wheel bolts MITSUBISHI OUTLANDER SPORT 2013 3.G Owners Manual

6-14 For emergencies
6
5. Remove the wheel nuts with the wheel nut wrench, thentake the wheel off. 6. Clean out any mud, etc. on the hub surface (F), hub bolts
(G) or in the installation holes (H) in the wheel, and then
mount the spare tire.
No one should be in your vehicle when using the
jack.
Do not start or run the engine while your vehicle is
on the jack.
Do not turn the raised wheel. The tires that are still
on the ground could turn and make your vehicle fall
off the jack.
CAUTION
!
Handle the wheel carefully when changing the tire,
to avoid scratching the wheel surface.
WARNING
!
BK0150700US.book 14 ページ ２０１２年３月２２日　木曜日　午後６時４６分

6-16 For emergencies
6
[Vehicle with the flange nuts]• Aluminium wheel
Temporarily tighten the wheel nuts until their flange
section comes in contact with the wheel and it is no
longer loose. • Steel wheel
Install the wheel nuts with their tapered ends facing
inward, then tighten by hand until the wheel is no longer
loose.
NOTE
Flange nuts can be temporarily used on the compact spare
or steel wheel, but return them to the original wheel and
tire as soon as possible.

If all 4 wheels are changed to steel wheels, use tapered
nuts.
CAUTION
!
Never apply oil to either the wheel bolts or the nuts
or they will tighten too much.
BK0150700US.book 16 ページ ２０１２年３月２２日　木曜日　午後６時４６分

For emergencies6-17
6
8. Lower the vehicle slowly until the tire touches the ground,by rotating the wheel nut wrench counterclockwise. 9. Tighten the nuts in the order shown in the illustration until
each nut has been tightened to the torque listed here.
65 to 80 ft-lb (88 to 108 N•m)
10. Lower the jack all the way and remove it.
CAUTION
!
Never use your foot or a pipe extension to apply
added force to the wheel nut wrench when tighten-
ing the wheel nuts. If you do so, you can over-tighten
the wheel nuts and damage the wheel, wheel nuts
and hub bolts.
BK0150700US.book 17 ページ ２０１２年３月２２日　木曜日　午後６時４６分