warning light Mercury Villager 1998 s Owner's Guide

7. Refill the engine with a CERTIFIED engine oil of the preferred
viscosity. Start the engine and check for leaks. Follow
directions inChecking and adding engine oilto be sure the
engine is filled to the proper level.
WARNING
Continuous contact with USED motor oil has caused
cancer in laboratory mice.
Protect your skin by washing with soap and water.
Brake Fluid
Your vehicle is equipped with a brake fluid level indicator in the
master cylinder which lights the BRAKE warning light on the
instrument panel when the brake fluid level is low.
Under normal circumstances, your vehicle should not use up
brake fluid rapidly. However, expect the level of the brake fluid
to slowly fall as you put more mileage on your vehicle and
the brake pads wear.
Check the brake fluid at least once a year. You can do this by
looking at the fluid level in the plastic brake fluid reservoir on the
master cylinder. The fluid level should be at or near the MAX
mark.
WARNING
Brake fluid is toxic.
If brake fluid contacts eyes, flush eyes with running water for 15
minutes. Get medical attention if irritation persists. If taken
internally, drink water and induce vomiting. Get medical attention
immediately.
282

Windshield Washer Fluid
Check the level of the windshield washer fluid every time you
stop for fuel, or when the warning light indicates low washer fluid.
The reservoir for washer fluid is located in the engine
compartment. This reservoir contains the fluid for both the
windshield and liftgate washers.
WARNING
Do not put windshield washer fluid in the container for
the engine coolant.
If sprayed to clean the glass, engine coolant or antifreeze could
make it difficult to see through the windshield.
Windshield washer fluid reservoir
284

mDrive slowly. If you can hear the cables rub or bang against
your vehicle, stop the vehicle and tighten the cables. If you
continue to hear the cables rub or bang against your vehicle,
remove the cables to prevent damage to your vehicle.
mAvoid fully loading your vehicle if possible.
mRemove tire cables at the first opportunity after using them on
snow and ice. Do not use the cables on dry roads.
Make sure your suspension insulators and bumpers are not
missing or worn to avoid damage to your vehicle.
Filling the Fuel Tank
Removing the tethered fuel filler cap
1. Open the fuel door on the driver's side of the vehicle.
2. Slowly unscrew the cap counterclockwise, using caution to
minimize the possibility of fuel spraying.
If the Service Engine Soon warning light comes on and stays
on when you start the engine, the fuel cap may not be properly
seated. Turn off the engine, remove the fuel cap and replace it, being
careful to align the cap properly.
The tethered fuel filler cap
306

If you lose the fuel filler cap, replace it with an authorized
Motorcraft or equivalent part.
WARNING
If you do not use the proper fuel cap, the pressure in the
fuel tank can damage the fuel system or cause it to
work improperly in a collision.
WARNING
The fuel system may be under pressure. If the fuel cap is
venting vapor or if you hear a hissing sound, wait
until it stops before completely removing the cap.
NOTE: If you replace your fuel filler cap with an aftermarket
fuel filler cap, the customer warranty may be void for
any damage to the fuel tank and/or fuel system.
A venting fuel tank is not an abnormal condition. It may be
caused by:
mtoo volatile a fuel for the weather conditions. Service stations
sometimes sell winter grade fuel in the summer.
mpulling a heavy load on hot days, or at high altitudes.
mextended periods of idling with the engine RPM increased
above the normal idle range.
mparking the vehicle in full sunlight for extended periods on
extremely hot days.
WARNING
Do not overfill the fuel tank. The pressure in an
overfilled tank may cause leakage and lead to fuel spray
and fire.
Maintenance and Care
307

WARNING
Do not park, idle, or drive your vehicle in dry grass or
other dry ground cover. The emission system heats up the
engine compartment and exhaust system, which can
start a fire.
WARNING
Do not remove the floor carpet in your vehicle. Emission
controls cause high exhaust temperatures under the
floor.
Watch for fluid leaks, strange odors, smoke and loss of oil
pressure. Also watch for the charge warning light, the check engine
light, or the temperature warning light. These sometimes
indicate that the emission system is not working properly.
Do not make any unauthorized changes to your vehicle or engine.
Changes that cause more unburned fuel to reach the exhaust
system can increase the temperature of the engine or exhaust
system.
In general, maintenance, replacement, or service of the emission
control devices or systems in your new Ford Motor
Company vehicle or engine may be performed at your expense
by any automotive repair establishment or individual using
automotive parts equivalent to those with which your vehicle or
engine was originally equipped.
By law, anyone who manufactures, repairs, services, sells, leases
vehicles, trades vehicles, or supervises a fleet of vehicles is
not permitted to intentionally remove an emission control device
or prevent it from working. In some of the United States and
in Canada, vehicle owners may be liable if their emission control
device is removed or is prevented from working.
314

Do not drive your vehicle if it does not operate properly. See
your dealer if the engine runs on for more than five seconds after
you shut it off or if it misfires, surges, stalls, or backfires.
Information about your vehicle's emissions control system is on
the Vehicle Emission Control Information decal located on or
near the engine. This decal identifies engine displacement and gives
some tune-up specifications.
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
In some localities it may be a legal requirement to pass an I/M
test of the on-board diagnostic (OBD-II) system. If your``Service
Engine Soon''light is on, reference the applicable light
description in the Warning Light and Gauges section of your
owners guide. Your vehicle may not pass the I/M test with the
``Service Engine Soon''light on.
If the vehicles powertrain system or battery has just been
serviced, the OBD-II system is reset to a ``not ready for I/M test''
condition. To ready the OBD-II system for I/M testing, a
minimum of 30 minutes of city and highway driving is necessary
as described below:
mFirst, at least ten minutes of driving on an expressway or
highway.
mNext, at least twenty minutes of driving in stop-and-go,
city-type driving with at least four idle periods.
Allow the vehicle to sit for at least 8 hours without starting the
engine. Then, start the engine and complete the above driving cycle.
The engine must warm up to it's normal operating
temperature. Once started, do not turn off the engine until the
above driving cycle is complete.
Maintenance and Care
315

Automatic transmission
driving an automatic overdrive..............223
fluid, adding.......................291
B
Backing up.........................222
Battery
acid, treating emergencies............268, 294, 295
charging system warning light..............14
disconnecting......................272
proper disposal, recycling................294
voltage gauge.......................14
when storing your vehicle................335
Brake fluid.........................282
brake warning light....................9
checking and adding...................282
description........................282
specifications....................283, 339
Brakes...........................215
adjustment........................215
anti-lock.........................215
applying the brakes...................218
brake warning light....................9
fluid, checking and adding................282
fluid, refill capacities...................282
fluid, specifications.................283, 339
front disc........................215
if brakes do not grip well..............217, 218
lubricant specifications..................339
master cylinder.....................282
new brake linings.....................5
noise........................215, 217
parking.........................218
power braking......................215
374

servicing......................217, 282
stopping distances....................218
trailer..........................235
when storing your vehicle................335
Brights (high beams).....................17
Bulbs, replacing.......................316
halogen.........................316
headlamps........................316
specifications.......................322
C
Canada, customer assistance................352
Canadian Motor Vehicle Arbitration Plan (CAMVAP)....352
Car seats for children (see Child safety seats)........153
Carbon monoxide in exhaust................212
Cargonet ..........................111
Catalytic converter.....................313
Chains, tires........................305
Changing a tire.......................254
Charging system warning light................14
Child safety restraints....................151
child safety belts.....................166
child safety seats.....................153
Child safety seats......................153
and air bags.......................153
attaching with tether straps...............160
automatic locking mode (retractor)..........136, 153
in front seat.......................153
in rear outboard seat...................153
in rear seat........................153
tether anchorage hardware................160
Childproof locks......................100
Index
375

Controls
mirrors..........................109
Convenience kit in cargo area................255
Coolant (see Engine coolant)................285
checking and adding...................285
drain and flush.....................289
preparing for storage...................335
specifications.......................339
temperature gauge...................18,23
warnings.........................285
Cooling fan.........................276
Customer Assistance Centre, Ford of Canada........352
D
Daytime running light system................78
Defrost
rear window.......................75
windshield........................56
Dipstick..........................281
automatic transaxle fluid.................291
engine oil........................281
power steering fluid.................289, 289
Disabled vehicle (see Towing)................272
Dispute Settlement Board..................348
Doors............................97
door ajar warning light..................15
lubricant specifications..................339
Driving under special conditions
heavy load........................226
towing a trailer.....................227
Index
377

E
Electrical system
circuit breakers......................252
fuses........................243, 244
relays..........................253
Electronic sound system
antenna..........................84
atenna..........................84
tuning the radio......................33
warranty and service information.............51
Emergencies, roadside
assistance........................345
battery acid spills..................268, 295
fuel...........................310
towing..........................272
Emergency brake (parking brake)..............218
Emission control system..................313
catalytic converter....................313
emissions warranty.................313, 314
Engine
check engine warning light................12
does not start....................209, 210
fuel injected engine, starting...............207
fuel pump shut-off switch................210
preparing to start..................207, 207
service points......................341
starting.........................207
starting after a collision.................242
storing your vehicle.................333, 334
Engine block heater.....................210
Engine coolant.......................285
checking and adding...................285
disposal.........................292
drain and flush.....................289
378