key MITSUBISHI iMiEV 2012 1.G Owner's Manual

Features and controls
3-19
3
Armed stagePark the vehicle and stop the electric motor unit. Arm the sys-
tem as described below.
1. Remove the key from the electric motor switch.
2. Lock all doors and the liftgate by using the keyless entry
system.At this time, the theft-alarm indicator (A) in the meter
cluster flashes for confirmation.
3. The system has entered the armed stage after about 20
seconds, when the theft-alarm indicator flashing becomes
slower.
The theft-alarm indicator continues to flash while the sys-
tem is in the armed stage.Arm the system and leave
BK0140800US.book 19 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-20 Features and controls
3
NOTE
The system will be disarmed if, while the theft-alarm indi-
cator is illuminated, all doors and the liftgate are unlocked
by using the keyless entry system.

The system will be disarmed if, while the theft-alarm indi-
cator is illuminated, the electric motor switch is turned to
the “ON”.

The system will not be armed if a door or the liftgate is not
completely closed. If this happens, rearm the system as
described above.

The theft-alarm system can be activated when people are
riding inside the vehicle or when the windows are open.
To prevent accidental activation of the alarm, do not set
the system to the system armed mode while people are
riding in the vehicle.

If the answerback function (flashing of the turn signal
lights by locking and unlocking the doors and the liftgate)
is deactivated, the turn signal lights do not flash after the
locking and unlocking operation.
For information on the answerback function, refer to
“Keyless entry system” on pages 3-7.Alarm stageThe alarm will be activated if the following occurs while the
vehicle is parked and the system is armed.

One of the doors and the liftgate is opened without using
the keyless entry system.
Type of alarmWhen the alarm is activated:
1. The headlights blink on and off for 3 minutes.
After 3 minutes the headlights automatically shut off.
2. The horn will sound intermittently for 3 minutes.NOTE
The alarm will continue to operate for 3 minutes. At the
end of that period, the alarm will automatically shut off to
save battery power. The system will then be rearmed until
the proper disarming step is taken.

The alarm will resume if unauthorized actions are taken
again, even if the alarm has stopped.Horn sounds!
Headlights blink on and off!
BK0140800US.book 20 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-21
3
Alarm deactivationThe alarm can be deactivated in the following ways.

By using the keyless entry system to lock or unlock the
doors and liftgate.

Turn the electric motor switch to the “ON” position.Disarmed stageThe system will be disarmed if the following operation is per-
formed.

The electric motor switch is turned to the “ON” position.

All doors and the liftgate are unlocked by using the
keyless entry system.
NOTE
If the UNLOCK button on the remote control transmitter
is operated when all doors and the liftgate are closed and
no door is opened within approximately 30 seconds, re-
arming will automatically occur.

The amount of time after unlocking until the vehicle
relocks automatically can be adjusted. See a certified i-
MiEV dealer for details.

Once the system has been disarmed, it cannot be rearmed
except by repeating the arming procedure.Testing the theft-alarm systemUse the following procedure to test the system:
1. Lower the driver’s window.
2. Arm the system as explained in “Armed stage”.
3. Make sure that the theft-alarm indicator comes on and
flashes for approximately 20 seconds.
4. Wait a few seconds and then unlock the driver’s side door
by using the inside door lock knob. Open the door.
5. Make sure that the horn sounds intermittently and the
headlights blink when a door is opened.
6. Disarm the system by unlocking all doors and the liftgate
by using the keyless entry system.
Disarm...by using the keyless entry system
BK0140800US.book 21 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-22 Features and controls
3Power window control
N00510800396
NOTE
Never try to operate the main switch and sub-switch in
different directions at the same time. This will freeze the
window in position.

Operating the power windows repeatedly with the electric
motor unit stopped will run down the 12V starter battery.
Use the window switches only while the electric motor
unit is operating.
Main switch
N00548700127
The main switch located on the driver’s door can be used to
operate all the windows.
A window can be opened or closed by operating the corre-
sponding switch.
Press the switch down to open the window, and pull up the
switch to close it.
If the driver’s door window switch is fully pressed down, the
driver’s door window automatically opens completely.
If you want to stop the window movement, operate the switch
lightly in the reverse direction.
1- Open (down)
2- Close (up)
WA R N I N G
!
Before operating the power windows, make sure
that nothing can be trapped (head, hands, fingers,
etc.) in the window.
Never leave the vehicle without carrying the key.
Never leave children or unreliable adults unat-
tended inside the vehicle.
BK0140800US.book 22 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-30 Features and controls
3Electric motor switch
N00571500011
LOCKThe steering wheel is locked. The key can be inserted and
removed only when the switch is in this position. ACCThe ready indicator is not illuminated, but the audio system
and other electric devices can be operated.ON The electric motor unit is running, and all the vehicle’s electri-
cal devices can be operated.
START The electric motor unit operates. After the electric motor unit
has started, release the key and it will automatically return to
the “ON” position.NOTE
Your vehicle is equipped with an electronic immobilizer.
To start the electric motor unit, the ID code which the
transponder inside the key sends must match the one
registered to the immobilizer computer.
(Refer to “Electronic immobilizer” on page 3-3.)ACC power auto-cutout function
N00573800021
After about 30 minutes has elapsed with the electric motor
switch in the “ACC” position, the function automatically cuts
out the power for the audio system and other electric devices
that can be operated with that position.
When the electric motor switch is turned from the “ACC” posi-
tion, the power is supplied again to those devices.NOTE
It is possible to modify functions as follows:
• The ACC power auto-cutout function can be deactivated
by a certified i-MiEV dealer.To remove the key
N00571600025
When removing the key, first set the selector lever to the “P”
(PARK) position, and then turn the key to the “LOCK” position
and remove it.
BK0140800US.book 30 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-31
3
Key reminder buzzer
N00571700013
If the driver’s door is opened while the electric motor switch is
in the “LOCK” or “ACC” position, a tone will sound.
CAUTION
!
Do not remove the key from the electric motor
switch while driving. The steering wheel will lock,
causing loss of control.
If the ready indicator is turned off while driving, the
power brake booster will stop functioning and brak-
ing efficiency will be reduced. Also, the power steer-
ing system will not function and it will require
greater effort to manually steer the vehicle.
Do not leave the key in the “ON” position for a long
time when the electric motor unit is not running.
This will cause the 12V starter battery to run down.
BK0140800US.book 31 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-32 Features and controls
3Steering wheel lock
N00512500209
To l o c kRemove the key at the “LOCK” position.
Turn the steering wheel until it is locked.To unlockTurn the key to the “ACC” position while moving the steering
wheel slightly.
NOTE
If the front wheels are turned, the anti-theft lock may
sometimes make it difficult to turn the key from “LOCK”
position to “ACC” position. Firmly turn the steering
wheel to the left or to the right as you turn the key.
CAUTION
!
Remove the key when leaving the vehicle.
If your vehicle needs to be towed, turn the key to the
“ACC” position to unlock the steering wheel.
BK0140800US.book 32 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-33
3 Starting the electric motor unit
N00571800014
1. Make sure all occupants are properly seated with seat
belts fastened.
2. Insert the key.
3. Make sure the parking brake is applied.
4. Press and hold the brake pedal down with your right foot.
5. Make sure the selector lever is in the “P” (PARK) posi-
tion.
6. Turn the key to the “ON” position and make certain that
all warning lights are functioning properly before starting
the electric motor unit.
7. Turn the key to the “START” position for one to two sec-
onds, and slowly return it to its original position. When
you hear the startup sound and the ready indicator comes
on, startup of the electric motor unit is complete.Electric motor reminderIf the driver’s door is opened while the key is in the “ON” posi-
tion, the electric motor reminder buzzer sounds intermittently
to remind the key is in the electric motor switch.
Transmission
N00513200203
Selector lever operation
N00513800371
CAUTION
!
Never attempt to start the electric motor unit by
pushing or pulling the vehicle.
While depressing the brake pedal, move the selector
lever through the gate.
Move the selector lever through the gate.
BK0140800US.book 33 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-37
3
Operation of the transmission
N00514500359
Waiting
N00515000087
For short waiting periods, such as at traffic signals the vehicle
can be left in selector lever position and held stationary with
the service brake.
For longer waiting periods with the electric motor unit running,
place the selector lever in the “N” (NEUTRAL) position and
apply the parking brake, while holding the vehicle stationary
with the service brake.
Parking
N00515100075
To park the vehicle, first bring it to a complete stop, fully
engage the parking brake, and then move the selector lever to
the “P” (PARK) position.
If you are going to leave the vehicle unattended, always switch
off the electric motor unit and carry the key.NOTE
On a slope, be sure to apply the parking brake before
moving the selector lever to the “P” (PARK) position. If
you move the selector lever to the “P” (PARK) position
before applying the parking brake, it may be difficult to
disengage the selector lever from the “P” (PARK) position
when next you drive the vehicle, requiring application of a
strong force to the selector lever to move from the “P”
(PARK) position.
CAUTION
!
Before selecting a position with the electric motor
unit running and the vehicle stationary, fully
depress the brake pedal to prevent the vehicle from
creeping.
The vehicle will begin to move as soon as the trans-
mission is engaged, the brakes should only be
released when you are ready to drive away.
Depress the brake pedal with the right foot at all
times.
Using the left foot could cause driver movement
delay in case of an emergency.
Operating the accelerator pedal while the other foot
is resting on the brake pedal will affect braking effi-
ciency and may cause premature wear of brake
pads.
CAUTION
!
Never hold the vehicle stationary on a hill with the
accelerator. Always apply the parking brake and/or
service brake.
BK0140800US.book 37 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-44 Features and controls
3Electric power steering system (EPS)
N00568400045
The electric power steering system (EPS) operates while the
electric motor unit is running.
The EPS uses an electric motor to assist the turning of the
steering wheel.
The EPS has mechanical steering capability in case the power
assist is lost. If the power assist is lost for some reason, you
will still be able to steer your vehicle. If the power assist is lost,
you will notice it takes much more effort to steer and that there
is much more “free play” in the steering wheel. If this happens,
take your vehicle to a certified i-MiEV dealer.NOTE
During repeated full-lock turning of the steering wheel
(for example, while you are maneuvering the vehicle into
a parking space), a protection function may be activated to
prevent overheating of the power steering system. This
function will make the steering wheel gradually harder to
turn. In this event, limit your turning of the steering wheel
for a while. When the system has cooled down, the steer-
ing effort will return to normal.
Rear
WA R N I N G
!
Do not turn the key from the ON position while the
vehicle is moving. Stopping the electric motor unit
would make the steering wheel extremely hard to
turn, possibly resulting in an accident.
BK0140800US.book 44 ページ ２０１１年９月２９日　木曜日　午後３時２８分