wiring MITSUBISHI SHOGUN 2008 Owner's Manual (in English)

General information
7
Modification/alterations
to the electrical or
fuel systems
E00200400254
MITSUBISHI MOTORS has always manufactured safe, high quality vehicles. In order to maintain this safety and quality, it is important that any accessory that
is to be fitted, or any modi-
fications carried out which invo
lve the electrical or fuel sys-
tems, should be carried out
in accordance with MITSUBISHI
MOTORS guidelines.
Genuine parts
E00200500330
MITSUBISHI MOTORS has gone to great lengths to bring you a superbly crafted automobile offering the highest quality and dependability.Use MITSUBISHI MOTORS genuine parts, designed and manufactured to maintain your MITSUBISHI MOTORS auto- mobile at top performance. MITSUBISHI MOTORS genuineparts are identified by this mark
and are available at all MIT-
SUBISHI MOTORS Authorized Service Points.
CAUTION
!●
If the wiring interferes wi
th any part of the vehicle
bodywork or improper installation methods areused, i.e. protective fuses
not installed,
etc.), elec-
tronic devices may be ad
versely affected, possibly
resulting in an electrical
fire or other failures that
may cause an accident.
BK-BK2008E1ENUK.en-uk-Section3.fm Page 7 Wednesday, January 9, 2008 4:21 PM

2-76 Seat and seat belts
2
SRS servicing
E00407901042
WARNING
!●
If any of the following
conditions occur, the SRS
and/or seat belt pre-tensioners are not workingproperly, and we recommend you to have it inspected by a MITSUBISHI MOTORS Authorized Service Point immediately.• The SRS warning lamp do
es not illuminate when
you start the vehicle. • The SRS warning lamp does not go out after sev-eral seconds. • The SRS warning lamp illuminates while driving.
WARNING
!●
We recommend any maintenance performed on or near the components of the SRS to be performed bya MITSUBISHI MOTORS
Authorized Service
Point. Improper work on the SR
S components or wiring
could result in inadverten
t deployment of the air-
bags, or could render the SRS inoperative; either situation could result in serious injury.
●
Do not modify your steering wheel, seat belt retrac- tor or any other SRS co
mponents. For example,
replacement of the steering
wheel, or modifications
to the front bumper or body
structure can adversely
affect SRS performance and
lead to possible injury.
●
If your vehicle has received any damage, we recom- mend you to have the SRS in
spected to ensure it is in
proper working order.
●
On vehicles with the side
airbags, do not modify
your front seats, centre pillar and centre console. It can adversely affect SR
S performance and lead to
possible injury.If you found any tear scratch, crack or damage to the seat fabric near the side airbag, the portion of the front and rear pillars and roof side rail, youshould have the SRS in
spected by a MITSUBISHI
MOTORS Authorized Service Point.
BK-BK2008E1ENUK.en-uk-Section5.fm Page
76 Wednesday, January 9, 2008 4:28 PM

Maintenance
8-35
8
5. Referring to the fuse load
capacity table, check the fuse
pertaining to the problem.
NOTE●
If any system does not function but the fuse corresponding to that system is normal, ther
e may be a fault in the system
elsewhere. We recommend y
ou to have your vehicle
checked.
6. Insert a new fuse of the same capacity by using the fuse
puller and insert the fuse at
the same place in the fuse
block.
C- Fuse is OK D- Blown fuse
CAUTION
!●
If the newly inserted fuse
blows again after a short
time, we recommend you to
have the electrical sys-
tem checked to find the cause and rectify it.
●
Never use a fuse with a
capacity larger than that
specified or any substitute,
such as wire, foil, etc.;
doing so will cause the circuit wiring to heat up and could cause a fire.
BK-BK2008E1ENUK.en-uk-Section11.fm Page
35 Wednesday, January 9, 2008 4:50 PM