ECU MITSUBISHI OUTLANDER 2010 2.G User Guide

Seat and restraint systems
2-21
2
To stow the third row seatNOTE

Before stowing the third row seat, make sure that there is
no luggage in the storage area. Storing the seat with lug-
gage in the storage area could damage the seat.
1. Open the tailgate. Refer to “Flap-fold tailgate” on page 3-
60.
2. From the rear of the vehicle, pull up the cover (A).
Secure the cover to the seatback with the strap (B).3. For each head restraint, while tilting the head restraint
backward, slide the knob (C) and fold the head restraint
forward.
BK0115300US.book 21 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-23
2
NOTE

Push down so that the backside of the third row seat is
firmly secured to the floor.


If it is difficult to lock the seat in place, return the third
row seat to its original position, and then lock it in place
by pushing down while pulling with more force on the
strap, so that the back end of the third row seat touches the
floor.5. Tilt the seat assembly forward.
BK0115300US.book 23 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-24 Seat and restraint systems
2
NOTE

Before folding the seatback down, make sure that the
front side of the third row seat is firmly secured to the
floor.


If it is difficult to secure the front side of the seat, make
sure that the backside of the third row seat is firmly
secured to the floor and then tilt the seat assembly forward
with more force to secure it in place.6. While pulling on the strap (F) on the center of the seat-
back, fold the seatback down.
7. Set the cover back in place.
BK0115300US.book 24 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-28 Seat and restraint systems
2Making a cargo area
N00405500091
NOTE

When the seatback of a front seat is reclined, return it to
the upright position before driving.
WA R N I N G
!

Never adjust the seats to make a cargo area when
the vehicle is in motion or on a slope. The seats could
move more than necessary or move suddenly and
cause a serious accident.


After folding up a seat or returning a seat back to its
normal position, make sure that the seat is firmly
secured. If the seat is not secured, it could move and
cause a serious accident.


Do not allow anyone to ride in the cargo area while
the vehicle is in motion. People who are not properly
seated and restrained can be seriously injured or
killed in an accident.


The front passenger seat is equipped with weight
sensors. Depending on the weight detected, the front
passenger airbag is disabled or enabled. When fold-
ing the second row seats forward for increased cargo
capacity, the front passenger seat and seat back
must be adjusted to assure they are not contacting
the second row seat. In the event the front seat or
seatback is allowed to contact the folded second row
seat, proper operation of the front passenger airbag
system may be affected.
CAUTION
!

In the cargo area, do not load the luggage higher
than the top of the seats and make sure that the lug-
gage is firmly secured. Restricted rear vision or fly-
ing objects entering the passenger compartment
during sudden braking could result in a serious acci-
dent.


Seats should always be folded up and put back into
the normal position by an adult. Seat adjustments
by a child could lead to an unexpected accident.


When adjusting the seats, be careful not to catch
your hand or leg. Personal injury could result.
BK0115300US.book 28 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-30 Seat and restraint systems
2
3. For vehicles with 2nd row seat slide function, the seatback
will fall forward and the entire seat will flip up as it slides
forward.For vehicles without 2nd row seat slide function, the seat-
back will fall forward. Lift the entire seat until you hear a
click.
4. After folding the seat, gently shake the folded seat to
make sure it’s firmly secured.
WA R N I N G
!

When folding the second row seat, make sure no one
is on the seat. The seatback will fall forward rapidly
and could cause serious injury.
BK0115300US.book 30 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-33
2
3. While pulling on the lock release strap on the back of the
seatback, raise up the seatback.
4. After returning the seatback to its normal position, gently
shake the seat and seatback to make sure they are firmly
secured.5. Raise all head restraints to the highest position.
Refer to “Head restraints: Adjustment of the head restraint
height” on page 2-25.
WA R N I N G
!

After returning the seat to its normal position, raise
all head restraints on the second row seat to the
highest position. Using the second row seat with the
head restraints retracted could cause a serious head
injury or death in the event of a collision or sudden
breaking.
BK0115300US.book 33 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-34 Seat and restraint systems
2Making a flat seat
N00404800143
The entire interior of the vehicle may be used for sleeping
accommodations by removing the head restraints and fully
reclining all the seats when the vehicle is stopped.
WA R N I N G
!

Never drive with passengers or cargo on the flat
seat. This is extremely dangerous and can cause
severe or fatal injury or death in an accident or if
heavy braking is required.CAUTION
!

Adjust the seats only when the vehicle is stopped in a
safe place.


Seat should be adjusted only by adults to avoid acci-
dents.


When sliding the seats, be careful not to catch your
hand or leg.


Do not walk around on top of the seats after they
have been laid flat because the footing is uneven. It
is safest to move about on your hands and knees.


To ensure the seats are locked securely, attempt to
move them back and forth.


Do not jump on or drop heavy objects on the seat-
backs.


To raise the seatback, firmly place your hand on the
seatback, pull the seatback lock knob up, and raise
the seatback slowly. (Refer to “To adjust the seat-
back” on page 2-8 and page 2-13.) Do not let chil-
dren adjust the seatback.CAUTION
!
BK0115300US.book 34 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-40 Seat and restraint systems
2
2. Grasp the latch plate and slide it up the webbing so that it
easily pulls across your body. 3. Pull the seat belt out slowly while holding the latch plate.
Push the latch plate into the buckle until you hear a
“click”. Pull up on the belt to be sure the latch plate is
locked securely in the buckle.
NOTE

If the seat belt locks up and cannot be pulled out, pull it
once with force and let it retract all the way.
Then, pull the belt out slowly once again.
BK0115300US.book 40 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-42 Seat and restraint systems
2
Driver’s seat belt reminder/warning light and
display
N00418400313
Warning light
Warning display type 1
Warning display type 2
A tone and warning light are used to remind the driver to fasten
the seat belt.
If the ignition switch is set to the “ON” position without the
driver’s seat belt being fastened, a warning light will come on
and a tone will sound for approximately 6 seconds to remind
you to fasten your seat belt.
If you then drive with the seat belt unfastened for longer than a
minute from when the ignition switch was turned on, the warn-
ing light will come on and blink repeatedly and the tone will
sound intermittently.
The warning light and the tone will stop after approximately 90
seconds.If you then repeatedly stop and start your vehicle with the seat
belt unfastened, the warning light/display and tone will remind
you to fasten your seat belt every time the vehicle starts mov-
ing. You will also be reminded to fasten your seat belt in this
way when you remove your seat belt while driving. The warn-
ing light and the tone go off when the seat belt is fastened.
NOTE

At the same time, “FASTEN SEAT BELT” will be dis-
played on the information screen in the multi-information
display.
WA R N I N G
!

In order to reduce the risk of serious injury or death
in an accident, always fasten your own seat belt. Do
not allow anyone to ride in your vehicle unless he or
she is also seated and fastening a seat belt. Children
should additionally be restrained in a secure child
restraint system.
BK0115300US.book 42 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-44 Seat and restraint systems
2
Storing the second row and third row seat belts
N00406500098
When a second row seat belt (except for the center seat belt) or
a third row seat belt is not in use, store it as shown in the illus-
tration.
WA R N I N G
!

Always adjust the shoulder belt anchor so that the
shoulder belt is positioned across the center of your
shoulder without touching your neck. The shoulder
belt should not be able to fall off your shoulder. Fail-
ure to follow this instruction can adversely affect
seat belt performance and increase the risk of seri-
ous injury or death in the event of an accident.


Adjust the shoulder belt anchor only when the vehi-
cle is not in motion.


Make sure the anchor is securely locked in position
after adjusting it.
A- Second row seat belt
B- Third row seat belt (Seating 7 passengers)
BK0115300US.book 44 ページ ２００９年７月１６日　木曜日　午前９時１３分