check transmission fluid MITSUBISHI LANCER EVOLUTION IV 1998 Workshop Manual

MANUAL TRANSMISSION OVERHAUL – Sealants and Adhesives22B-5
SEALANTS AND ADHESIVES
TRANSMISSION
ItemsSpecified sealants and adhesives
Clutch housing-transmission case mating surfaceTHREEBOND 1216
Control housing-transmission case mating surface
Under cover-transmission case mating surface
Air breatherTHREEBOND 1501
Center differential drive gear boltTHREEBOND 1303 or LOKTITE 648
TRANSFER
ItemsSpecified sealants and adhesives
Air breatherTHREEBOND 1501
FORM-IN-PLACE GASKET
The transmission has several areas where the form-in-place gasket (FIPG) is in use. To ensure that
the gasket fully serves its purpose, it is necessary to observe some precautions when applying the gasket.
Bead size, continuity and location are of paramount importance. Too thin a bead could cause leaks.
Too thick a bead, on the other hand, could be squeezed out of location, causing blocking or narrowing
of the fluid feed line. To eliminate the possibility of leaks from a joint, therefore, it is absolutely necessary
to apply the gasket evenly without a break, while observing the correct bead size.
DISASSEMBLY
The parts assembled with the FIPG can be easily disassembled without use of a special method. In
some cases, however, the sealant between the joined surfaces may have to be broken by lightly striking
with a mallet or similar tool. A flat and thin gasket scraper may be lightly hammered in between the
joined surfaces. In this case, however, care must be taken to prevent damage to the joined surfaces.
SURFACE PREPARATION
Thoroughly remove all substances deposited on the gasket application surfaces, using a gasket scraper
or wire brush. Check to ensure that the surfaces to which the FIPG is to be applied is flat. Make sure
that there are no oils, greases and foreign substances deposited on the application surfaces. Do not
forget to remove the old sealant remaining in the bolt holes.
FORM-IN-PLACE GASKET APPLICATION
Applied FIPG bead should be of the specified size and without breaks. Also be sure to encircle the
bolt hole circumference with a completely continuous bead. The FIPG can be wiped away unless it is
hardened. While the FIPG is still moist (in less than 10 minutes), mount the parts in position. When
the parts are mounted, make sure that the gasket is applied to the required area only. In addition, do
not apply any oil or water to the sealing locations or start the engine until a sufficient amount of time
(about one hour) has passed after installation is completed.
The FIPG application procedure may vary on different areas. Observe the procedure described in the
text when applying the FIPG.