headlights MITSUBISHI iMiEV 2012 1.G User Guide

3-66 Features and controls
3
Dash lights brightness indicator
N00572600019
Each time you press the dash lights illumination button (B), the
brightness of the instruments changes.
NOTE
You can adjust to 4 different levels for when the parking
lights or headlights are illuminated and 4 for when they
are not.

If you press and hold the button for longer than about 1
second, the brightness automatically scrolls through its
different levels, and stops scrolling when you release the
button. Select your desired level of brightness.

When the combination headlights and dimmer switch is in
the “AUTO” position, the meter illumination switches
automatically to the adjusted brightness, depending on the
brightness outside the vehicle.

The brightness level of the instruments is stored when the
electric motor switch is turned off.

If the 12V starter battery is disconnected for a long time,
these level of brightness will be reset.
A- Brightness display
B- Dash lights illumination button
Bright Dim
BK0140800US.book 66 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-72 Features and controls
3Indicators
N00519900127
Turn signal indicators/Hazard warning lights
N00520000232
The arrows will flash in time with the corresponding exterior
turn signals when the turn signal lever is used.
Both arrows will flash when the hazard warning flasher switch
is pressed.NOTE
If the indicator flashes faster than usual or if the indicator
stays on without flashing, check for a malfunctioning turn
signal light bulb or turn signal connection.High beam indicator
N00520100086
A blue light comes on when the headlights are on high beam.Front fog light indicator
(if so equipped)
N00520200221
This indicator comes on while the front fog lights are on.Position indicator
N00551300039
This indicator turns on while the position lights are on.Ready indicator
N00573200012
This indicator comes on when the electric motor switch is
turned to “START” and driving becomes possible.
Charging indicator
N00573300013
This indicator flashes when the regular charging cable or quick
charging cable is connected.
After that, the light switches to being illuminated when charg-
ing starts and goes out when charging is completed.Regenerative brake system indicator
N00573400014
The indicator comes on when the regenerative brake perfor-
mance may be weakened. In this case, drive the vehicle at a
lower speed.
BK0140800US.book 72 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-76 Features and controls
3Combination headlights and dimmer switch
N00522500710
HeadlightsNOTE
Do not leave the headlights and other lights on for a long
period of time while the ready indicator is not illuminated.
A run down 12V starter battery could result.

When it rains, or when the vehicle has been washed, the
inside of the lens sometimes becomes foggy. This is the
same as when window glass mists up on a humid day, and
does not indicate a problem. When the light is switched
on, the heat will dry out the fog. However, if water col-
lects inside the light, have it checked by a certified
i-MiEV dealer.
Type 1Rotate the switch to operate the lights.
The combinations of switch operations and illuminated lights
differ in accordance with the following conditions.
Except for vehicles equipped with daytime running lights
OFF All lights off
Parking, tail, front and rear side-marker lights, license
plate and instrument panel lights on
Headlights and other lights on
BK0140800US.book 76 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-77
3
Vehicles equipped with daytime running lights
[When the ready indicator is illuminated, and the parking brake
is released]
The daytime running lights will be illuminated:NOTE
Once the daytime running light come on, they do not go
out until the electric motor switch is turned to the
“LOCK” or “ACC” position.
[When the ready indicator is not illuminated, or when the ready
indicator is illuminated but the parking brake is not released]
The electric motor unit starts when the lights are off.
Type 2Rotate the switch to operate the lights.
The combinations of switch operations and illuminated lights
differ in accordance with the following conditions.
Except for vehicles equipped with daytime running lights

OFF The daytime running lights illuminated
The daytime running lights illuminated
Parking, tail, front and rear side-marker lights, license
plate and instrument panel lights on
Headlights and other lights on
OFF All lights off
Parking, tail, front and rear side-marker lights, license
plate and instrument panel lights on
Headlights and other lights on
OFF All lights off
AUTOHeadlights and other lights turn on and off automati-
cally in accordance with outside light level.
Parking, tail, front and rear side-marker lights, license
plate and instrument panel lights on
Headlights and other lights on
BK0140800US.book 77 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-78 Features and controls
3
Vehicles equipped with daytime running lights
[When the ready indicator is illuminated, and the parking brake
is released]
The daytime running lights will be illuminated:NOTE
Once the daytime running light come on, they do not go
out until the electric motor switch is turned to the
“LOCK” or “ACC” position.[When the ready indicator is not illuminated, or when the ready
indicator is illuminated but the parking brake is not released]
The electric motor unit starts when the lights are off.OFF The daytime running lights illuminated
AUTOThe daytime running lights illuminated
Headlights and other lights turn on and off automati-
cally in accordance with outside light level.
The daytime running lights illuminated
Parking, tail, front and rear side-marker lights, license
plate and instrument panel lights on
Headlights and other lights on
OFF All lights off
AUTOHeadlights and other lights turn on and off automati-
cally in accordance with outside light level.
Parking, tail, front and rear side-marker lights, license
plate and instrument panel lights on
Headlights and other lights on
BK0140800US.book 78 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-79
3
NOTE
The sensitivity of the automatic on/off control can be
adjusted.
For further information, please contact a certified i-MiEV
dealer.

Do not place anything on the sensor (A), and do not clean
with a glass cleaner. Clean only with clear water.

If the lights do not turn on or off with the switch in the
“AUTO” position, manually operate the switch. Have the
system checked by a certified i-MiEV dealer.
Light auto-cutout function (headlights and other
lights)
N00532600554

If the key is turned to “LOCK” or “ACC” position or
removed from the electric motor switch and the driver’s
door is opened with the combination headlights and dim-
mer switch in the “ ” or “ ” position, the lights auto-
matically turn off.
• If the driver’s door is opened after the key is removed
from the electric motor switch, a buzzer will sound to
remind you to turn off the lights.
• If the driver’s door is opened with the key in the electric
motor switch, a buzzer will sound intermittently to
remind you to remove the key.

If the key is turned to “LOCK” or “ACC” position with
the driver’s door closed and the combination headlights
and dimmer switch in the “ ” or “ ” position, the
lights will stay on for about 3 minutes and then turn off
automatically. NOTE
The light auto-cutout function can be deactivated.
See a certified i-MiEV dealer for details.
BK0140800US.book 79 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-80 Features and controls
3
When you want to keep the lights on: If the combination headlights and dimmer switch is turned to
the “ ” or “ ” position again after the electric motor
switch is turned to “LOCK” or “ACC”position, the auto-cutout
function described above will not work. The lights (the parking
lights, tail lights and license plate lights) will stay on and will
not turn off automatically. NOTE
If the driver’s door is opened and the key is removed, the
headlight reminder buzzer will sound. If the key is still in
the electric motor switch the key reminder buzzer will
sound intermittently.
The buzzer stops when the driver’s door is closed.
Headlight reminder buzzer
N00549800213
If the driver’s door is opened with the key removed from the
electric motor switch while the lights are on, the buzzer will
sound to remind you to turn off the lights.
The lights and buzzer will turn off automatically.
Or you can turn the combination headlights and dimmer switch
to the “OFF” position to stop the buzzer.
BK0140800US.book 80 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-81
3
Dimmer (high/low beam change)
N00549900155
To change the headlights from high beam to low beam and vice
versa, pull the turn signal lever to fully toward you (1). Switch
the headlights to low beam as a courtesy whenever there are
oncoming vehicles, or when there is traffic moving ahead of
you. An illuminated blue light in the instrument cluster indi-
cates when the headlights are on high beam.
Headlight flasher
N00550000198
You can flash the high beams by pulling the lever gently
toward you (2). The lights will go back to normal when you let
go. While the high beam is on, you will see a blue light on the
instrument panel.NOTE
You can flash the high beams by pulling the lever toward
you, even if the combination headlights and dimmer
switch is off.

If you turn the lights off with the headlights set to high-
beam illumination, the headlights are automatically
returned to their low-beam setting when the combination
headlights and dimmer switch is next turned to the “ ”
position.
BK0140800US.book 81 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-83
3 Hazard warning flasher switch
N00522700305
If you press the flasher switch, the front and rear turn signals
will flash intermittently, and so will the hazard warning lights.
This is an emergency warning system and should not be used
when the vehicle is in motion, except for emergencies.
If you need to leave your vehicle, the flashers will keep work-
ing after the key is removed from the electric motor switch.NOTE
If you keep the flashers on for a long period of time while
the ready indicator is not illuminated, the 12V starter bat-
tery could go flat and the electric motor unit could be
impossible to start.
Front fog light switch
(if so equipped)
N00522800410
The front fog lights illuminate only when the headlights are on
low beam.
Turning the knob in the direction of the “ON” position turns on
the front fog lights as well as the indicator in the instrument
cluster. To turn them off, turn the knob in the direction of the
“OFF” position.
The knob will return to the neutral position when it is released.NOTE
If the headlights are switched to high beam, the front fog
lights will go out; they will illuminate again when the
headlights are switched back to low beam.
BK0140800US.book 83 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-84 Features and controls
3

If the combination headlights and dimmer switch is
rotated to the “OFF” or “ ” position while the front fog
lights are illuminated, they will automatically turn off.
They can be turned back on again by rotating the combi-
nation headlights and dimmer switch back to “ ” posi-
tion, and turning the knob in the direction of the “ON”
position.

Do not use fog lights except in conditions of fog, other-
wise excessive light glare may temporarily blind oncom-
ing vehicle drivers.
Wiper and washer switch
N00523000640
Windshield wipersThe windshield wiper and washer can be operated with the
electric motor switch in the “ON” or “ACC” position.
If the blades are frozen to the windshield, do not operate the
wipers until the ice has melted and the blades are freed, other-
wise the wiper motor may be damaged.
CAUTION
!
If the washer is used in cold weather, the washer
fluid sprayed against the glass may freeze, which
may hinder visibility. Warm the glass with the
defroster before using the washer.
BK0140800US.book 84 ページ ２０１１年９月２９日　木曜日　午後３時２８分