adding oil MITSUBISHI L200 2004 Owner's Manual (in English)

FOR EMERGENCIES
4. Check the coolant level in the reserve
tank. If there is none, make sure that
the engine has cooled down before
removing the radiator cap, because
hot steam or boiling water otherwise
will gush from the filler port and may
scald you.
5. Add coolant to the radiator and/or
reserve tank if necessary (refer to the
“Maintenance” section).
CAUTIONAdding cold water rapidly when the
engine is hot could cause the cylin-
der head and/or block to crack, add
the water a little at a time while run-
ning the engine.
Bleeding the fuel system
(diesel-powered vehicles
only)
EN07A-La
The fuel system should be bled to remove
air as described below if the fuel supply is
exhausted during travel.
1. Loosen the air plug (A) at the top of
the fuel filter. 6. Examine the radiator hoses for
coolant leakage and the fan belts for
looseness or damage.
If there is anything wrong with the
cooling system or fan belt, have the
problem corrected at an authorized
MITSUBISHI dealer.
8-25
M36A003N07A007
A
08engL2_240082_4 22-01-2004 13:10 Page 8-25