air conditioning MITSUBISHI OUTLANDER SPORT 2013 3.G Owners Handbook

5
The sunshade can be operated with the ignition switch or the operation mode in ON.
A


-

Pull the s
witch in the arrow direction to
open the sunshade. Pulling the switch all
the way automatically opens the sunshade
completely.
B


-

Push the s
witch in the arrow direction to close the sunshade. Pulling the switch all the way
automatically closes the sunshade completely.
C


-

Push the s
witch to stop the moving sunshade. If an object obstructs the sunshade from
closing the safety mechanism will cause the sunshade to re-open automatically. The
opened sunshade will become operational again after a few seconds.
The sunshade illumination turns on with the ignition switch or when the operation mode is in ON or ACC.
D

-

Push the s
witch to change brightness of the sunshade illumination. The brightness switches in sequence from


high → middle → low → off → high.
A

-

T
urn for Temperature control
B
-

Push t
o select outside air (Indicator light off) or recirculated air
(Indicator light on)
C
-

T
urn to select the blower speed. To the right increases blower speed. To
the left decreases blower speed. Turned all the way to the left turns the
blower off. Note: OFF is located above AUTO.
D
-

Push f
or air conditioning ON/OFF (Indicator light on/Indicator light off).
E - Turn to select the air flow and direction mode (AUTO position is only
aut

o type air conditioning).
F
-

Push t
o defog the rear window (Indicator light on). Rear window



def
ogger light automatically turns off after 20 minutes.
To defog front windshield
1.
Set the Mode Dial
E to defrost
position.
2.
Set the blo
wer speed C to the maximum position.
3.

Set the t

emperature A to highest position.
Air Conditioning (Automatic shown) The wipers will operate once.
INT: Intermittent intervals can be
adjusted by turning the knob A
AUTO: The wipers will be
operated automatically by rain
sensor (if so equipped).
Slow
FastWindshield Wipers
CONTROLS
Sunshade
Turn the knob B to operate the
rear window wiper.
The wiper operates
continuously for several
seconds then operates
intermittently at intervals of
about 8 seconds.
Washer fluid is sprayed,
the wiper will aut

omatically
operate 2 or 3 times.
Rear Window Wiper/Washer
Rain Sensing Wipers
(if equipped)
It is possible to adjust the
sensitivity of the rain sensor by
turning the AUTO ring (C).
+ Higher sensitivity to rain
— Lower sensitivity to rain
C
A
D
B
C