remote control Mercury Villager 1998 Owner's Manuals

If the vehicle doors are not fully closed and the interior lamps
remain illuminated, they will eventually turn off automatically to
prevent the battery from becoming discharged. Lamps that
illuminate when the front doors and the sliding door are open
will turn off after approximately 30 minutes. Lamps that are
illuminated when the liftgate is open will turn off after
approximately 60 minutes.
Illuminated Entry System (If equipped)
If your vehicle is equipped with this option, the interior courtesy
lamps (footwell, stepwell, and dome lamps) will light when
either of the front doors or the sliding door is open. If you have
the optional Keyless Entry System the lamps will also light
whenever the remote keyless entry transmitter button is pressed.
There are stepwell lamps located near the sliding door
entrance and one on each front door. The footwell lamps are
located below the instrument panel near the driver 's and front
passenger 's feet. When the liftgate is opened, the optional liftgate
lamp, rear dome lamp and sliding door stepwell lamp will
illuminate.
The lamps that have the delay feature will automatically dim
until they turn completely off approximately 15 seconds after the
doors are closed. When the key is placed in the ignition and
turned to the ON position, the lamps will turn off.
Controls and Features
83

Dual Electric Remote Controlled Mirrors (If equipped)
If you have power side view mirrors, you can adjust them in any
direction by using the mirror controls on the instrument panel.
This switch operates with the ignition in ON or ACC.
The mirror control switch is on the instrument panel to the left of
the steering wheel.
To adjust the remote controlled side mirrors:
1. Select the right or left mirror by moving the selector switch to
RorL.
2. Move the control knob in the direction you want to move the
mirror.
3. Return the selector switch to the middle position to keep the
mirror in place.
11 0

Heated mirror feature (If equipped)
Both power mirrors are heated whenever the rear window
defroster is turned on. Do not remove ice from the mirrors with a
scraper or you could damage them.
Cargo Net (If equipped)
The cargo net is designed to hold your cargo upright between the
third row bench seat and the liftgate to prevent it from moving
around the cargo area.
To install the cargo net:
Attach the loops on the four corners of the net to the four
retainers on the cargo area rear quarter panels. Pull on the net to
be sure that it is fastened securely.
Dual electric remote controlled mirrors switch
Controls and Features
111

Remote Keyless Entry System (If equipped)
If you have chosen the remote keyless entry system option for
your vehicle, you can lock or unlock the doors and liftgate without
using a key. This option will allow you to open your vehicle
using a remote transmitter from distances of up to 49 feet (15
meters) away. The remote feature will operate only when the
ignition is in the OFF position.
The transmitter can unlock the driver's door, unlock all doors,
lock all doors, and activate the vehicle's anti-theft system (if
equipped). It is designed to be carried with your vehicle key.
By pressing the UNLOCK button on the transmitter once, you can
unlock the driver door. Pressing the UNLOCK button a second
time within six (6) seconds of unlocking the driver door will unlock
the other doors. The interior lamp will turn on and stay on for
thirty (30) seconds.
By pressing the LOCK button on the transmitter once, all the
doors will lock, the parking lamps flash twice and the horn chirps.
When the LOCK button is pushed with all the doors locked,
the parking lamps flash twice and the horn chirps to confirm that
the doors are already locked.
Remote keyless entry transmitter
Controls and Features
11 3

Remove the two batteries by snapping open the lid of the remote
transmitter. The transmitter can be snapped apart by twisting
a thin coin between the two halves of the transmitter. Replace the
batteries with new ones as shown in the above illustration.
Close the lid securely. Press both the LOCK and the UNLOCK
button two or three times to test the remote transmitter operation.
If the batteries are removed for any reason other than
replacement, repeat the steps inReplacing the batteriesto test your
remote transmitter(s).
mAn improperly disposed battery can hurt the environment.
Always confirm local regulations for battery disposal.
mThe remote transmitter is waterproof; however, if it does get
wet, immediately wipe it completely dry.
mThe operational range of the remote transmitter extends to
approximately 49 feet (15 meters) from the vehicle. This
range may vary with conditions.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
Replacement/Additional Transmitters
In the event a transmitter is lost or an additional remote
transmitter needs to be set, you must change the ID code. Follow
the steps below to change the ID code of your system, or
return the remaining transmitter(s) to your dealer for
reprogramming of your remote entry system. This is necessary to
prevent unauthorized use of the lost transmitter.
Controls and Features
11 5

ID Code Programming Procedure
NOTE: All transmitters must be programmed (or
reprogrammed) at the same time. If the programming
mode is entered and the transmitters are not programmed
(or reprogrammed) at the same time, they will not
operate with the system.
1. Enter vehicle and close and lock all doors.
2. Insert and remove key from ignition six times within ten (10)
seconds. The instrument panel lights will flash twice.
3. Turn ignition key to the ACC position.
4. Press the LOCK button on the remote transmitter once.
5. To enter additional remote controllers (including the original),
unlock, then lock the driver door using the power door lock
switch.
6. Press the LOCK button on a new remote transmitter. The
instrument panel lights will flash twice, indicating code is
entered.
7. Repeat steps 5 and 6 as needed (up to four remote transmitters
may be programmed).
Anti-Theft System (If equipped)
This system helps protect your vehicle against break-ins or theft
by monitoring all doors, the hood and the liftgate lock
cylinder.
When an unauthorized entry occurs, the system triggers and will:
mflash the headlamps and hazard lamps
mhonk the horn
mdisable the starting circuit to prevent the vehicle from being
started
11 6

To arm the system
1. Remove the key from the ignition.
2. Lock the doors by using either the power door lock switch or
by turning the key in either the driver or passenger door lock
cylinder. The parking lights will flash and the horn chirps
to let you know that the system has been armed. The anti-theft
indicator light on the right side of the steering wheel will
light and remain on.
NOTE: If your vehicle is equipped with a factory installed
remote keyless entry system, the system can be armed
by closing all the doors and pressing the LOCK
button on the remote transmitter.
3. Close all doors. The anti-theft indicator light will stay on for
approximately 30 seconds and then flash once every 2.5
seconds.
Anti-theft indicator light
Controls and Features
11 7

Disarming a triggered anti-theft system
The alarm can be disarmed by:
munlocking the driver or passenger doors
munlocking the doors with the remote keyless entry transmitter
(if equipped)
mputting the key in the ignition and turning it to the ACC
position
NOTE: The flashing lights and honking horn will shut off
automatically within 2 minutes 30 seconds after the
system is triggered. It will trigger again if another
intrusion occurs. However, the starter circuit remains
disabled until the system is disarmed.
NOTE: Factory installed remote keyless entry systems will only
operate with the ignition in the OFF position.
Controls and Features
11 9

Mileage, calculating fuel economy..............311
Mirrors...........................109
automatic dimming rearview mirror...........100
dual electric remote control................110
rearview.........................109
side view mirrors....................109
side view mirrors (manual)................109
side view mirrors (power)................110
Motorcraft parts......................337
O
Octane rating.....................308, 309
Odometer..........................20
description........................20
trip odometer.......................20
Oil filter..........................281
Oil (see Engine oil).....................279
Oil viscosity........................279
Overdrive..........................223
Overseas offices.......................353
P
Parking brake
operation........................218
warning light........................9
Parts (see Motorcraft Parts).................337
PCV valve, specifications..................337
Power door locks......................101
Power features
door locks........................101
mirrors.......................109, 110
windows.........................106
Power steering
dipstick.........................289
Index
385