fog light MITSUBISHI iMiEV 2012 1.G User Guide

5-6 Comfort controls
5Air conditioning
N00730300328
The air conditioning can only be used when the ready indicator
is illuminated.NOTE
If the energy level gauge is at 0 bars or the power down
warning light illuminates, the vehicle interior may not be
cooled/heated even though the dial or switch is operated.
Furthermore, the defog performance may be also reduced.
Refer to “Energy level gauge” on page 3-69.
Refer to “Power down warning light” on page 3-75.
Control panel
N00730500290
A- Temperature control dial
B- MAX switch
C- Blower speed selection dial
D- Air conditioning switch
E- Mode selection dial
F- Air selection switch
BK0140800US.book 6 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Comfort controls
5-9
5
“AUTO” position
The vents change to the following positions according to the
position of the temperature control dial.
Refer to “Temperature control dial” on page 5-8.
Air selection switch
N00736800400
Normally, use the outside air position to keep the windshield
and side windows clear and to quickly remove fog or frost
from the windshield.
To change the air selection, simply press the air selection
switch.

Outside air {Indicator light (A) OFF}
Outside air is introduced into the passenger compartment.

Recirculated air {Indicator light (A) ON}
Air is recirculated inside the passenger compartment.
Temperature control dial position
Ve n t s
Between “C” and middle(
): Upper part of front
passenger compartment
Middle(
)Set the dial to middle
(
) from the “C” side: Upper part of front
passenger compartment
Set the dial to middle
(
) from the “H” side: Leg area
Between
middle (
)
and “H”Near middle (
)
: Leg area
Near “H”: Leg area,
windshield, and door
windowsCAUTION
!
When using the mode selection dial between the
“ ” and “ ” positions, prevent fogging by press-
ing the air selection switch to select outside air.
(Refer to “Air selection switch” on page 5-9.)
BK0140800US.book 9 ページ ２０１１年９月２９日　木曜日　午後３時２８分

5-10 Comfort controls
5
If high cooling performance is desired, or, if the outside air is
dusty or contaminated in some way, use the recirculation posi-
tion. Switch to the outside air position every now and then to
keep the windows from fogging up. NOTE
When the mode selection dial is set to the “ ” position,
the air conditioning compressor runs automatically. Out-
side air introduction will also be selected automatically.

When the temperature control dial is set to the “C” posi-
tion, the air selection will be automatically set to the
recirculation position.
Air conditioning switch
N00731000465
Push the switch, and the air conditioning compressor will turn
on. The air conditioning indicator light (A) will come on.
Push the switch again and the air conditioning compressor will
stop and the indicator light (A) goes off.
CAUTION
!
Using recirculated air for a long time may cause the
windows to fog up.
BK0140800US.book 10 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-31
7
*: Fusible link

Some fuses may not be installed on your vehicle, depend-
ing on the vehicle model or specifications.

The table above shows the main equipment corresponding
to each fuse.
No.
Symbol
Electrical system
Capacity
1 Tail light (left) 7.5 A
2Cigarette lighter/
12 V power outlet15 A
3 — — —
4Starter 7.5 A
5 Audio amplifier 20 A
6— — —
7 Tail light (right) 7.5 A
8 Outside rearview mirrors 7.5 A
9Control unit
(Electric motor unit)7.5 A
10 Control unit 7.5 A
11 Rear fog light 10 A
12 Door lock 15 A
13 Interior lights (Dome lights) 10 A
14 Rear window wiper 15 A
15 Gauges 7.5 A
16 Relay 7.5 A
17 Heated seat 20 A
18 Option 10 A
19Heated door outside rearview
mirrors7.5 A
20 Windshield wiper 20 A
21 Back-up lights 7.5 A
22 Defogger 30 A
23 Heater 30 A
24 12V starter battery 30 A*
25 Radio 10 A
26 Electronic controlled unit 15 A
27 — Electronic controlled unit 7.5 ANo.
Symbol
Electrical system
Capacity
BK0140800US.book 31 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-32 Vehicle care and maintenance
7
Under the hood fuse location table
*: Fusible link

Some fuses may not be installed on your vehicle, depend-
ing on the vehicle model or specifications.

The table above shows the main equipment corresponding
to each fuse.
No.
Symbol
Electrical system
Capacity
1— — —
2 12V starter battery 30 A*
3 Electric motor switch 40 A*
4 Radiator fan motor 40 A*
5 Power window control 40 A*
6 Brake electric vacuum pump 30 A*
7 Electric motor unit control 15 A
8 Stop lights (Brake lights) 15 A
9 Front fog lights 15 A
10Wa t e r p u m p
(Electric motor unit)15 A
11 Charge 10 A
12 Hazard warning flasher 10 A
13 Horn 10 A
14 Daytime running lights 10 A
15Main drive lithium-ion bat-
tery fan motor15 A
16Wa t e r p u m p
(Air conditioning)10 A
17 Headlight (low beam) (right) 20 A
18 Headlight (low beam) (left) 20 A
19 Headlight (high beam) (right) 10 A
20 Headlight (high beam) (left) 10 ANo.
Symbol
Electrical system
Capacity
BK0140800US.book 32 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-35
7 Replacement of light bulbs
N00942900336
Before replacing a bulb, be sure the light is off. Do not touch
the glass part of the new bulb with your bare fingers; the oil
from your skin will stay on the glass and dim or destroy the
bulb when it gets hot.NOTE
If you are unsure of how to carry out the work as required,
it is recommended that these procedures be carried out by
a certified i-MiEV dealer.

Be careful not to scratch the vehicle body when removing
a light and lens.

When it rains, or when the vehicle has been washed, the
inside of the lens sometimes becomes temporarily foggy.
This is the same phenomenon as when window glass mists
up on a humid day, and does not indicate a functional
problem.
When the light is switched on, the heat will remove the
fog. However, if water collects inside the light, please
have it checked by a certified i-MiEV dealer.
CAUTION
!
Never use a fuse with a capacity greater than the one
listed or any substitute, such as wire, foil etc. This
would cause the circuit wiring to heat up and could
cause a fire.
If the replacement fuse blows again after a short
time, have the electrical system checked by a certi-
fied i-MiEV dealer to find and correct the cause.
CAUTION
!
Bulbs are extremely hot immediately after being
turned off.
When replacing a bulb, wait for it to cool sufficiently
before touching it. You could otherwise be burned.
BK0140800US.book 35 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-36 Vehicle care and maintenance
7
Bulb capacity
N00943000099
The bulb should only be replaced with a new bulb with the
same rating and type. The type and rating are listed on the base
of the bulb.Outside
N00950300847
NOTE
Check with a certified i-MiEV dealer when the headlight
and the parking light need to be repaired or replaced.
Description
Wa t t a g e
ANSI Trade
No. or Bulb
type
1- Headlight, low beam 55 W H11
2- Head light, high beam 60 W 9005 HB3
3- Front fog light (if so
equipped)35 W H8Front
4- Daytime running light
(if so equipped)13 W P13W
5- Front turn signal light 21 W W21W
6- Parking light 5 W W5W
7- Front side-marker light 5 W W5W
Description
Wa t t a g e
ANSI Trade
No. or Bulb
type
BK0140800US.book 36 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-40 Vehicle care and maintenance
7
Front turn signal lights/Front fog lights (if so
equipped)/Daytime running lights
(if so equipped)
N00943400312
1. To create enough work space, turn the steering wheel all
the way in the same direction to the side you wish to
replace.
2. Remove the clip (A) and bolts (B), then lift the cover (C).3. Turn the socket counterclockwise to remove it.
D- Front turn signal light
E- Front fog light
F- Daytime running light
BK0140800US.book 40 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-41
7
4. Remove the bulb as follows.
[Front turn signal light]
Pull the bulb out of the socket.
[Front fog light and daytime running light]
While holding down the tab (F), pull out the bulb assem-
bly (G).5. To install the bulb, perform the removal steps in reverse.Front fog light
Daytime running light Front turn signal light
CAUTION
!
Handle halogen light bulb with care. The gas inside
a halogen light bulb is highly pressurized, so drop-
ping, knocking, or scratching a halogen light bulb
can cause it to shatter.
Never hold the halogen light bulb with a bare hand,
dirty glove, etc.
The oil from your hand could cause the bulb to
break the next time the fog lights are used.
If the glass surface is dirty, clean it with alcohol and
let it dry completely before installing the bulb.
BK0140800US.book 41 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Alphabetical index
2
C
California Perchlorate Materials Requirements 1-9
Capacities 9-10
Card holder 3-123
,3-129
Cargo loads 4-13
Certification label 9-5
Charging
Quick charging 1-33
Regular charging 1-20
,1-32
Charging indicator 3-72
Charging Timer 1-48
Charging troubleshooting guide 1-38
Chassis number 9-3
Child restraint 2-23
Child safety locks for rear door 3-15
Cleaning
Inside of your vehicle 7-50
Outside of your vehicle 7-52
Clock 5-41
Cold
Cautions and actions to deal with intense cold 1-12
Combination headlights and dimmer switch 3-76
Consumer information 8-2
Coolant 7-7
,9-10
Cruising range 1-5
Cruising range indicator 3-61
,3-67
Cup holder 3-130
D
Dash lights brightness indicator 3-61
,3-66
Daytime running lights
Bulb capacity 7-36
Replacement 7-40
Defogger (rear window) 3-89
Dimensions 9-6
Dimmer (high/low beam change) 3-81
Dinghy towing 4-14
Disc brake pads 7-27
Dome light (Front)/Reading lights
Bulb capacity 7-37
Switch 3-125
Dome light (Rear)
Bulb capacity 7-37
Switch 3-127
Door-ajar warning light and buzzer 3-74
Doors
Lock 3-12
Power door locks 3-14
Driver’s seat belt reminder/warning light 2-17
Driving during cold weather 4-7
Driving, alcohol and drugs 4-3
E
Economical driving 4-2
Electric motor
Number 9-4
BK0140800US.book 2 ページ ２０１１年９月２９日　木曜日　午後３時２８分