light MITSUBISHI OUTLANDER 2011 2.G MMCS Manual

GPS Measurement 1-9
IntroductionSituations where errors occur in the current
location and direction
GPS satellite unit is poor.
States Department of Defense, so sometimes the
satellite itself intentionally sends incorrect position
data. The measurement error will increase in this
kind of situation.
because the distribution of the GPS satellites is poor
(when the satellites are aligned in approximately the
same direction or height). (The best accuracy for
GPS measurement is when signals are received from
multiple satellites; a satellite directly over the vehicle
and others just over the horizon to the north, south,
east and west.)
GPS measurement, errors are slightly more likely in
the horizontal direction.
vehicle height can be received, but electromagnetic
waves cannot physically be received from satellites
positioned lower than the vehicle height (on the far
side of the Earth). This means that an adequate
height comparison is not possible.
3D MeasurementWhen valid electromagnetic waves can be received
from at least four GPS satellites, the 3D positions of
latitude, longitude and height are calculated.
2D MeasurementWhen valid electromagnetic waves can only be
received from three or less GPS satellites, the height
is assumed to be unchanged from the previous
measurement and the 2D positions of latitude and
longitude are calculated. If this happens, the accuracy
of the position is less than with the 3D measurement.
No MeasurementIf no valid electromagnetic waves can be received from
the GPS satellites, there is no measurement.
\b \b
\f \


 \b
\b \f

Starting the MMCS 2-2
Operation Instructions
With this navigation system, operations
can be performed by pressing the panel
keys or touching the screen buttons.
Operate the screen by touching lightly with
a ngertip.
mb447
WARNING

operations or concentrate on the screen. Failure to
pay attention to the road ahead may cause traf c
accidents. Have a front seat passenger perform
the operations, or stop the car in a safe location
before operating.
NOTEit with hard, sharp objects, as this may cause
malfunction.
The Screens in this ManualThe screens described in this manual are for
explanation. They may be different from actual
screens, and their operation may also be different.
Lists
This section explains the list operation
buttons when a list has been displayed.
Scrolls forward through a list one line at
a time.
Scrolls forward through a list one page
at a time.
Scrolls back through a list one line at a
time.
Scrolls back through a list one page at
a time.
\b \b
\f \

  \b
\b \f

Editing a Location 5-5
Address Book
5 Touch [Set to Address Book]
eng_a136The information change is completed.
Deleting
Deleting a stored location.

1 Touch [Delete] of “Address
Book” in the Personal Settings screen

2 Touch the stored location to delete
eng_a137
NOTE
displayed with a black highlight.
Touch a location again to remove it from the deletion target.

same time.
3 Touch [Done]
eng_a138
4 Touch [Yes]
eng_a139The selected stored locations are deleted.
\b \b
\f \

   \b
\b
 \f

Disk Handling 7-5
Audio
Correct Disk Handling
Handling Precautions
fingerprints or other dirt, the disk may become
unreadable. When holding a disk, do not touch the
signal surface. Gently pinch both edges of the disk,
or hold by the center hole and one edge.
the disk.
disk is already inserted. This may scratch or damage
the disks.
Maintenanceuse a soft cloth to wipe gently from inside to outside,
without rotating the disk.
and around the circumference of new disks. Using
a disk with residue may cause malfunction, so use a
ballpoint pen, etc., to clean away the residue.
Storage Precautionscases and store out of direct sunlight.
from the device.
Disk Playback Environmentimmediately after turning on the vehicle heater may
cause malfunction due to condensation (water
droplets) forming on the optical parts of the device,
or on the disk. In such cases, remove the disk and
wait a while before use.
malfunction.
Copyrightperformance, or rental of disks is prohibited by law.
and Macrovision and other copyright holders are
protected by the patent laws of the United States
and other intellectual property rights.
authorization from Macrovision. Further, without
special authorization from Macrovision, use is
restricted to the home and other private appreciation.
\b \b
\f \

   \b
\b

\f

Adjusting the Screen 11-1
Settings
Setting
Adjusting the Screen
Adjustments related to the screen display.
Display Off
Turns OFF the monitor display.

1 Press the [SET] key, and touch
[Display Off]
eng_a018-2
eng_a161The monitor display is turned OFF.
NOTEAt this time, although the navigation voice guidance
will be switched off, the AV audio will remain on.

screen, or press any key.
Picture Control
Adjustments related to the picture quality.

1 Press the [SET] key, and touch
[Picture Control]
eng_a018-2
2 Touch [ - ] or [ + ] for “Brightness”,
“Contrast”, or “Black Level” to adjust
eng_a162
NOTE“Brightness” can be adjusted with headlights ON and
OFF separately.

picture quality
while a DVD image
is displayed,
“Tint” and “Color
Intensity” can also
be adjusted.
eng_a231
3 Touch [Back]The picture quality adjustment is completed.
Screen Size
Switches between Screen Size and other
displays for DVD image etc..

1 Press the [SET] key, and touch
[Screen Size]
eng_a163-2
2 Touch one of the following buttons
eng_a232
[Normal] Displays the screen in normal 4:3 aspect
ratio.
[Full] Extends the display evenly both left and right in wide mode.
[Wide] Extends the left and right parts only of
the display while leaving the center as is
in wide mode.
[Zoom] Magni es the image displayed using 4:3 aspect ratio. (I.e., the top and bottom
are out of frame.)
3 Touch [Back]Screen Size switching is completed.
\b \b
\f \




 \b \b


System Settings 11-4
System Settings
The basic settings required by the navigation
function can be performed here.

1 Press the [SET] key, and touch
[System]
eng_a018-2
eng_a034-1The system settings screen is displayed.
2 Touch each item to change the
setting

3 Touch [Back]
eng_a034-1The setting change is completed.
Time
Changing the time zone.

1 Touch [Time]

2 Touch the desired zone
eng_a608
3 Touch [On] or [Off] for “Daylight
Saving Time”

4 Touch [Back]
eng_a609The time zone settings are completed, and the display
returns to the system options screen.
Language
Changing the language used by the
system.

1 Touch [Language]

2 Touch one of the languages
eng_a205
3 Touch [Back]
[English] Change to English.
[Français] Change to French.
[Español] Change to Spanish.
NOTE sides can be changed by performing operations on
either the MMCS side or the meter side.
of the meter side and the MMCS side can be set
separately.
\b \b
\f \



\b \b \b
\f

Equipment 11-7
Settings
Equipment
(if so equipped)
Set the vehicle equipment.

1 Press the [SET] key, touch
[Equipment]
eng_a018The equipment screen is displayed.
2 Touch the name of the equipment
group
eng_a237
3 Touch the item name
eng_a239
4 Touch the condition
eng_a240
5 Touch [Back]The equipment settings are completed.
Equipment Items that Can Be Set
Refer to the section titled “Features and
Controls” in the vehicle owner’s manual for
details on setting these items.
Keyless Entry System



F.A.S.T.*-key (Keyless Operation System)*:Free-hand Advanced Security Transmitter





NOTEEither “Keyless Entry System” or “Keyless Operation
System” will be displayed, depending on the equipment.
Wipers



Exterior Lights/Interior Lights


Closed
Theft Alarm
Turn Signal
Touch)
Power Door Locks


Others
\b \b
\f \



 \b \b
\f

Personal Settings 11-18
4 Touch [Set]

5 Touch [Set]
eng_a192The editing of the avoid area is completed.
DeletingDeleting a stored avoid area.
1 Touch [Delete]

2 Touch the avoid area to delete
eng_193
NOTE with a highlight.Touch a location again to remove it
from the deletion list.

same time.
display the map
of the avoid area
vicinity.
eng_a194
3 Touch [Done]
eng_a195
4 Touch [Yes]
eng_a196The deletion of the selected avoid areas is completed.
My Categories
Frequently used POI categories can be
stored in “My Categories”.
A maximum of six category items can be
stored in “My Categories”.

1 Touch [Edit]A list is displayed of all categories.
The remaining operations are the same as from “Editing
My Categories” (page 3-6).
\b \b
\f \




 \b \b
\f

Personal Settings 11-19
Settings
Delete Previous 20
Destinations from the previous 20 set
destinations can be selected and deleted.

1 Touch [Select]The delete previous 20 screen is displayed.
2 Touch the location to delete
eng_a197
NOTEa highlight.Touch a location again to remove it from
the deletion target.

time.
display a map of
the vicinity and
corresponding
information.
eng_a198
3 Touch [Done]
eng_a199
4 Touch [Yes]
eng_a200The deletion of the selected locations is completed.
Navi Voice / Others
1 Display the Navi Menu, and touch
[Navigation Settings]
eng_a502-2
2 Touch [Navii Voice / Others]
eng_a606>>>“Other Settings” (Page 11-5)
\b \b
\f \




 \b \b
\f