belt MITSUBISHI SHOGUN 2016 (in English) Owner's Guide

NOTElDepending on the seating position in the ve-
hicle and the child restraint system that you have, the child restraint can be attached us-
ing one of the following two ways:
• Use the lower anchorage in the rear seat
(3-door models) / second seat (5-door
models) ONLY if the child restraint has ISOFIX mountings (See page 4-34).
• Using the seat belt (See page 4-35).Older children
E00406700147
Children who have outgrown the child re-
straint system should be seated in the rear
seat and wear combination lap shoulder belt.
The lap portion of the belt should be snug and positioned low on the abdomen so that it
is below the top of the hip-bone. Otherwise, the belt could intrude into the child’s abdo-
men during an accident and cause injury.
Child restraint
4-28OVWE16E1Seat and seat belts4

Suitability for various ISOFIX positions
E00411401790Mass groupSize classFixture
Vehicle ISOFIX positionsRear/second OutboardLeft sideRight sideCarrycotFISO/L1XXGISO/L2XX0- Up to 10 kgEISO/R1XX0+- Up to 13 kgEISO/R1XIL*1DISO/R2XXCISO/R3XXI- 9 to 18 kgDISO/R2XXCISO/R3XXBISO/F2IUFIUFB1ISO/F2XIUF, IL* 2IUF, IL*2AISO/F3IUFIUFII- 15 to 25 kg XXIII- 22 to 36 kg XXCAUTIONl
When installing a child restraint system, remove the head restraint from the seat.
Child restraint
4-29OVWE16E1Seat and seat belts4

Key of letters to be inserted in the table above:
lIUF- Suitable for ISOFIX forward child restraints systems of universal category approved for use in the mass group.
l IL- Suitable for particular ISOFIX child restraint systems given in the following list (MITSUBISHI MOTORS genuine parts).
l X- ISOFIX position not suitable for ISOFIX child restraint systems in this mass group and/or this size class.IL (Genuine part information) Genuine part No.UN-R44 Approval No.*1MZ314393 (Child restraint system),
MZ314394 (ISOFIX base)E1-04301146*2MZ313045E1-04301133NOTEl
MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For detailed information, consult your MITSUBISHI MOTORS Authorized Service Point.

Suitability for various seating positions
E00406802546
3-door models
Mass group
Seating positionFront passengerRear outboard
Rear centre
Activated air-
bagDeactivated
Airbag #1Left sideRight side0- Up to 10 kgXXXXX0+- Up to 13 kgXL*1L*1L*1L*1
Child restraint
4-30OVWE16E1Seat and seat belts4

Mass group
Seating positionFront passengerRear outboard
Rear centre
Activated air-bagDeactivated
Airbag #1Left sideRight sideI-9 to 18 kgL*2L*2L*2L*2L*2II & III-15 to 36 kgL*3L*3L*3L*3L*3
#1
: With front passenger’s airbag deactivated by means of front passenger’s airbag ON-OFF switch.
CAUTIONl When installing a child restraint system, remove the head restraint from the seat.Key of letters to be inserted in the table above:
l
L- Suitable for particular child restraints in the following list (MITSUBISHI MOTORS genuine parts).
l X- Seat position not suitable for children in this mass group.
L (Genuine part information) Genuine parts No.UN-R44 Approval No.*1MZ314393E1-04301146*2MZ313045E1-04301133*3MZ314250E1-04301169
Child restraint
4-31OVWE16E1Seat and seat belts4

NOTElThere is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0-Up to 10 kg”.
l MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For detailed information, consult your MITSUBISHI MOTORS Authorized Service Point.5-door models
Mass group
Seating positionFront passengerRear out-
boardIntermediate OutboardIntermediate CentreActivated air- bagDeactivated
Airbag #1Left sideRight side0- Up to 10 kgXXXUUX0+- Up to 13 kgXL*1L*1U, L* 1U, L*1L*1I-9 to 18 kgL*2L*2L*2U, L* 2U, L*2L*2II & III-15 to 36 kgL*3L*3L*3U, L* 3U, L*3L*3
#1
: With front passenger’s airbag deactivated by means of front passenger’s airbag ON-OFF switch.
CAUTIONl When installing a child restraint system, remove the head restraint from the seat.
l When installing a “universal” category child restraint system on the intermediate outboard seat, adjust the seatback of the intermediate seat to its most up-
right position.
l When installing a child restraint system that’s a
MITSUBISHI MOTORS genuine part for the mass group “0+ up to 13 kg” in a rear outboard seating posi-
tion, remove the head restraint from the rear outboard seating position and tip the rear outboard seatback fully rearward.
Child restraint
4-32OVWE16E1Seat and seat belts4

Key of letters to be inserted in the table above:
lU- Suitable for “universal” category restraints approved for use in this mass group.
l L- Suitable for particular child restraints in the following list (MITSUBISHI MOTORS genuine parts).
l X- Seat position not suitable for children in this mass group.L (Genuine part information) Genuine parts No.UN-R44 Approval No.*1MZ314393E1-04301146*2MZ313045E1-04301133*3MZ314250E1-04301169NOTEl
There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0-Up to 10 kg”.
l MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For detailed information, consult your MITSUBISHI MOTORS Authorized Service Point.

Child restraint
4-33OVWE16E1Seat and seat belts4

Installing a child restraint sys-tem to the lower anchorage (ISOFIX child restraint mount-ings) and tether anchorage*
E00408901980
Lower anchorage location
Your vehicle’s rear seat (3-door models)/ second seat (5-door models) is fitted with
lower anchorages for attaching a child re- straint system with ISOFIX mountings.
Tether anchorage locations
There are 2 attachment points on the floor, located behind the rear seat (3-door models)/
second seat (5-door models). These are for securing a child restraint system tether strap to both of the 2 rear (3-door models)/second (5-door models) seating positions in your ve-
hicle.
WARNINGl Child restraint anchorages are designed
to withstand only those loads imposed by
correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts, harnesses, or for attach-
ing other items or equipment to the vehi- cle.Child restraint system with
ISOFIX mountings
The child restraint system is designed only
for seats that incorporate lower anchorages.
Retain the child restraint system using the lower anchorages.
It is not necessary to retain the child restraint
system using the vehicle’s seat belts.
A: Child restraint System connectors
To install
1. Remove any foreign material in or
around the connectors and ensure the ve-
hicle seat belt is in its normal storage po-
sition.
2. Remove the head restraint from the loca-
tion in which you wish to install a child
restraint.
Refer to “Head restraints” on page 4-12.
Child restraint
4-34OVWE16E1Seat and seat belts4

3.Push the child restraint system’s connec-
tors (A) into the slits (B) in accordance with the instructions provided by the
child restrain system’s manufacturer.
A- Connector B- Slit
C- Vehicle seatback
D- Vehicle seat cushion E- Lower anchorage
If your child restraint system requires the
use of a tether strap, fasten the tether strap in accordance with steps 4 through 5.
4. Open the cover from the tether anchor-
age installation point by pulling it back
with your hand as illustrated.
5. Latch the top tether strap hook (F) of the
child restraint system to the tether an- chorage bracket (G) and tighten the top
tether strap so that it is securely fas- tened.
WARNINGl Do not latch the top tether strap hook to
any place, for example the luggage hook (H), other than the tether anchorage
bracket (I), or the child restraint system could not be fastened securely, resulting
in serious injury in the event of a collision.
6. Push and pull the child restraint system
in all directions to be sure it is firmly se- cured.
To remove
Remove the child restraint in accordance
with the instructions provided by the child re-
straint system’s manufacturer.
Installing a child restraint sys-
tem to a 3-point type seat belt
E00408701887
3-door models5-door models
Installation:
1. Put a child restraint system on the seat in
which you wish to install it, and remove
the head restraint from the seat.
Refer to “Head restraints” on page 4-12.
Child restraint
4-35OVWE16E1Seat and seat belts4

2.Fasten the seat belt to secure the child
restraint system. Make sure you hear a “click” when you insert the latch plate in
the buckle.
3. Remove all slack by using the locking
clip.
4. Push and pull the child restraint in all di-
rections to be sure it is secure.WARNINGl For some types of child restraint, the lock-
ing clip (A) should be used to help avoid personal injury during a collision or sud-den manoeuvre.
It must be fitted and used in accordance
with the child restraint manufacturer’s instructions.
The locking clip must be removed when the child restraint is removed.Seat belt inspection
E00406300475
l Check the belts for cuts, worn or frayed
webbing and for cracked or deformed metallic parts. Replace the belt assembly
if it is defective.
l A dirty belt should be cleaned with neu-
tral detergent in warm water. After rins-
ing in water, let it dry in the shade. Do
not attempt to bleach or re-dye the belts
because this will affect their characteris-
tics.WARNINGl We recommend you to have all seat belt
assemblies including retractors and at- taching hardware inspected after any col- lision. We recommend that seat belt as-
semblies in use during a collision be re- placed unless the collision was minor and
the belts show no damage and continue to operate properly.
l Do not attempt to repair or replace any
part of the seat belt assemblies; we recom- mend you to have this work done by aMITSUBISHI MOTORS Authorized
Service Point. Incorrect repair or replace- ment could reduce the effectiveness of the
belts and could result in serious injury in
the event of a collision.WARNINGl Once the pretensioner has been activated,
it cannot be re-used.
It must be replaced together with the re- tractor.Supplemental restraint
system (SRS) - airbag E00407203397
The information written in this Supplemental
Restraint System (SRS) section contains im- portant points concerning the driver, front
passenger, side and curtain airbags.
The SRS driver’s and front passenger’s air- bags are designed to supplement the primary
protection of the driver and front passenger
side seat belt systems by providing those oc- cupants with protection against head and
chest injuries in certain moderate-to-severe
frontal collisions.
The SRS driver’s and front passenger’s air- bags employ a dual stage airbag system. The
SRS driver’s and front passenger’s airbag is controlled by the impact sensors (at the frontof the vehicle) and the control unit (near the
centre of the vehicle at floor level).

Seat belt inspection
4-36OVWE16E1Seat and seat belts4

The SRS side airbag (if so equipped) is de-
signed to supplement properly worn seat belts and provide the driver and front passen- ger with protection against chest injury in
certain moderate-to-severe side impact colli- sions.

The SRS curtain airbags (if so equipped) are designed to supplement properly worn seat
belts and provide the driver and passenger with protection against head injuries in cer-tain moderate-to-severe side impact colli-sions.

The SRS is NOT a substitute for the seat
belts; for maximum protection in all types of
crashes and accidents, seat belts should AL- WAYS be worn by everyone who drives or
rides in this vehicle.How the Supplemental Re-
straint System works
E00407302939
The SRS includes the following components:
1- Airbag module (Driver)
2- Front passenger’s airbag OFF indication
lamp
3- Airbag module (Passenger)
4- Front passenger’s airbag ON-OFF
switch
5- Side airbag modules*
6- Curtain airbag modules*
The airbags will operate only when the igni- tion switch is in the “ON” or “START” posi-
tion.

The airbags deployment produces a sudden, loud noise, and releases some smoke and
powder, but these conditions are not injuri- ous, and do not indicate a fire in the vehicle.
People with respiratory problems may feel some temporary irritation from chemicals
used to produce the deployment; open the
windows after airbag deployment, if safe to
do so.
The airbags deflate very rapidly after deploy- ment, so there is little danger of obscured vi-sion.CAUTIONl Airbags inflate at an extremely rapid speed.
In certain situations, contact with inflating
airbags can result in abrasions, light cuts, bruises, and the like.
Supplemental restraint system (SRS) - airbag
4-37OVWE16E1Seat and seat belts4