warning light Mercury Villager 1998 s Owner's Guide

NOTE: Your vehicle has an interlock that prevents you from
shifting out of P (Park) unless your foot is on the brake
pedal.
If the engine does not start after two attempts:
1. Turn the ignition key to the OFF position.
2. Press the accelerator all the way to the floor and hold it.
3. Turn the ignition key to the START position.
4. Release the ignition key when the engine starts.
5. Release the accelerator gradually as the engine speeds up.
If the engine still does not start, the fuel pump shut-off switch may
have been activated. For directions on how to reset the switch
seeFuel Pump Shut-Off Switchin the index.
A computer system controls the engine's idle speed. When you
start your vehicle, the engine's idle speed normally runs high.
These faster engine speeds will make your vehicle coast
slightly faster than its normal idle speed. It should, however,
slow down after a short time. If it does not, have the idle speed
checked.
If the engine idle speed does not slow down automatically, do
not allow your vehicle to idle for more than 10 minutes. Have the
vehicle checked.
WARNING
Extended idling at high engine speeds can produce very
high temperatures in the engine and exhaust system,
creating the risk of fire or other damage.
Starting
209

5. Check under the vehicle again for leaking fuel. If you see or
smell fuel, do not start your vehicle again. If there is no
fuel, you can try to start your vehicle again.
6. Check all vehicle warning lights before driving your vehicle.
Guarding Against Exhaust Fumes
Carbon monoxide, although colorless and odorless, is present in
exhaust fumes. Take precautions to avoid its dangerous
effects.
WARNING
Do not start your vehicle in a closed garage or in other
enclosed areas. Exhaust fumes can be toxic. Always open the
garage door before you start the engine.
WARNING
If you ever smell exhaust fumes of any kind inside your
vehicle, have your dealer inspect and fix your vehicle
immediately. Do not drive if you smell exhaust fumes.
These fumes are harmful and could kill you.
Have the exhaust and body ventilation systems checked by a
qualified technician whenever:
myour vehicle is raised for service
mthe sound of the exhaust system changes
myour vehicle has been damaged in an accident
Improve your ventilation by keeping all air intake vents clear of
snow, leaves, and other objects.
If the engine is idling while you are stopped in an open area for
long periods of time, open the windows at least one inch (2.5
cm). Also, adjust the heating or air conditioning system to bring
in outside air.
212

During ABS activation, a mechanical noise may be heard as the
ABS cycles. This is normal ABS operation.
Anti-lock brake system (ABS)
On vehicles equipped with an anti-lock braking system (ABS), a
noise from the hydraulic pump motor and pulsation in the
pedal may be observed during ABS braking events. Pedal pulsation
coupled with noise while braking under panic conditions or on
loose gravel, bumps, wet or snowy roads is normal and indicates
proper functioning of the vehicle's anti-lock brake system. If
the vehicle has continuous vibration or shudder while braking,
felt mainly in the steering wheel, the vehicle most likely needs
service.
The ABS system has self-check capabilities. The system turns on
the ABS warning light each time you start the engine. After
the engine is started and the ABS warning light turns off, the system
performs another test the first time the vehicle reaches 4 mph
(6 km/h). A mechanical noise may be heard as the ABS system
performs a self test. This is a normal part of the self test
feature. If a malfunction is found during this check, the ABS
warning light will come on.
You should always be careful when braking, even if your vehicle
has the ABS system. Heavy braking on roads with loose
surfaces such as snow or gravel, or roads with severe pavement
irregularities could also cause you to lose control of your
vehicle.
WARNING
If the anti-lock brake system warning light remains on or
comes on while driving, have the braking system
checked by a qualified service technician as soon as
possible.
216

NOTE: If a fault occurs in the anti-lock system, and the brake
warning light is not lit, the anti-lock system is disabled
but normal brake function remains operational.
Ford Motor Company has not found any negative effects of
mobile radio transmitting equipment installed on vehicles with
the ABS providing that the radio is installed according to the radio
manufacturer's instructions. However, if you have had a
mobile radio transmitter installed and the check ABS light comes
on (at any time other than immediately after turning the key
to the ON position) have your mobile radio dealer inspect the
installation. Also, if the ABS system is activated other than during
maximum braking, have your mobile radio installation
checked.
If Brakes Do Not Grip Well or Pedal is ``Low''
If the brake pedal seems ªlowº it may indicate the need for a
brake system inspection and/or service. Apply your parking brake
several times. If the condition has not improved, you should
have your brakes checked as soon as possible.
Occasional brake squeal during light to moderate stops does not
affect the function of the brake system and is normal.
However, if the squeal becomes very loud or if it becomes more
frequent, return the vehicle to your dealer for inspection.
WARNING
Modifications to the suspension spring rates and/or
vehicle ride height may adversely affect vehicle stopping
ability.
Driving
217

WARNING
When parking, do not use the gearshift in place of the
parking brake. Always set the parking brake fully and make
sure that the gearshift is securely latched in Park (P).
Turn off the ignition whenever you leave your vehicle.
Never leave your vehicle unattended while it is running. If
you do not take these precautions, your vehicle may
move unexpectedly and injure someone.
To release the parking brake, press the brake pedal with your
right foot and hold it while you lift up on the parking brake release
handle.
WARNING
If the parking brake is fully released, but the Brake
System light remains on, have the brakes checked
immediately. They may not be working properly.
The parking brake
Driving
219

N (Neutral)
In N (Neutral), the transaxle is not locked. Your vehicle will roll
freely, even on the slightest incline, unless the parking brake
or brakes are on.
Parking
Always come to a complete stop before you shift into P (Park).
This position locks the transaxle and prevents the front wheels from
turning. To securely latch the gearshift in the P (Park) position,
pull it toward you, push it completely counterclockwise against the
stop, and then push it toward the instrument panel.
The gearshift is securely latched in Park (P) if you cannot rotate
it in a clockwise direction without lifting it toward you.
WARNING
Always set the parking brake fully and make sure the
gearshift is latched in P (Park). Turn off the ignition
whenever you leave your vehicle.
WARNING
Never leave your vehicle unattended while it is running.
Forced Downshifts
To gain extra acceleration in Drive (D) (when passing another
vehicle) push the accelerator to the floor. The transaxle will
automatically downshift to the appropriate gear - third,
second or first.
Driving
225

Driving Through Water
Do not drive quickly through standing water, especially if the
depth is unknown. Traction or brake capability may be limited and
if the ignition system gets wet, your engine may stall. Water
may also enter your engine's air intake and cause severe damage
to your engine.
If driving through deep or standing water is unavoidable,
proceed very slowly. Never drive through water that is higher
than the bottom of wheel rims.
Once through the water, always try the brakes. Wet brakes do not
stop the vehicle as effectively as dry brakes. Drying can be
improved by moving your vehicle slowly while applying light
pressure on the brake pedal.
Driving With a Heavy Load
The Safety Compliance Certification Label, located on the driver's
door pillar, provides important information regarding the
weight limits your vehicle can safely carry or tow. The total
weight of your vehicle, including the weight of the passengers
and cargo, should never be more than the Gross Vehicle Weight
Rating (GVWR). Also, the weight that your vehicle carries on
the front axle and rear axle should never be more than the Gross
Axle Weight Rating (GAWR) for the respective axle.
The load capacities of your vehicle's tires affect the GVWR or
GAWR limitations. Using replacement tires with a higher weight
limit than the originals does not increase GVWR or GAWR.
Using lower capacity replacement tires may lower GVWR and
GAWR limitations.
WARNING
Do not exceed the GVWR or the GAWR specified on the
Safety Compliance Certification Label.
226

Trailer Brakes
Separate trailer brakes are required on most trailers weighing
over 1,500 lbs. (680 kg).
WARNING
Do not connect a trailer's hydraulic brake system directly
to your vehicle's brake system. Your vehicle may not
have enough braking power and your chances of having a
collision greatly increase.
Trailer Lamps
Make sure your trailer lamps conform to federal and local
regulations.
Class I Trailer Tow electrical wiring provides two circuits (right
hand and left hand) to operate trailer stop/turn tail lamps. Each
stop/turn circuit will operate one combination stop/turn light
bulb (# 1157, 3157, 2357, or 3357) on the trailer. Never add more than
one trailer light bulb to one circuit.
WARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage rating
can cause severe wire damage and could start a fire.
Driving
235

WARNING
Never use wheels or lug nuts different than the original
equipment as this could damage the wheel or mounting
system. This damage could allow the wheels to come
off while the vehicle is being driven.
13. Replace the wheel cover by pressing it into place. If you have
the standard wheel covers, you must align the notch in the
wheel cover with the tire's valve stem and align the recess in the
back of the wheel cover with one of the lug nuts. If you
have the optional aluminum wheel, press the center wheel
cap into place after matching up the design of the wheel cap
to the wheel.
14. Make sure the jack is securely fastened. When you replace
the jack in the jack storage compartment, place the base
against the square-shaped fastening bracket and open the jack
slightly so that the jack is snug against the fastening
brackets.
15. Store the flat tire under the vehicle just as you would store
the spare tire. Refer to the section onStowing the Spare Tire
in this chapter.
266

Jump-Starting Your Battery
Your vehicle's battery may discharge if you leave the lights or
any electrical equipment on after you turn the engine off. If this
happens, you may be able to jump-start from a booster
battery to start your vehicle.
WARNING
The gases around the battery can explode if exposed to
flames, sparks, or lit cigarettes. An explosion could result
in injury or vehicle damage.
WARNING
To protect yourself when charging a battery, always shield
your face and eyes. Make sure that you can breathe
fresh air.
WARNING
Applying too much pressure on the ends when lifting a
battery could cause acid to spill. Lift the battery with a
carrier or with your hands on the opposite corners.
WARNING
Batteries contain sulfuric acid which burns skin, eyes, and
clothing.
If the acid touches someone's skin, eyes, or clothing, immediately
flush the area with water for at least 15 minutes. If someone
swallows the acid, have him or her drink lots of milk or water
first, then Milk of Magnesia, a beaten egg, or vegetable oil. Call a
doctor immediately.
268