engine MITSUBISHI CARISMA 2000 1.G User Guide
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 2000, Model line: CARISMA, Model: MITSUBISHI CARISMA 2000 1.GPages: 280, PDF Size: 2.32 MB
Page 73 of 280
INSTRUMENTS AND CONTROLS
4–7
Turn-signal indication lamps - greenED52A-Bb
These indication lamps blink on and off when a turn-
signal lamp is operating.
NOTE
If the blinking is too fast, the cause may be a faulty
turn-signal connection or a blown lamp bulb.
Hazard warning indication lamps - greenED30A-A
When the hazard warning lamp switch is pressed, all
turn-signal lamps will flash on and off continuously.
High-beam indication lamp - blueED51A-Aa
This indication lamp illuminates when the high beam
is used.
Low fuel indication lamp - amberED63AMEa
The indication lamp comes on when the fuel tank is
getting low. Refuel as soon as possible.
CAUTION
Do not drive with an extremely low fuel level,
running out of fuel could cause damage to the
catalytic converter.
NOTE
(1) On inclines or curves, due to the movement of
fuel in the tank, the low fuel indication lamp may
come on earlier than usual.
(2)When the engine on diesel–powered vehicles
fails to operate owing to running out of fuel, it
may sometimes be difficult to start after refuel-
ing. This is due to air entering the fuel system.
Therefore, air must be bled from the system.
(Refer to the page 8–21.)
Front fog lamp indication lamp* - greenED74B-A
This lamp illuminates while the front fog lamps are on.
Page 74 of 280
INSTRUMENTS AND CONTROLS
4–8
Rear fog lamp indication lamp - amber
ED74A-B
This lamp illuminates while the rear fog lamp is on.
Door-ajar warning lamp - redED56A-Ca
This lamp illuminates when a door or the tailgate is
either open or incompletely closed.
CAUTION
Before moving your vehicle, check that the
warning lamp is OFF.
Brake warning lamp - redED23AAKb
With the ignition switch “ON”, the brake warning lamp
illuminates under the following conditions:
(1) When the parking brake lever has been en-
gaged.
(2) When the brake fluid level in the reservoir falls to
a low level.
CAUTION
(1) In the situations listed below, brake per-
formance may be compromised, if brakes
are applied suddenly; consequently,
avoid driving at high speeds or applying
the brakes suddenly. Furthermore, the ve-
hicle should be brought to a stop in a safe
location and your nearest authorized MIT-
SUBISHI dealer should be contacted.
The brake warning lamp does not il-
luminate when the parking brake is ap-
plied or does not turn off when the
parking brake is released.
The brake warning lamp remains il-
luminated during driving.
(2) The vehicle should be brought to a halt in
the following manner when brake per-
formance has deteriorated.
Depress the brake pedal harder than
usual.
Should the brakes fail, use engine
braking to reduce your speed and
slowly pull the parking brake lever to
park your vehicle.
Depress the brake pedal to operate the
stop lamp (brake lamp) to alert the ve-
hicles behind you.
Page 75 of 280
INSTRUMENTS AND CONTROLS
4–9
Charge warning lamp - redED54A–Ra
This lamp illuminates when the ignition key is turned
“ON”, and goes off after the engine has started.
CAUTION
If it illuminates while the engine is running,
there is a problem in the charging system. In
this case, immediately park your vehicle in a
safe place and contact your nearest author-
ized MITSUBISHI dealer.
Abnormality in the charging system
Broken alternator belt
Check engine indication lamp - amberED85AAKa
This lamp is a part of an onboard diagnostic system
which monitors the emissions, engine and automatic
transmission control systems.
If a problem is detected in one of these systems, this
lamp illuminates or flashes. Although your vehicle will
usually be drivable and not need towing, have the sys-
tem checked as soon as possible at an authorized
MITSUBISHI dealer.
This lamp will also illuminate for a few seconds when
the ignition key is turned to the “ON” position. If it does
not go off after a few seconds, take the vehicle to an
authorized MITSUBISHI dealer.
CAUTION
(1) Prolonged driving with this lamp on may
cause further damage to the emission
control system. It could also affect fuel
economy and drivability.
(2) If the lamp does not illuminate when the
ignition key is turned to the “ON” posi-
tion, have the system checked at an auth-
orized MITSUBISHI dealer.
Page 76 of 280
INSTRUMENTS AND CONTROLS
4–10
CAUTION
(3) If the lamp illuminates or flashes while the
engine is running, avoid driving at high
speeds and have the system checked at
an authorized MITSUBISHI dealer.
During vehicle operation with the lamp il-
luminated or flashing, the vehicle may not
accelerate when you depress the acceler-
ator pedal.
When the vehicle is stationary with the
lamp illuminated or flashing, you must de-
press the brake pedal more firmly than
usual since the engine idling speed is
higher than usual and the vehicle with an
automatic transmission has a stronger
tendency to creep forward.
NOTE
The engine electronic control module accommodat-
ing the onboard diagnostic system has various fault
data (especially about the exhaust emission) stored.
This data will be erased if a battery cable is discon-
nected, which will make rapid diagnosis difficult. Do
not disconnect a battery cable when the check engine
indication lamp is ON.
Oil pressure warning lamp - redED25A-Ai
This lamp illuminates when the ignition key is turned
“ON”, and goes off after the engine has started. If it il-
luminates while the engine is running, the oil pressure
is too low.
If the warning lamp illuminates while the engine is run-
ning, turn the engine off and contact your nearest
authorized MITSUBISHI dealer for inspection.
CAUTION
(1) If this lamp illuminates when the engine
oil level is not low, contact your nearest
authorized MITSUBISHI dealer for inspec-
tion.
(2) This warning lamp does not indicate the
amount of oil in the crankcase. This must
be determined by checking the oil level on
the dipstick, while the engine is switched
off.
(3) If you continue driving with low engine oil
level or with this warning lamp illumi-
nated, engine seizure may occur.
NOTE
The oil pressure warning lamp should not be treated
as an indication of the engine’s oil level. The oil level
must be checked using the dipstick.
Page 77 of 280
INSTRUMENTS AND CONTROLS
4–11
Diesel preheat indication lamp - amber
(diesel-powered vehicles)
ED58A-Ja
The indication lamp illuminates when the ignition
switch is in the “ON” position. As the glow plug be-
comes hot, the lamp goes out and the engine can
be started.
Overheating warning lamp - red
(diesel-powered vehicles)
ED67A-Ba
If the warning lamp illuminates while the engine is run-
ning, it is possible that the engine is overheated.
Immediately park your vehicle in a safe place and
make the necessary corrections. (Refer to “Engine
overheating on page 8–15.)
While driving, care should always be taken to maintain
the normal operating temperature.
Page 85 of 280
INSTRUMENTS AND CONTROLS
4–19
CAUTION
If the lamps are kept flashing for a
long time, the battery will be dis-
charged, resulting in hard engine
starting or no start condition at all.
Type 1
I08B119a
Rear window demister switchEE17AAMb
The rear window demister switch can be op-
erated with the ignition switch in the “ON”
position.
Push the switch to turn on the rear window
demister. To turn off the demister, push the
switch again. As your vehicle is equipped
with the rear window demister timer, it will be
turned off automatically in about 20 minutes.
To turn off the demister within 20 minutes,
push the switch again.
The indication lamp (A) will illuminate while
the demister is on. If your vehicle is equipped
with a mirror heater, when the demister
switch is pressed, the mist can also be re-
moved from the outside rear-view mirrors.
Refer to “Electric remote-controlled outside
rear-view mirrors” on page 5–32.
Type 2
I17A061a
CAUTION
(1) The demister switch is not to melt
snow but to clear mist.
Remove snow before using the
demister switch.
(2) To avoid unnecessary discharge
of the battery, do not use the rear
window demister when the en-
gine is not running. Turn the de-
mister off immediately after the
window is clear.
(3) When cleaning the inside of the
rear window, use a soft cloth and
wipe gently along the heater
wires, being careful not to dam-
age the wires.
Page 89 of 280
INSTRUMENTS AND CONTROLS
4–23
F19A038a
Vehicles with sunroof
Room lamp
1(OFF)
-The lamp goes out.
2()
-The lamp illuminates when a
door or the tailgate is opened
and goes out when it is closed.
3(ON)
-The lamp illuminates.
F19A039a
Spot lamps4 - The lamp goes out.
5 - The lamp illuminates.
NOTE
If you leave the lamps on without running the
engine, you will run down the battery. Before
you leave the vehicle, make sure that all the
lamps are switched off.
Page 102 of 280
STARTING AND DRIVING
5–2
Running-in
recommendations
EA01AMKi
During the running-in period for the first
1,000 km, it is advisable to drive your new
vehicle using the following precautions as a
guideline to aid long life as well as future
economy and performance.
(1) Do not race the engine at high speeds.
(2) Avoid rapid starting, accelerating, brak-
ing and prolonged high-speed running.
(3) Keep to the running-in speed limit
shown below.
Please note that the legal speed limits
displayed must be adhered to.
(4) Do not exceed loading limits.
(5) Refrain from towing a trailer.
Ve h i c les with manual transmissionkm/h
Speed limit
DrivePetrol-powered vehicleDiesel-range
130016001800
(GDI)powered
vehicle
1st25353025
2nd50606045
3rd80909070
4th105120120100
5th130150155135
Vehicles with automatic trans-
mission INVECS-II 4A/T
km/h
Drive rangeSpeed limitDrive range1600
“L” (LOW)30
“2” (SECOND)70
“3” (THIRD)105
“D” (DRIVE)120
Ve h i c les with automatic trans-
mission INVECS-II
Sport Mode 4A/T
km/h
Drive rangeSpeed limit
1st30
2nd80
3rd120
4th130
Page 103 of 280
STARTING AND DRIVING
5–3
Fuel selectionEC20AMFe
Recommended
fuel
Petrol-powered vehicles
Unleaded petrol
octane rating (DIN 51607)
95 RON or higher (Super)
Diesel-powered vehicles
Cetane rating (DIN 51601)
45 or higher
NOTE
The petrol-powered vehicles have the oc-
tane number automatic change device so
that you can use unleaded normal petrol 91
RON as an emergency measure in case un-
leaded premium petrol 95 RON or higher is
not available on journey, etc. In such a case,
you don’t need to adjust the engine specially.
In case of using unleaded normal petrol 91
RON, the engine performance will suffer a
little degradation.
Filling the fuel tankEC20DMA
WARNING
Gasoline is highly flammable and ex-
plosive.
Yo u could be burned or seriously in-
jured when handling it. When refuel-
ing your vehicle, always turn the en-
gine off and keep away from flames,
sparks, and smoking materials. Al-
ways handle fuel in well–ventilated
outdoor areas.
Fuel tank capacity
60 litres
LHD
C20A131a
Refueling
1. Before filling with fuel, stop the engine.
2. The fuel tank filler is located on the left
side of your vehicle.
The fuel tank filler door can be opened
from inside the vehicle with the fuel
tank filler door release lever located
beside the driver’s seat.
Page 105 of 280
STARTING AND DRIVING
5–5
5. When the gun stops automatically, re-
move the gun half the way in the tank
port. After the second automatic stop,
do not fill with fuel any more.
CAUTION
To avoid fuel spillage and overfilling,
do not ”top–off” the fuel tank.
6. To close, turn the fuel tank filler tube
cap slowly clockwise until you hear
clicking sounds, then gently push the
fuel tank filler door closed.
CAUTION
If you need replace the fuel tank filler
tube cap, use only the cap specified
for your model vehicle.
C18A001a
Catalytic converterEC18A-Jc
For ordinary use, there are no particular pre-
cautions except that of using unleaded pet-
rol.
The exhaust gas scavenging device with
catalytic converter is extremely efficient for
the reduction of noxious gases. The catalytic
converter is installed in the exhaust system.
It is important to keep the engine properly
tuned to ensure proper catalyst operation
and prevent possible catalyst damage.
CAUTION
Damage to the catalytic converter can
result if your vehicle is not kept in
proper operating condition. In the
event of an engine malfunction par-
ticularly involving engine misfire or
other apparent loss of performance
have your vehicle serviced promptly.
Continued operation of your vehicle
with a severe overheated condition
may result in possible damage to the
converter and vehicle.
WARNING
(1) As with any vehicle, do not park
or operate this vehicle in areas
where combustible materials
such as dry grass or leaves can
come into contact with a hot ex-
haust since a fire could occur.
(2) Undercoating paint should not be
applied to the catalytic converter.