power steering fluid MITSUBISHI LANCER EVOLUTION IX 2005 Workshop Manual

MPI – GENERAL13A-2
MPI system diagram
Engine ECU
H1. O
2 sensor
H2. Air flow sensor
H3. Intake air temp.
sensor
H4. Throttle position
sensor
H5. Intake Cam position
sensor
H6. Exhaust Cam
position sensor
H7. Crank angle
sensor
H8. Atmospheric
pressure sensor
H9. Water temp.
sensor
H10. Knock sensor
H11. Manifold absolute
pressure (MAP)
sensor
H12. Air temp. sensor• Power supply
• Ignition switch IG
• Ignition switch ST
• Vehicle speed
sensor
• A/C switch
• A/C load signal
• Power steering
fluid pressure switch
• Alternator FR signal
• Inter-cooler water spray
switch (auto)
•Inter-cooler water spray
switch (manual)I1. Injector
I2. ISC servo (Stepper
motor)
I3. Fuel pressure
control solenoid valve
I4. No. 1 Waste gate
solenoid valve
I5. No. 2 Waste gate
solenoid valve
I6. Purge control
solenoid valve
I7. Secondary air
control solenoid valve
I8. Oil feeder control
valve• Engine control relay
• Fuel pump relay 2,3
(ON/OFF)
• Fuel pump relay (HI/LO
switch)
• A/C relay
• Ignition coil
• Fan controller
• Condenser fan relay (HI)
• Condenser fan relay
(LO)
• Engine warning light
• Diagnosis output
terminal
• Alternator G terminal
• Inter-cooler water spray
relay
•Inter-cooler water spray
lamp
• O
2sensor heater
ÈÈ
I 6. Purge control
solenoid valve
I 7. Secondary
air control
solenoid valveCheck
valve
Secondary air
valve
To fuel
tank
H 6. Exhaust cam
position sensor
H 8. Atmospheric
pressure sensor
H 2. Air flow sensor
Intake
Waste gate actuator
I 4. No.1 waste gate
solenoid valve H 3. Intake air
temperature
sensor
I 5. No.2 waste gate
solenoid valve
H 1. O
2sensor
H 5. Intake cam
position sensorCatalyst
H 7. Crank angle sensor
H 10. Knock sensor
H 9. Water temperature sensor
I 1. Injector From fuel
pump
Fuel pressure
regulatorI 8. Oil feeder control
valve I 3. Fuel pressure
control solenoid
valve
Vacuum
tank
I 2. ISC servoH 11. MAP sensor
H 12. Air temperature sensor
H 4. Throttle
position
sensor
From fuel tank
Canister
By-pass valve

LAYOUT DIAGRAMS - ENGINE COMPARTMENT1-5
A-31 (2-black) Front ABS sensor (RH)
A-32 (4-black) Dummy connector
A-33 (4-black) Headlamp ASSY (LH) (except discharge
headlamps)
(8-black) Headlamp ASSY (LH) (discharge
headlamps)
A-34 (2) Intercooler water spray motor
A-35 (2-black) Fog lamp (LH)
A-36 (2-black) Condenser fan motor
A-37 (2-grey) Condenser fan motor
A-38 (1-black) Power steering fluid pressure switch
A-39 (1-black) A/C compressor (vehicle with manual
A/C, fully automatic A/C) or dummy
connector (vehicle with heater)A-40 (2-black) Fog lamp (RH)
A-41 (4-black) Headlamp ASSY (RH) (except discharge
headlamps)
(8-black) Headlamp ASSY (RH) (discharge
headlamps)
A-42 (2-brown) Dual pressure switch (vehicle with
manual A/C, fully automatic A/C) or
dummy connector (vehicle with heater)
A-52 (2-yellow) Front impact sensor (RH) (vehicle not
fitted with front passenger airbag)
A-53 (2-yellow) Front impact sensor (LH) (vehicle not
fitted with front passenger airbag)
Front harness (LH)

CIRCUIT DIAGRAMS - ENGINE CONTROL SYSTEM3-32
Engine control system (continued)
Ignition
switch (ST)
Starter
relayIdle speed
control
servo
Fuel
pressure
solenoid
valveWaste gate
solenoid
valve 1
Engine ECU
Power steering fluid
pressure switch Engine speed
detection connectorEngine control relay