bulb MITSUBISHI GALANT 2012 9.G User Guide

7-50 Vehicle care and maintenance
7
Front turn-signal and parking lights
N00917300424
1. Turn the bulb socket counterclockwise to remove it. And
remove the bulb from the socket by turning it counter-
clockwise while pressing in.
2. To install the bulb, perform the removal steps in reverse.
Front side-marker lights
N00943400282
1. Turn the bulb socket counterclockwise to remove it. And
remove the bulb from the socket by pulling out.
2. To install the bulb, perform the removal steps in reverse.
BK0139500US.book 50 ページ ２０１１年４月１９日　火曜日　午後１時４８分

Vehicle care and maintenance
7-51
7
Front fog lights
(if so equipped)
N00943600691
1. Remove the clips (A) and screws (B), then remove the
cover (C).2. Remove the socket and bulb assembly (D) by turning it
counterclockwise.
BK0139500US.book 51 ページ ２０１１年４月１９日　火曜日　午後１時４８分

7-52 Vehicle care and maintenance
7
3. Pull part (E) in the direction of the arrow (F) to undo the
lock, thereby freeing the fog light bulb from the connec-
tor.
4. To install the bulb, perform the removal steps in reverse.
CAUTION
!
Handle halogen light bulb with care. The gas inside
a halogen light bulb is highly pressurized, so drop-
ping, knocking, or scratching a halogen light bulb
can cause it to shatter.
Never hold the halogen lights bulb with a bare hand,
dirty glove, etc. The oil from your hand could cause
the bulb to break the next time the fog lights are
used.
If the glass surface is dirty, clean it with alcohol and
let it dry completely before installing the bulb.
BK0139500US.book 52 ページ ２０１１年４月１９日　火曜日　午後１時４８分

Vehicle care and maintenance
7-53
7
Rear combination lights
N00943700416
1. Open the lid.
Partially take off the trim cover (A).2. Remove each socket and bulb assembly by turning it
counterclockwise.
3. To install the bulb, perform the removal steps in reverse.
B- Rear turn-signal light
Remove the bulb by pulling it out.
C- Tail and stop light
Remove the bulb by pulling it out.
BK0139500US.book 53 ページ ２０１１年４月１９日　火曜日　午後１時４８分

Vehicle care and maintenance
7-55
7
3. Remove the socket and bulb assembly by turning it coun-
terclockwise.4. Remove the bulb by pulling it out.E- Back-up light
BK0139500US.book 55 ページ ２０１１年４月１９日　火曜日　午後１時４８分

7-56 Vehicle care and maintenance
7
5. To install the bulb, perform the removal steps in reverse.NOTE
To reinstall the clips, first insert the prongs (F) into the
hole, then firmly press the cap portion (G).
High-mounted stop light
N00943900098
NOTE
The high-mounted stop light uses an LED instead of a
bulb. Check with an authorized Mitsubishi Motors dealer
or a repair facility of your choice when the light needs to
be repaired or replaced.
BK0139500US.book 56 ページ ２０１１年４月１９日　火曜日　午後１時４８分

7-58 Vehicle care and maintenance
7
3. Open the trunk lid.
Remove the socket and bulb assembly by turning it coun-
terclockwise.4. Remove the bulb by pulling it out.
5. To install the bulb, perform the removal steps in reverse.
BK0139500US.book 58 ページ ２０１１年４月１９日　火曜日　午後１時４８分

Vehicle care and maintenance
7-59
7
Dome light
N00944100231
1. Insert the tip of a screwdriver at the edge of the lens, pry
gently to remove the lens, and then remove the bulb from
the light holder.NOTE
Wrap a cloth around the tip of the screwdriver to keep
from scratching the lens.
2. To install the bulb, perform the removal steps in reverse.Reading lights
N00944400104
Have the reading light bulbs replaced at an authorized Mitsub-
ishi Motors dealer or a repair facility of your choice.
Glove compartment light
(if so equipped)
N00954200020
Have the glove compartment light bulbs replaced at an autho-
rized Mitsubishi Motors dealer or a repair facility of your
choice.
Front
BK0139500US.book 59 ページ ２０１１年４月１９日　火曜日　午後１時４８分

7-60 Vehicle care and maintenance
7
Trunk room light
N00944800081
1. Pull both clips (A) away from the center as shown and
remove the light unit. Then remove the bulb by pulling
out.
2. To install the bulb, perform the removal steps in reverse.
Vanity mirror lights
(if so equipped)
N00952800064
1. Insert the tip of a screwdriver at the edge of the lens, pry
gently to remove the lens, and then remove the bulb from
the light holder.NOTE
Wrap a cloth around the tip of the screwdriver to keep
from scratching the lens.
2. To install the bulb, perform the removal steps in reverse.
BK0139500US.book 60 ページ ２０１１年４月１９日　火曜日　午後１時４８分

Alphabetical index
2Parking brake lever stroke 7-28
Pedal 3-47
Pedal free play 7-28
Power brakes 3-48
Service brake 3-47
Warning light 3-78
Break-in recommendations 3-2
Bulb capacity 7-45
C
California Perchlorate Materials Requirements 1-9
Capacities 9-8
Cargo loads 4-13
Catalytic converter 7-3
Certification label 9-4
Charging system warning light 3-80
Child restraints 2-27
Child safety locks for rear door 3-15
Cleaning
Inside of your vehicle 7-62
Outside of your vehicle 7-63
Clock 3-123
Coat hooks 3-134
Combination headlights and dimmer switch 3-81
Consumer information 8-2
Coolant (engine) 7-9
,9-8
Cruise control 3-57
Indicator light 3-58
Cup holder 3-133
D
Defogger (rear window) 3-90
Digital clock 3-123
Dimensions 9-4
Dimmer (high/low beam change) 3-83
Disc brake pads 7-31
Dome light 3-129
Capacity 7-46
Replacement 7-59
Door-ajar warning buzzer 3-80
Door-ajar warning light 3-80
Doors
Lock 3-12
Power door locks 3-14
Drive belt 7-32
Driving during cold weather 4-6
Driving, alcohol and drugs 4-2
E
Electric rear window defogger switch 3-90
Electronic immobilizer (Anti-theft starting system) 3-3
Emission-control system maintenance 7-29
Engine
Compartment 7-6
Coolant 7-9
,9-8
Coolant temperature gauge 3-76
Hood 7-4
Malfunction indicator light 3-79
BK0139500US.book 2 ページ ２０１１年４月１９日　火曜日　午後１時４８分