rear window, and
cause damage to the rear window defogger.
Rear Wiper and Washer
The controls for the rear wiper and washer can also be found on
the instrument panel to the right of the instrument cluster.
The rear wiper and washer controls operate with the ignition in
the ACC and ON positions.
To turn on the rear wiper, press the RR WIPER switch. The
wiper will operate until it is turned off. The wiper will complete
one cycle every 10 to 15 seconds. To turn off the rear wiper,
press the RR WIPER switch a second time.
Rear wiper and washer switch locations
76

Automatic Door Lock
If your vehicle is equipped with the optional power door locks,
locking the driver door with the key or with the manual rocker
switch will also lock all other doors. However, when the driver
door is unlocked, with the key or with the manual rocker switch,
other doors remain locked. The optional keyless entry system
will also lock and unlock your doors.
Anti-Lockout
Your vehicle is equipped with an anti-lockout feature which
prevents the driver side door from being locked while the key is
in the ignition. To lock the driver side door, remove the key
from the ignition and then use either the manual rocker switch or
the door lock cylinder.
Accessory Delay (If equipped)
Accessory Delay is a feature that allows vehicles equipped with
power windows and the power sunroof to operate all power
windows and the power sunroof for 15 minutes after the ignition
is turned to OFF or until the driver or front passenger door is
opened (after ignition is turned to OFF).
Sliding Door
The sliding door allows rear seat passengers to enter and exit
easily.
To lock the sliding door, push the right side of the rocker switch.
To unlock the sliding door, push the left side of the rocker
switch.
To open the sliding door from inside or outside of the vehicle,
pull the handle toward the rear of the vehicle. The door will stay
open if you slide it all the way back until the catch at the
bottom of the door engages.
98

NOTE: If the sliding door is open when all doors are locked with
the power door lock switch, the sliding door
automatically locks when it is closed.
You can manually lock and unlock the doors using the manual
door locks to override the power locks.
Liftgate
Opening the Liftgate
To unlock the liftgate with the key, insert the key into the lock
and turn it counterclockwise. To make the gate swing up to the fully
opened position, pull back and upward on the handle. The
liftgate will not unlock if the optional liftgate window is open.
You can also unlock the liftgate using the optional power door
lock system, or the optional keyless entry system. However, it
cannot be opened until you release the latch by reaching
under the license plate light shield and lifting up on the handle.
The power door lock switch
102

Opening the Liftgate Window (If equipped)
To open the liftgate window only, turn the key clockwise. The
window unlatches and the rear wiper falls out of the way. Do not
force the wiper down by hand Ð it moves when the key is
turned. To close, push downward until it latches.
Opening the liftgate
Controls and Features
103

WARNING
Make sure that the liftgate door and/or window are closed
to prevent exhaust fumes from being drawn into the
vehicle. This will also prevent passengers and cargo from
falling out. If you must drive with the liftgate door or
window open, keep the vents open so outside air comes into
the vehicle.
Closing the Liftgate
To close the liftgate, reach up and pull the handle on the inner
trim panel downward.
When you have pulled down the liftgate enough so that you can
reach the license plate light shield, push the shield down and
forward to close the liftgate. At this point, the liftgate is not locked.
The liftgate window in the open position
104

You can lock the liftgate by pushing in the lock lever before you
begin to close the liftgate. You can also lock the liftgate by
closing the liftgate, inserting your key and turning it clockwise
until you hear the lock lever engage. If you turn it too far, the
optional liftgate window will open. The liftgate can also be
locked with the optional power door locks.
The liftgate area is intended only for cargo, not passengers. It
cannot be opened from inside the vehicle.
After the lock lever is depressed, the liftgate must be unlocked
with the power door lock button or the key.
NOTE: The lock lever will be on the right side of the lock
cylinder if your vehicle is equipped with the standard
liftgate glass. The lock lever will be on the left side
of the lock cylinder if your vehicle is equipped with the
optional flip-up liftgate window.
Windows
Power Windows (If equipped)
Each of the front doors has a power control that opens and closes
the window on that door. The driver door has master controls
that operate both front door windows. You must place the ignition
in the ON position to use your power window controls. The
driver's power window controls include a lockout button which
prevents the operation of the passenger side window from
either the passenger or driver side controls.
To open the window, press down on the switch; to close the
window, lift up on the switch.
WARNING
Do not let children play with the power windows.
106

One-Touch-Down Power Window (Included with
optional power windows -- driver side only)
The one-touch-down power window feature allows you to
completely open the driver's window without holding down the
window switch. To open the window completely, press the
switch down for about one second, then release it. If the switch is
momentarily lifted while the window is going down, the
window will stop at that position.
To close the window you must lift and hold the switch until the
window closes.
Manual Flip-Open Quarter Windows
To open the flip-open quarter windows in the second or third
row, pull the rear portion of the latch toward you. Swing the latch
forward and out, then lock it into the open position by pushing
rearward until you hear a click. To close the windows, reverse the
procedure.
Driver's side power window controls
Controls and Features
107

NOTE: Optional third-row power windows must be opened with
the overhead console controls.
Power Quarter Windows (If equipped)
The power quarter windows operate with the ignition in the ON
position. The power-operated quarter windows in the third
seat position are controlled by the RIGHT VENT and LEFT VENT
switches on the overhead console. Press the indented side of
the switch to open the windows; press the raised side of the switch
to close the windows.
Manual flip-open quarter window latch location
108