tire size MINI Coupe 2014 User Guide

▷If a warning triangle or portable hazard
warning lamp is required, set it up on the
roadside at an appropriate distance from
the rear of the vehicle. Comply with all
safety guidelines and regulations. ◀
The procedure to correct a flat tire depends on
the equipment in the vehicle:
▷Run-flat tires, refer to page 164.▷MINI Mobility System, refer to page 165.▷Wheel change with a compact wheel, refer
to page 181.
MINI Mobility System
Notes
▷Follow the instructions on using the Mobi‐
lity System found on the compressor and
sealant bottle.▷Use of the Mobility System may be ineffec‐
tive if tire damage is greater than approx.
1/8 in/4 mm in size.▷Contact the nearest service center if the tire
cannot be made drivable.▷If possible, do not remove foreign bodies
that have penetrated the tire.▷Pull the speed limit sticker off the sealant
bottle and apply it to the steering wheel.
Sealant and compressor
1Sealant bottle and speed limit sticker2Filling hose
Note the use-by date on the sealant bottle.3Holder for the sealant bottle4Compressor5Connector and cable for the lighter socket/
socket in passenger compartment   102.6Connection hose for connecting the com‐
pressor and sealant bottle or the compres‐
sor and wheel7On/off switch8Pressure gauge for displaying the tire infla‐
tion pressure9Release button for reducing the tire infla‐
tion pressure
The connector, cable, and connecting hose are
stowed in the compressor housing.
Using the Mobility System
To repair a flat tire with the Mobility System,
proceed as follows:
▷Filling the tire with sealant▷Distributing the sealant▷Correcting the tire inflation pressure
Filling the tire with sealant
Adhere to the specified sequence
Adhere to the specified sequence of the
steps; otherwise, sealant may escape under
high pressure. ◀
1.Shake the sealant bottle.2.Pull the connection hose 6 fully out of the
compressor housing and screw it onto the
sealant bottle connection. Ensure that the
connection hose is not kinked.Seite 165Wheels and tiresMobility165
Online Edition for Part no. 01 40 2 911 475 - VI/13

Do not allow the compressor to run too
long
Do not allow the compressor to run longer than
10 minutes; otherwise, the device will overheat
and may be damaged. ◀
If the inflation pressure is not maintained, take
the vehicle on another drive, distributing the
sealant, refer to page 166. Then repeat steps
1 to 4 once.
If the inflation pressure of 1.8 bar/26 psi is still
not reached, the tire is too heavily damaged.
Contact the nearest service center.
Continuing the trip Note the maximum speed
Do not exceed the maximum speed of
50 mph/80 km/h; otherwise, accidents can oc‐
cur. ◀
Replace the defective tire as soon as possible
and have the wheel balanced.
Have the Mobility System refilled.
Snow chains
Only certain fine-link snow chains have been
tested by MINI, classified as safe for use, and
recommended. Consult your service center for more information.
Use only in pairs on the front wheels, equipped
with tires of the following size:▷175/65 R 15 M+S▷175/60 R 16 M+S
John Cooper Works:
▷185/50 R 17 86 H M+S XL RSC
Observe the manufacturer's instructions when
mounting snow chains. Do not exceed a speed
of 30 mph or 50 km/h when using snow chains.
Do not initialize the Flat Tire Monitor if snow
chains are mounted; otherwise, the instrument
might issue an incorrect reading. When driving
with snow chains, it may be useful to tempora‐
rily deactivate DSC or activate DTC, refer to
page 89.Seite 167Wheels and tiresMobility167
Online Edition for Part no. 01 40 2 911 475 - VI/13

driving characteristics could result, for example
reduced track stability on braking, extended
braking distance, and altered self-steering
characteristics in the limit range. In conjunction
with winter tires, these characteristics are more
pronounced. ◀
Only mount one compact wheel
Only one compact wheel may be
mounted. Restore the wheels and tires to their
original size as quickly as possible. Failure to do
so is a safety risk. ◀
Check the tire inflation pressure at the next op‐
portunity and correct it if necessary. Replace
the defective tire as soon as possible and have
the new wheel balanced.
Preparing wheel change
Observe the safety precautions regarding flat
tires, refer to page 164.
Additional safety precautions in the event
of a wheel change
Change the wheel only on a level, firm surface
which is not slippery.
The vehicle or the jack could slip to the side if
you attempt to raise the vehicle on a soft or
slippery surface, snow, ice, tiles, etc. Do not use
a wooden block or similar object as a support
base for the jack, as this would prevent it from
extending to its full support height and reduce
its load-carrying capacity.
To avoid serious or fatal injury: never lie under
the vehicle, and never start the engine while it
is supported by the jack. ◀1.Place the folding wheel chock behind the
front wheel of the other vehicle side; if the
vehicle is on an incline, place it in front of
this wheel. If the vehicle is parked on a
steep incline, additionally secure the vehi‐
cle against rolling.2.Expose the lug bolts if necessary.3.Loosen the lug bolts a half turn.Jacking up vehicle
The vehicle jack is designed for changing
wheels only.
The vehicle jack is designed for changing
wheels only. Do not attempt to raise another
vehicle model with it or to raise any load of any
kind. To do so could cause accidents and per‐
sonal injury. ◀
1.Position the vehicle jack at the jacking point
closest to the wheel.
The entire surface of the jack base must
rest on the ground vertically beneath the
jacking point.2.Guide the jack head into the rectangular re‐
cess of the jacking point when cranking up.3.Jack the vehicle up until the wheel you are
changing is raised from the ground.
Mounting the compact wheel
1.Unscrew the lug bolts and remove the
wheel.2.Remove accumulations of mud or dirt from
the mounting surfaces of the wheel and
hub. Also clean the lug bolts.Seite 183Replacing componentsMobility183
Online Edition for Part no. 01 40 2 911 475 - VI/13

Shift paddles on the steeringwheel 63
Side airbags 80
Side windows, refer to Win‐ dows 31
Slot for remote control 55
Snap-in adapter, mobile phone 145
Socket, OBD Onboard Diagno‐ sis 174
Special equipment, series equipment 6
Speed, average 67
Speedometer 14
Speed, with winter tires 164
Sport button 91
Sport program, automatic transmission with Step‐
tronic 63
Stability control systems 89
Start/Stop button 55
Start/Stop button, starting the engine 56
Start/Stop button, switching off the engine 57
Starting the engine 56
Start problems, refer to Jump- starting 186
Steering wheel 49
Steering wheel– Shift paddles 63
Steering wheel, adjusting 49
Steering wheel lock 55
Stopping, engine 57
Storage, tires 164
Storing the vehicle 195
Summer tires, refer to Wheels and tires 154
Summer tires, tread 161
Switches, refer to Cockpit 12
Switching off, engine 57
Switching off, vehicle 57
Symbols 6
T
Tachometer 66
Tailgate– Comfort Access 29– Emergency activation 28– Emergency unlocking 28– Opening/closing 27– Opening from the out‐
side 27– Unlocking manually 27– Unlocking with remote con‐
trol 24
Tail lamps 179
Tank gauge, refer to Fuel gauge 66
Technical changes, refer to Safety 6
Technical data 210
Telephone 138
Temperature
– Air conditioner 97– Automatic climate con‐
trol 100
Temperature, coolant, refer to
Coolant temperature 66
Temperature display
– External temperature 65– External temperature warn‐
ing 65– Setting the units 69
Temperature warning 65
Theft alarm system, refer to Alarm system 31
Time
– Setting the time 70
Tire age 162
Tire identification marks 160
Tire inflation pressure 154
Tire inflation pressure
– Pressure loss 84
Tire pressure monitor, refer to
Flat Tire Monitor 83
Tire Pressure Monitor TPM
– System limits 85– System reset 86– Warning lamp 86
Tire Quality Grading 160
Tires– Flat tire 84– Inflation pressure 154– Inflation pressure loss 86– Pressure monitoring, refer to
Tire Pressure Monitor
TPM 85
Tires, breaking in 112
Tires, changing 163
Tires, condition 161
Tires, damage 162
Tire size 160
Tires, minimum tread 162
Tires, retreaded tires 163
Tires, storage 164
Tire tread 161
Tool kit, refer to Onboard ve‐ hicle tool kit 175
Tools, refer to Onboard vehi‐ cle tool kit 175
Torque, refer to Engine data 210
Towing another vehicle 188
Towing, being towed 188
Tow-starting 188
TPM, refer to Tire Pressure Monitor 85
Traction control 90
Transmission
– Overriding selector lever
lock in case of automatic
transmission with Step‐
tronic 64
Transmission lock
– Refer to Changing selector
lever positions 62
Transmission, manual 61
Transporting children safely 50
Trip-distance counter, refer to Trip odometer 65
Triple turn signal activa‐ tion 58
Trip odometer 65
Trunk
– Opening from the inside 27Seite 221Everything from A to ZReference221
Online Edition for Part no. 01 40 2 911 475 - VI/13