charging MITSUBISHI iMiEV 2012 1.G Manual Online

3-70 Features and controls
3
NOTE
If the energy level gauge shows 0 bars during use of the
air conditioning, the cooling or heating may stop opera-
tion and the mode is changed to fan only.

If the energy level gauge shows 0 bars, the power down
warning light is illuminated to control the output.

If the energy level gauge shows 2 bars while the main
drive lithium-ion battery is being charged, the warning
indicator flashes. If the energy level gauge shows 1 bar
while the main drive lithium-ion battery is being charged,
the warning indicator and the charging bars flash alter-
nately.
BK0140800US.book 70 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-71
3 Indicator and warning light package
N00519800836
1- Low energy warning indicator → P.3-69
2- Selector lever position indicator → P.3-34
3- Acoustic Vehicle Alerting System (AVAS) indicator
→ P.3-38
4- High-beam indicator → P.3-72
5- Turn-signal indicators/Hazard warning lights → P.3-72
6- Position indicator → P.3-72
7- Front fog light indicator (if so equipped) → P.3-72
8- Service reminder → P.3-63
9- Outside air temperature warning indicator → P.3-67
10- Regenerative brake system indicator → P.3-72
11- Ready indicator → P. 3 - 7 2
12- Tire pressure monitoring system warning light → P.3-50
13- 12V starter battery charging system warning light → P.3-7414- Electric power steering system warning light → P.3-45
15- Electric motor unit warning light → P.3-75
16- Brake warning light → P.3-73
17- Anti-lock braking system warning light → P.3-42
18- Power down warning light → P.3-75
19- Active stability control (ASC) indicator → P.3-48
20- Active stability control (ASC) OFF indicator → P.3-48
21- Charging indicator → P.3-72
22- Theft-alarm indicator → P.3-18
23- Door-ajar warning light → P.3-74
24- Driver ’s seat belt reminder/warning light → P.2-17
25- Supplemental Restraint System (SRS) warning light
→ P. 2 - 2 2
BK0140800US.book 71 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-72 Features and controls
3Indicators
N00519900127
Turn signal indicators/Hazard warning lights
N00520000232
The arrows will flash in time with the corresponding exterior
turn signals when the turn signal lever is used.
Both arrows will flash when the hazard warning flasher switch
is pressed.NOTE
If the indicator flashes faster than usual or if the indicator
stays on without flashing, check for a malfunctioning turn
signal light bulb or turn signal connection.High beam indicator
N00520100086
A blue light comes on when the headlights are on high beam.Front fog light indicator
(if so equipped)
N00520200221
This indicator comes on while the front fog lights are on.Position indicator
N00551300039
This indicator turns on while the position lights are on.Ready indicator
N00573200012
This indicator comes on when the electric motor switch is
turned to “START” and driving becomes possible.
Charging indicator
N00573300013
This indicator flashes when the regular charging cable or quick
charging cable is connected.
After that, the light switches to being illuminated when charg-
ing starts and goes out when charging is completed.Regenerative brake system indicator
N00573400014
The indicator comes on when the regenerative brake perfor-
mance may be weakened. In this case, drive the vehicle at a
lower speed.
BK0140800US.book 72 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-74 Features and controls
3
12V starter battery charging system warning
light
N00573500028
This light will illuminate when there is a problem with the
charging system for the 12V starter battery.
Normally, when the electric motor switch is turned to the “ON”
position, this light will illuminate. Then, when the electric
motor unit is started and the ready indicator illuminates, the
light will go out.
Door-ajar warning light and buzzer
N00520900316
This light comes on when any door or liftgate is open or not
completely closed.
When the vehicle is moving at more than 5 mph (8 km/h) and
any door or liftgate is open or ajar, a tone will sound 16 times
and the warning light will flash 16 times to inform the driver
that a door or liftgate is not properly shut.NOTE
The flashing of the warning light and the buzzer can be
disabled.
For further details, please contact a certified i-MiEV
dealer.

When the driver’s door is open, the door-ajar warning
buzzer does not sound because the electric motor
reminder sounds instead.
CAUTION
!
If the warning light stays on after the ready indica-
tor illuminates, there may be a problem with the
charging system for the 12V starter battery.
• Immediately park your vehicle in a safe place and
contact a certified i-MiEV dealer.
• Do not charge the 12V starter battery.
CAUTION
!
Before driving, make sure that the door-ajar warn-
ing light is off.
BK0140800US.book 74 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-2 For emergencies
6If the vehicle breaks down
N00836300220
If your vehicle breaks down on the road, move to the shoulder
and turn on the hazard warning flashers. If there is no shoulder,
or the shoulder is not safe, drive in the right lane slowly, with
the hazard lights flashing, until you come to a safe stopping
place. Keep the flashers flashing.
If the ready indicator light goes out while driving, the brakes
and steering will continue to work, but without power assist, so
more effort will be required for braking and steering. Stop the
vehicle on the shoulder of the road and turn on the hazard
warning flashers.
Jump-starting
N00836400739
If the electric motor unit cannot be energized because the 12V
starter battery is weak or dead, you can start it with the battery
from another vehicle using jumper cables. NOTE
Do not use jumper cables if they have damage or corro-
sion.
1. Take off any metal jewelry such as watch bands or brace-
lets that might make an accidental electrical contact.
WA R N I N G
!
To reduce the risk of igniting flammable gas that
may be emitted from the 12V starter battery, care-
fully read this section before jump-starting the vehi-
cle.
Do not try to start the electric motor unit by pushing
or towing the vehicle. This can cause an accident
resulting in serious injury or death and can damage
the vehicle.
CAUTION
!
Do not attempt jump starting the 12V starter bat-
tery while the main drive lithium-ion battery is
being charged. Doing so could damage the vehicle or
charging equipment.
BK0140800US.book 2 ページ ２０１１年９月２９日　木曜日　午後３時２８分

For emergencies
6-5
6
10. Check if the ready indicator illuminates.
[When the ready indicator illuminates]
Stop the engine of the other vehicle, and disconnect the
cables in the reverse order and keep the electric motor
switch in the ON position to charge the 12V starter battery
for more than 30 minutes.
After the 12V starter battery is charged, continue the pro-
cess from step 15.
[When the ready indicator does not illuminate]
Both the 12V starter battery and the main drive lithium-
ion battery have gone flat at the same time.
Charge the 12V starter battery and the main drive lithium-
ion battery by following steps from steps 11 to 13.
11. Keep the jumper cables to each vehicle connected and
turn the electric motor switch of your vehicle to the
“LOCK” position.NOTE
The jumper cables need to be connected to the 12V starter
battery when you start charging the main drive lithium-ion
battery because the on board charger etc. operate utilizing
power from the 12V starter battery.
12. Charge the main drive lithium-ion battery by regular
charging. The 12V starter battery is automatically charged
while charging the main drive lithium-ion battery. (Refer
to “Regular charging” on page 1-20.)13. When the charging indicator on the instrument cluster is
illuminated, stop the engine of the other vehicle and dis-
connect the jumper cables in the reverse order.
NOTE
When the regular charge connector is connected to the
charge port, the charging indicator will blink. When
charging has started, the charging indicator will illumi-
nate.

The 12V starter battery will automatically charge while
the main drive lithium-ion battery is charging.
14. Charge the main drive lithium-ion battery for more than 1
hour.
15. Disconnect the charging cable.
(Refer to “Regular charging” on page 1-20.)
BK0140800US.book 5 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-6 For emergencies
6
16. Turn the electric motor switch to the “START” position,
make sure that the ready indicator on the instrument clus-
ter is illuminated.
If the ready indicator does not illuminate, perform the pro-
cedure again starting from step 5. If charging cannot be
performed, consult a certified i-MiEV dealer.
17. Refit the battery cover. (“Checking 12V starter battery
electrolyte level” on page 7-14.)
Charging the 12V starter battery by using an
external battery charger
WA R N I N G
!
Always remove the 12V starter battery from your
vehicle when the 12V starter batter is charged by an
external battery charger.
Keep sparks, cigarettes and flames away from the
12V starter battery because the battery may
explode.
Keep your work area well vented when charging or
using the 12V starter battery in an enclosed space.
Remove all the caps before charging the 12V starter
battery.
Electrolyte (battery acid) is corrosive diluted sul-
phuric acid. If electrolyte comes in contact with your
hands, eyes, clothes, or the painted surface of your
vehicle, thoroughly flush with water. If electrolyte
gets in your eyes, flush them immediately and thor-
oughly with water, and get prompt medical atten-
tion.
Always wear protective clothing and goggles when
working near the battery.
Keep the battery out of the reach of children.
BK0140800US.book 6 ページ ２０１１年９月２９日　木曜日　午後３時２８分

For emergencies
6-7
6
As your vehicle has anti-lock brakesIf you drive your vehicle with a low battery charge, after the
electric motor unit has been started by using jumper cables, it
can cause the anti-lock braking system warning light to illumi-
nate. This is only due to the low battery voltage. It is not a
problem with the brake system. If this happens, fully charge the
12V starter battery and ensure the charging system is operating
properly.
Tire repair kit
N00836600366
This vehicle is equipped with a tire repair kit which can be
used to repair a minor puncture in tread area caused by a nail,
screw or similar object. A spare tire is not provided with this
vehicle.
WA R N I N G
!
The tire repair kit may not permanently seal a punc-
tured tire.
Using the tire repair kit may damage the wheel
and/or the tire inflation pressure sensor for the tire.
The vehicle must promptly be inspected and
repaired by a certified i-MiEV dealer after using the
tire repair kit.
Use only the Mitsubishi genuine tire repair kit. Seal-
ant in other repair kits may not sufficiently seal the
tire puncture.
BK0140800US.book 7 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-3
7
Have you purchased the Mitsubishi Motors Diamond Care Pro-
tection Plan? The Plan supplements your new vehicle warran-
ties. See a certified i-MiEV dealer for details.
WA R N I N G
!
When servicing the vehicle, make sure that the elec-
tric motor switch is in the “LOCK” position and the
charging cable is disconnected. Failure to do so
could result in an electric shock.
When checking or servicing under the hood or the
coolant reserve tank, be sure the electric motor unit
is stopped and it has had a chance to cool down.
If you need to work under the hood with the electric
motor unit on, be careful that your clothing, hair,
etc. does not get caught in the fan or other moving
parts.
The fan can turn on automatically even if the elec-
tric motor unit is not running. Turn the electric
motor switch to the “LOCK” position to be safe
while you are working under the hood.
Do not smoke or allow open flames around the 12V
starter battery.
Be extremely careful when working around the 12V
starter battery. It contains poisonous and corrosive
sulfuric acid.
Handling your vehicle’s parts and materials in the
wrong way can injure you. Ask a certified i-MiEV
dealer if you have questions.
CAUTION
!
The components inside the electric motor unit room
may be very hot to the touch.
Make sure all components have sufficiently cooled
before beginning an inspection.
These components are affixed with a label indicating
precautions for handling. Follow the instructions on
the label.
When replacing the 12V starter battery, remove the
positive (+) and negative (-) terminals after turning
the electric motor switch to the “LOCK” position
and waiting at least 2 minutes. If the 12V starter
battery terminal is removed just after the electric
motor switch is turned to the “LOCK” position, this
may cause damage to electric components.
If the electric motor unit warning light illuminates,
do not replace the 12V starter battery. Contact a
certified i-MiEV dealer.
BK0140800US.book 3 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-15
7
During cold weather
N00901600057
The 12V starter battery is weaker in cold temperatures. This
has to do with its chemical and physical properties and is why a
very cold 12V starter battery, especially one with a low charge,
will have a hard time starting your vehicle.
It is recommended that you have your 12V starter battery and
charging system checked by a certified i-MiEV dealer before
the start of cold weather. If necessary, have it charged. This
will guarantee more reliable starting, and longer 12V starter
battery life.

Electrolyte (battery acid) is made of corrosive
diluted sulfuric acid. If it spills on nearby parts, it
can crack, stain, or discolor them. And if gets on
your skin or in your eyes, it can cause burns or
blindness. Please observe the following handling
instructions:
• If electrolyte gets on plastic parts or other nearby
parts, wipe it off with a soft cloth or chamois
soaked in a solution of water and neutral detergent
then immediately rinse the affected parts with
plenty of water.
• If electrolyte gets on your hands or clothes, rinse
thoroughly with water. If electrolyte gets in your
eyes, flush them with water immediately and get
immediate medical attention.WA R N I N G
!
BK0140800US.book 15 ページ ２０１１年９月２９日　木曜日　午後３時２８分