wheel bolts MITSUBISHI GRANDIS 2008 Owner's Manual (in English)

6-22 For emergencies
6
7. On vehicles with wheel covers, first remove the covers
(refer to “Wheel covers” on page 6-26). Then loosen the
wheel nuts with the wheel nut wrench. Do not remove the
wheel nuts yet.
8. Find the jacking point closest to the flat tyre (refer to
“Jacking up the vehicle” on page 6-13). Then position the
jack and raise the vehicle until the tyre is slightly off the
ground.
9. Remove the wheel nuts with the wheel nut wrench, then
take the wheel off.10. Clean out any mud, etc. on the hub surface (C), hub bolts
(D) or in the installation holes (E) in the wheel, and then
mount the spare tyre.
CAUTION
!●Handle the wheel carefully when changing the tyre,
to avoid scratching the wheel surface.
BK-XP08E1ENUK.en-uk.book Page 22 Monday, August 13, 2007 2:20 PM

6-24 For emergencies
6
Vehicle with aluminium wheels
With a normal wheel, tighten the wheel nuts until the
flanges of the wheel nuts touch the wheel and the wheel is
not loose.With a compact spare wheel, tighten the wheel nuts until
the tapered parts of the wheel nuts make light contact with
the seats of the wheel holes and the wheel is not loose.
NOTE●Flange nuts can be temporarily used on the spare wheel,
but return to the original wheel and tyre as soon as possi-
ble.
●If all four aluminium wheels are changed to steel wheels,
use tapered nuts.
Normal wheel
CAUTION
!●Never apply oil to either the wheel bolts or the nuts
or they will tighten too much.Compact spare wheel
BK-XP08E1ENUK.en-uk.book Page 24 Monday, August 13, 2007 2:20 PM