remote start MITSUBISHI ECLIPSE 2010 4.G Owners Manual

Features and controls
3-3
3
NOTE
The key number (A) is stamped on the key number plate
as shown in the illustration.
Make a record of the key number and store the key and
key number plate in separate places, so that you can order
a key from your authorized Mitsubishi Motors dealer if
the original keys are lost.

The key is a precision electronic device with a built-in sig-
nal transmitter. Please observe the following in order to
prevent damage.
• Do not leave where it may be exposed to heat caused by
direct sunlight, such as on top of the dashboard.
• Do not take the remote control transmitter apart.
• Do not excessively bend the key or subject it to strong
impacts.
• Keep the remote control transmitter dry.
• Keep away from magnetic objects such as key holders.
• Keep away from devices that produce magnetism, such
as audio systems, computers and televisions.
• Do not clean with ultrasonic cleaners.
• Do not leave the key where it may be exposed to high
temperature or high humidity.

As your vehicle is equipped with an electronic immobi-
lizer, the engine is designed so that it will not start if the
ID code registered in the immobilizer computer and the
key’s ID code do not match. Refer to the section entitled
“Electronic immobilizer” for details and key usage.
Electronic immobilizer
(Anti-theft starting system)
N00509100676
The electronic immobilizer is designed to significantly reduce
the possibility of vehicle theft. The purpose of the system is to
immobilize the vehicle if an invalid start is attempted. A valid
start attempt can only be achieved (subject to certain condi-
tions), using a key “registered” to the immobilizer system.
All of the keys provided with your new vehicle have been pro-
grammed to the vehicle’s electronics.
BK0098300US.book 3 ページ ２００８年１２月８日　月曜日　午前１１時３７分

Features and controls
3-5
3
NOTE
Electronic immobilizer is not compatible with commer-
cially available remote starting systems. Use of commer-
cially available remote starting systems may result in
vehicle starting problems and a loss of security protection.

A system failure is suspected when the ignition key is
turned to the “START” position, and the engine does not
start. In such a case, contact an authorized Mitsubishi
Motors dealer.Replacement keysOnly keys that have been programmed to the vehicle electron-
ics can be used to start the vehicle.
If you lose a key, you can order a key from your authorized
Mitsubishi Motors dealer by referring to the key number.
To prevent vehicle theft, the ID code for the vehicle keys must
be changed.
Take your vehicle and all remaining keys to your authorized
Mitsubishi Motors dealer to have your ID code changed.
Additional keysTo add a key, you need to register the ID code to the vehicle.
Registering the ID code can be done by your authorized Mit-
subishi Motors dealer. Or it can be done by yourself (except for
vehicles sold in Canada).
For you to register the ID code yourself, follow the “Customer
key programming” procedure below.
If you choose to have your authorized Mitsubishi Motors
dealer register the ID code, take your vehicle and any remain-
ing keys to your authorized Mitsubishi Motors dealer.NOTE
You are provided with 2 keys, but you may add up to 6
more keys.Customer key programming (Except for vehicles
sold in Canada)You can program new keys to the system if you have two valid
(already registered) keys and blank (not registered) immobi-
lizer key (specially cut for your vehicle at your Mitsubishi
Motors dealer) by doing the following:
1. Insert the first valid key into the ignition and turn the igni-
tion to the “ON” position for 5 seconds.
2. Turn the ignition to the “LOCK” position and remove the
first key.
3. Within 30 seconds of turning the first key to the “LOCK”
position, insert the second valid key into the ignition and
turn it to the “ON” position. About 10 seconds later, the
immobilizer indicator will start blinking.
CAUTION
!
Do not make any alterations or additions to the
immobilizer system. Alterations or additions could
cause failure of the immobilizer.
BK0098300US.book 5 ページ ２００８年１２月８日　月曜日　午前１１時３７分

Features and controls
3-17
3
2. Slip your hand into the gap (B) under the rear hatch or
trunk, and raise the rear hatch or trunk lid to open it.NOTE
It is also possible to open the rear hatch or trunk lid using
the remote control transmitter. (See “Keyless entry sys-
tem” on page 3-7.)

The cargo area light (ECLIPSE only) comes on when the
rear hatch is opened, and goes out when it is closed.
To close
N00554200039
Pull the rear hatch grip (A) or trunk lid downward as illustrated
and let it go before the rear hatch or trunk lid closes com-
pletely. Gently slam the rear hatch or trunk lid from the outside
so that it is completely closed.
ECLIPSE ECLIPSE SPYDER
CAUTION
!
To avoid injuring your hand or arm, do not attempt
to close the rear hatch or trunk lid without letting go
of the rear hatch or trunk lid grip.
Before starting the vehicle, be sure to confirm that
the rear hatch or trunk lid is locked. If the rear
hatch or trunk lid opens while driving the vehicle,
objects stored in the cargo area could fall out onto
the road.ECLIPSE ECLIPSE SPYDER
BK0098300US.book 17 ページ ２００８年１２月８日　月曜日　午前１１時３７分

Alphabetical index
7
Starting
At extremely cold ambient temperature 3-66
Flooded engine 3-66
Normal conditions 3-65
Steering
Power steering fluid 7-16
,9-10
Tilt lock lever 3-55
Wheel lock 3-63
Steering wheel remote control switch 5-65
Stop and tail light
Bulb capacity 7-49
Sun visors 3-168
Sunroof 3-28
Supplemental Restraint System 2-36
How the Supplement Restraint System works 2-39
Servicing 2-57
Warning light 2-44T
Tachometer 3-108
Tank capacity 1-5
,9-10
Theft-alarm system 3-22
Timing belt 7-36
Tire pressure monitoring system 3-97
Tires 7-20
How to change a tire 6-9
Inflation pressure 7-23
Maintenance 7-25
Quality grading 8-2Replacing tires and wheels 7-25
Rotation 7-26
Size (tire and wheel) 9-9
Snow tires 7-28
Tire and loading information placard 4-8
,9-4
Tire chains 7-29
Tread wear indicators 7-26
Tools 6-8
Storage 6-8
Top stack 3-31
Towing 6-20
Traction control function 3-86
Trailer towing 4-13
Trip odometer 3-108
Trunk lid 3-16
Turn signal lights
Bulb capacity 7-48
Indicators 3-113
Lever 3-131
Replacement 7-53
,7-55
,7-56
,7-59
V
Vanity mirror 3-169
Vanity mirror lights
Bulb capacity 7-50
,7-51
Replacement 7-70
Vehicle care precautions 7-71
Vehicle dimensions 9-6
Vehicle emission control information label 9-2
BK0098300US.book 7 ページ ２００８年１２月８日　月曜日　午前１１時３７分