parking brake MITSUBISHI COLT 2008 Owner's Manual (in English)

Overview
Supplemental restraint
system (SRS) - air bag*
(for front passenger’s seat)
P. 2 - 4 7
Accessory socket
P. 5-60
Ventilators P. 5-2
Hazard warning flasher switch
P. 3 - 3 7
Cup holder (for rear seats)
P. 5-69
Parking brake lever
P. 4-6 Gearshift lever* P. 4-22
Allshift lever* P. 4-25
Steering wheel height
adjustment P. 4-9
Heated seats switch*
P. 2-7Front passenger’s air bag
ON-OFF switch* P. 2-53
Audio*
P. 5-24, 5-24
Heater* P. 5-7
Automatic air conditioning*
P. 5 - 1 3
Multi centre display P. 3-14
LHD
Rear window demister
switch P. 3-45
Cup holder (for front
seats) P. 5-69
Front passenger’s
air bag off indicator
lamp* P. 2-56

Overview
Fuses P. 8-30
RHD
Supplemental restraint
system (SRS) - air bag*
(for front passenger’s seat)
P. 2-47
Accessory socket P. 5-60Ventilators P. 5-2
Hazard warning flasher switch
P. 3 - 3 7
Cup holder (for rear seats)
P. 5 - 6 9 Parking brake lever
P. 4-6
Gearshift lever* P. 4-22
Allshift lever* P. 4-25
Steering wheel height
adjustment P. 4-9
Heated seats switch*
P. 2-7
Rear window demister
switch P. 3-45 Audio*
P. 5-24, 5-24
Heater* P.5-7
Automatic air conditioning*
P. 5-13 Multi centre display
P. 3 - 1 4
Front passenger’s air bag
ON-OFF switch* P. 2-53 Front passenger’s air
bag off indicator
lamp* P. 2-56
Cup holder (for front
seats) P. 5-69

Instruments and controls3-9
3
Diesel preheat indication lamp
(diesel-powered vehicles)
E00502300029
This indication lamp illuminates when the igni-
tion switch is placed in the “ON” position. As
the glow plug becomes hot, the lamp goes out
and the engine can be started.
NOTE●If the engine is cold, the diesel preheat indi-
cation lamp is on for a longer time.
● When the engine has not been started within
about 5 seconds after the diesel preheat
indication lamp went out, return the ignition
switch to the “LOCK” position. Then, turn
the switch to the “ON” position to preheat
the engine again.
Wa r n i n g l a m p s
E00502400017
Brake warning lampE00502501099
This lamp illuminates when the ignition switch
is turned to the “ON” position, and the lamp goes
off after a few seconds. Always make sure that
the lamp goes off before beginning to drive.
With the ignition switch “ON”, the brake warn-
ing lamp illuminates under the following condi-
tions:
● When the parking brake lever has been
engaged.
With the ignition switch “ON”, the brake warn-
ing lamp illuminates and a buzzer sounds under
the following conditions: ● When the brake fluid level in the reservoir
falls to a low level.
● The vehicle speed exceeds 8 km/h with the
parking brake applied.

3-10 Instruments and controls
3
CAUTION!
●If either of the si tuations described
below occurs, there is a risk of reduced
brake effectiveness. Stop the vehicle in
a safe place and we recommend you to
have it checked.
• The brake warning lamp does not illuminate when the parking brake is
applied or does not turn off when the
parking brake is released.
• The brake warning lamp remains
illuminated during driving.
● If the brake warnin g lamp comes on at
the same time as the ABS warning
lamp, the brake force distribution
function may be not working so hard
braking could make the vehicle unsta-
ble. Avoid hard braking and high-
speed driving. Stop the vehicle in a safe
place and we recommend you consult a
MITSUBISHI MOTORS Authorized
Service Point.
● The vehicle should be brought to a halt
in the following manner when brake
performance has deteriorated.
• Depress the brake pedal harder than
usual. Even if the brake pedal moves
down to the very end of its possible
stroke, keep it pressed down hard.
• Should the brakes fail, use engine
braking to reduce your speed and
slowly pull the parking brake lever to
park your vehicle.
Depress the brake pedal to operate
the stop lamp (brake lamp) to alert
the vehicles behind you.
CAUTION!

4
Starting and driving
Economical driving . . . . . . . . . . . . . . . . . . . . . . . .4- 2
Driving, alcohol and drugs. . . . . . . . . . . . . . . . . . .4- 3
Safe driving techniques . . . . . . . . . . . . . . . . . . . . .4- 3
Running-in recommendations . . . . . . . . . . . . . . . .4- 5
Parking brake . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4- 6
Parking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4- 8
Steering wheel height adjustment . . . . . . . . . . . . .4- 9
Inside rear-view mirror . . . . . . . . . . . . . . . . . . . . .4- 10
Outside rear-view mirrors . . . . . . . . . . . . . . . . . . .4- 10
Ignition switch . . . . . . . . . . . . . . . . . . . . . . . . . . . .4- 14
Steering wheel lock . . . . . . . . . . . . . . . . . . . . . . . .4- 15
Starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4- 16
Manual transmission . . . . . . . . . . . . . . . . . . . . . . .4- 22
Automated manual transmission . . . . . . . . . . . . . .4- 25
How to drive a vehicle with automated manual transmission . . . . . . . . . . . . .4- 30
Braking. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4- 35
Anti-lock brake system (ABS) . . . . . . . . . . . . . . . .4- 36
Electric power steering system . . . . . . . . . . . . . . .4- 40
Traction control system (TCL) /Active stability control syst em (ASC)*. . . . . . .4- 42
Cargo loads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4- 45
Trailer towing. . . . . . . . . . . . . . . . . . . . . . . . . . . . .4- 46

4-6 Starting and driving
4
Vehicles with automated manual transmissionParking brake
E00600500679
To park the vehicle, first bring it to a complete stop, fully
engage the parking brake, and then move the gearshift lever to
1st (on an uphill) or “R” (Reverse) position (on a downhill), for
vehicles with manual transmission, or move the allshift lever to
“S” (Stand by) position (on uphill) or “R” (Reverse) position
(on a downhill) on automated manual transmission vehicles.
To apply
Shift point
Speed limit
Petrol-powered vehiclesDiesel-powered vehicles
1st gear 30 km/h (19 mph) 25 km/h (16 mph)
2nd gear 50 km/h (31 mph) 40 km/h (25 mph)
3rd gear 80 km/h (50 mph) 65 km/h (40 mph)
4th gear 105 km/h (65 mph) 95 km/h (59 mph)
5th gear 130 km/h (81 mph) 125 km/h (78 mph)
6th gear 155 km/h (96 mph) 155 km/h (96 mph)
1- Pull the lever up without pushing the button at the end of thehand grip.

Starting and driving4-7
4
To r e l e a s e
When parking on a hill, apply the parking brake and turn the
front wheels towards the kerb on a downhill grade, away from
the kerb on an uphill grade.
1- Pull the lever up slightly.
2- Push the button at the end of the hand grip.
3- Push the lever downward.
CAUTION!
● Before driving, be sure that the parking brake is
fully released and brake warning lamp is off.
If a vehicle is driven wi thout releasing the parking
brake, the brake will be overheated, resulting in
ineffective brak ing and possible brake failure.
●When you intend to apply the parking brake, firmly
press the brake pedal to bring the vehicle to a com-
plete stop before pullin g the parking brake lever.
Pulling the parking brake lever with the vehicle
moving could make the rear wheels lock up, thereby
making the vehicle unstable.
● If the brake warning lamp does not extinguish when
the parking brake is fully released, the brake system
may be abnormal. For details, refer to “Brake warn-
ing lamp” on page 3-9.
CAUTION!

4-8 Starting and driving
4Parking
E00600600869
Parking on a hill
To prevent the vehicle from rolling into the street, follow these
procedures:
Parking on a downhill
Turn the front wheels towards
the kerb and move the vehicle
forward until the kerb side wheel gently touches the kerb.
Set the parking brake and place the gearshift lever into the “R”
(Reverse) position (with manual transmission) or the allshift
lever into the “R” (Reverse) position (with automated manual
transmission).
If necessary, apply chocks to wheels.
Parking on an uphill
Turn the front wheels away from the kerb and move the vehicle
back until the kerb side wheel gently touches the kerb.
Set the parking brake and place th e gearshift lever into the 1st
position (with manual transmission) or the allshift lever into
the “S” (Stand by) position (with automated manual transmis-
sion).
If necessary, apply chocks to wheels.
NOTE● If your vehicle has an automated manual transmission,
place the allshift lever in the “S” (Stand by) position or
“R” (Reverse) position before stopping the engine.
If you move the allshift lever after stopping the engine, a
gearshift will not take place.
Parking with the engine running
Never leave the engine running while you take a short
sleep/rest. Also, never leave the engine running in a closed or
poorly ventilated place. Leaving the engine running risks
injury or death from accidental ly moving the gearshift lever
(manual transmission) or the allshift lever (automated manual
transmission) or the accumulation of toxic exhaust fumes in the
passenger compartment.
Where you park
Your front bumper can be damaged if you scrape it over kerbs
or parking stop blocks. Be careful when travelling up or down
steep slopes where your bumper can scrape the road.
When leaving the vehicle
Always remove the key from the ignition switch and lock all
doors and the tailgate when leaving the vehicle unattended.
Always try to park your vehicle in a well lit area.
WARNING!
● Do not park your vehicle in areas where combustible
materials such as dry grass or leaves can come in
contact with a hot exhaust, since a fire could occur.

Starting and driving4-17
4
Starting the engine (petrol-powered vehicles)E00601701255
This vehicles is equipped with an electronically controlled fuel
injection system which is automa tically controlled. When start-
ing the engine, do not de press the accelerator pedal.
The starting procedure is as follows:
Vehicles with manual transmission 1. Insert the ignition key and fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal.
5. Place the gearshift lever in the “N” (Neutral) position.
CAUTION!
●Never attempt to start the engine by pushing or pull-
ing the vehicle. This can be very dangerous.
●Do not run the engine at high rpm or drive the vehi-
cle at high speed until th e engine has had a chance to
warm up.
● Release the ignition key as soon as the engine starts
to avoid damaging the starter motor.
●If your vehicle is equipped with a turbocharger, do
not stop the engine immedi ately after high-speed or
uphill driving. First allow the engine to idle to give
the turbocharger a chance to cool down.

4-18 Starting and driving
4
6. Turn the ignition key to the “ON” position and make cer-tain that all warning lamps are functioning properly before
starting the engine.
7. Turn the ignition key to the “START” position without depressing the accelerator pedal, and release it when the
engine starts.
NOTE● A ticking noise may be heard after starting the engine.
This is not an abnormal condition. The noise will disap-
pear after a short time of engine running.
If the ticking noise continues after the engine has warmed
up, we recommend that you have your vehicle checked.
● If the engine won’t start, depress the accelerator pedal
fully while cranking the engi ne. Once the engine starts,
release the accelerator pedal. Vehicles with automated manual transmission
1. Insert the ignition key and fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Turn the ignition key to the “ON” position and make cer- tain that all warning lamps are functioning properly.
5. Place the allshift lever in the “N” (Neutral) position and confirm that “N” is shown by the allshift indicator display.
Refer to “Moving the allshift lever” on page 4-27.
CAUTION!
● When starting the engine, make sure you depress
the brake pedal. If you st art the engine with the
accelerator pedal depressed, move your foot to the
brake pedal as soon as the engine has started.