cooling MITSUBISHI iMiEV 2012 1.G Owner's Manual

7-14 Vehicle care and maintenance
7
NOTE
Be sure to install the plastic nut in the correct direction.Checking 12V starter battery electrolyte level
N00901500056
Before checking the 12V starter battery electrolyte level,
remove the 12V starter battery’s upper cover.
The electrolyte level must be between the limits shown on the
outside of the 12V starter battery. Fill it with distilled water as
needed. The inside of the 12V starter battery is divided into
several compartments. Take the cap off of each compartment
and fill to the mark.
Do not fill above the top line because a spill during driving
could cause damage.
CAUTION
!
Be sure to install the 12V starter battery upper
cover. Otherwise, the battery electrolyte may spill
and cause a malfunction.
When installing the 12V starter battery upper cover
and plastic nut do not touch the cooling fan or other
moving parts under the hood.
Be especially careful that the cables, your clothing
or hair, etc., do not get caught in the cooling fan or
other moving parts.
WA R N I N G
!
If the 12V starter battery goes flat, be sure to check
the 12V starter battery electrolyte level before con-
necting booster cables.
After checking the 12V starter battery electrolyte
level, make sure the caps are fitted securely.
If any of the caps cannot be re-secured to the 12V
starter battery, replace the 12V starter battery.
BK0140800US.book 14 ページ ２０１１年９月２９日　木曜日　午後３時２８分