MPG MITSUBISHI CARISMA 2000 1.G Owners Manual
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 2000, Model line: CARISMA, Model: MITSUBISHI CARISMA 2000 1.GPages: 280, PDF Size: 2.32 MB
Page 95 of 280
INSTRUMENTS AND CONTROLS
4–29
D92I001a
Average fuel consumptionED92I-Bc
This value shows the average fuel con-
sumption (in L/100 km or mpg) since the dis-
play was reset. If you reset the display at the
time when you want to start the measure-
ments, average fuel consumption from that
point of time can be displayed.
To reset the display[Vehicles without MITSUBISHI genuine
audio]
Push the button (A) for more than 2 seconds.
Type 1
D92G002a
[Vehicles with MITSUBISHI genuine
audio]
Push the “DISP” button for more than 2 sec-
onds.
NOTE
(1) When the ignition switch is turned on,
the average fuel consumption which
was being displayed when the ignition
switch was previously turned off will be
displayed once again.
(2) Average fuel consumption varies ac-
cording to the conditions under which a
vehicle is travelling (road conditions, the
manner in which the vehicle is being
driven, etc.).
Observe this display for reference be-
cause the fuel consumption display
may differ from the actual fuel consump-
tion.
Type 2
D92G003a
Page 99 of 280
INSTRUMENTS AND CONTROLS
4–33
D92J002a
2. Use the “H” or “M” button to select the
desired speed unit, then press the
“SET” button to enter the setting.
H- km
M- mile
D92J003a
3. If the km unit was selected in step 2,
the fuel consumption unit must be se-
lected continuously using the “H” or
“M” button. The currently selected unit
will appear.
Use the “H” or “M” button to select the
desired fuel consumption unit, then
press the “SET” button to enter the set-
ting.
H- L/100 km
M- km/L
D92J004a
4. Press the “SET” button to determine
the setting. The display will return to
the original display item.
NOTE
(1) For vehicles without a MITSUBISHI
genuine audio system, only the unit of
fuel consumption can be changed to km
or miles as you like.
(2) If you select “M” (mile) unit in step 2, fuel
consumption is automatically shown in
“mpg (mile per gallon)”.
(3) To cancel the unit setting procedure be-
fore completion, press the button (A).
(4) The outside temperature and clock are
not shown during the unit selecting pro-
cedure.
(5) If the “SET” button is not pressed for
about 15 seconds or longer in the
middle of the selection, the currently se-
lected unit is set automatically. Then, the
display returns to the original display
item.