height adjustment MITSUBISHI 3000GT 1991 User Guide

42-14BODY - Service Rdiustment ProceduresMB990834-0118A0381
18Ac-46118A0465FUEL FILLER DOOR ADJUSTMENT
M42FDAFLoosen the fuel filler door mounting screw and adjust the fuel
filler door so that the clearance around the fuel filler door is
even without any height differences.
DOOR ADJUSTMENT
M42FEAG
1.Use the special tool to loosen the hinge mounting bolts on
the body side, and then adjust the clearance around the
door so that it is uniform on all sides.
2.If the door is not flush with the body, remove the spring pin
from the door check, use the special tool to loosen the bolts
for mounting the door hinges to the door. Move the door to
adjust the door position along the body surface.
CautionAttach protection tape to the fender edges where the
hinge is installed.
3.If the door does not open freely, adjust the engagement of
the striker with the door latch by means of the striker
mounting shim and move the striker up and down or from
side to side.DOOIR WINDOW GLASS ADJUSTMENT
M42FFAL
1. Remove the door trim and waterproof film. (Refer to
P.42-41.)2. Remove the front pillar trim.
3. Remove the drip line weatherstrip.
4. Loosen the bolts and nuts of the following parts.
l Glass guide front track
l Glass guide rear track
l Delta sash
l Stabilizer inner front
l Stabilizer inner rear
. up stop
l Door belt line outer weatherstrip
NOTEMove the window glass down to the lowest position before
removing the delta sash bolt.
1 TSB Revision-1