trunk MITSUBISHI LANCER EVOLUTION X 2008 Workshop Manual

ANTENNA
CHASSIS ELECTRICAL54A-26
SUBWOOFER Fosgate
® PREMIUM SOUND SYSTEM>
The 25 cm dual voice coil subwoofer has been installed to the
trunk room, enabling the playback of dynamic deep bass.
ANTENNA
GENERAL INFORMATIONM2545100200163
The pole antenna has been adopted for the radio.
The antenna base incorporates the radio amplifier.
When the satellite radio tuner is installed, the
antenna base that also corresponds to the satellite
radio is installed.
CONSTRUCTION DIAGRAM
AC608344ABSubwoofer
Trunk room
AC608360
Pole antenna (for radio)
AB
Satellite radio tuner (Vehicles with satellite radio)
Antenna base

SEAT
INTERIOR52A-7
REAR SEATM2520007000605
A low-back bench seat is used for rear seat. The rear
seat offer the following advantages:
•The center armrest has a cup holder.
•An upper tether anchor has been installed on the
rear shelf trim, and an ISO-FIX lower anchor has
been installed on the body side.
AC609174
Cup holderHead restraint
vertical adjustrment
Head restraint
vertical adjustrment
Rear seatback
forward folding
AB

TRIMS
INTERIOR52A-10
TRIMS
INTERIOR TRIMSM2520012000559
•The interiors are fully covered by trims.
•The energy absorption rib molding located in the
back side of the front pillar trim and the rear pillar
trim protect head from side impacts and the resin
materials for the trims are unbreakable materials.
•Use of nonflammable materials for the trims has
increased safety as outstanding interiors. Also,
material codes are indicated to deal with recy
-
cling easily.
AC608126
Energy absorption ribFront pillar trim
(back side)
Front pillar trim
Cowl side trim Center pillar trim upper
Rear pillar trim
Front scuff plate Center pillar trim lower
Rear scuff plate
Trunk side trimRear end trim
AB
Rear shelf trim Trunk lid trim

TRIMS
TSB Revision
INTERIOR52A-10
TRIMS
REMOVAL AND INSTALLATIONM1521001101049
Required Special Tool:
•MB990784: Ornament Remover
AC610310
45
1 3
6
2 79
11
12
10
13
AB
8
14
22 ± 4 N·m
16 ± 3 ft-lb
Removal steps
1.Front scuff plate
2.Cowl side trim
•Rear seat cushion (Refer
to
P.52A-23).
3.Rear scuff plate
4.Front door opening trim
5.Rear door opening trim
<>6.Front pillar trim
7.Lower center pillar trim
8.Upper center p illar trim cap
•Outer seat belt (Refer toP.52A-28).
9.Upper center pillar trim
10.Rear pillar trim
•Seat side back (Refer toP.52A-23).
11 .Rear shelf trim
12.Rear end trim
13.Trunk side trim
14.Child restraint fitting
Removal steps (Continued)