ECO mode NISSAN 350Z 2007 Z33 Audio Visual, Navigation And Telephone System

AV-74
NAVIGATION SYSTEM
Revision: 2006 November2007 350Z
Special Note for Trouble DiagnosisNKS002JP
Prior to perform trouble diagnosis, make sure there are no corresponding description in the “Example of
Symptoms Possible No Malfunction”. Refer to AV- 9 5 , "
Example of Symptoms Possible No Malfunction" .
On Board Self-Diagnosis FunctionNKS000D6
DESCRIPTION

Trouble diagnosis function of navigation system has a Self Diagnosis mode by automatic operation and a
Confirmation/Adjustment mode by manual operation.

Self Diagnosis mode checks for connections between the units constituting this system, analyzes each
individual unit at the same time, and displays the results on the display unit.

Confirmation/Adjustment mode displays trouble diagnosis that require an operation and a judgment by a
human (auto-decision can not be performed by the system), confirmation of preset value, and an error his-
tory.
DIAGNOSIS ITEM
Self Diagnosis ModeNKS000D7
OPERATION PROCEDURE
1. Start the engine.
2. Press and hold “MAP” and “ ” buttons simultaneously for 5
seconds or more.

Shifting from current screen to previous screen is performed
by pressing “BACK” button.
Mode Description
Self Diagnosis

NAVI control unit diagnosis (DVD-ROM drive will not be diagnosed when no
DVD-ROM is in it.).

Analyzes connection between the NAVI control unit and the GPS antenna, con-
nection between the NAVI control unit and each unit, and operation of each unit.
Confirmation/
AdjustmentDisplay DiagnosisColor tone and shading of the screen can be checked by the display of a color bar
and a gray scale.
Vehicle SignalsDiagnosis of signals that are input to NAVI control unit can be performed for Vehicle
speed, Lights, Ignition and Reverse.
NavigationSteering Angle
AdjustmentThis mode is used to correct difference between actual turning angle of a vehicle
and turning angle of the vehicle mark on the display.
Speed CalibrationUnder ordinary conditions, the navigation system distance measuring function will
automatically compensate for minute decreases in wheel and tire diameter caused
by tire wear or low-pressure. Speed Calibration can immediately restore system
accuracy in cases such as when distance calibration is needed because of the use
of tire chains.
Error HistoryMalfunctions that occurred in the past are displayed, along with the number of times
each has occurred. Time and location when/where the errors occurred are also dis-
played.
Delete Unit Connection Log Erase the connection history of unit and error history.
SKIB7380E

NAVIGATION SYSTEM
AV-77
C
D
E
F
G
H
I
J
L
MA
B
AV
Revision: 2006 November2007 350Z
Confirmation/Adjustment ModeNKS000D8
OPERATION PROCEDURE
1. Start the engine.
2. Press and hold “MAP” and “ ” buttons simultaneously for 5
seconds or more.

Shifting from current screen to previous screen is performed
by pressing “BACK” button.
3. The initial trouble diagnosis screen will be shown, and items
“Self Diagnosis” and “Confirmation/Adjustment” will become
selective.
4. Select “Confirmation/Adjustment”.
5. Each diagnosis is shown by selecting each screen switch on
Confirmation/Adjustment screen.
SKIB7380E
SKIB6974E
SKIB7386E

NAVIGATION SYSTEM
AV-95
C
D
E
F
G
H
I
J
L
MA
B
AV
Revision: 2006 November2007 350Z
Example of Symptoms Possible No MalfunctionNKS002JQ
For Navigation System operation information, refer to Navigation System Owner's Manual.
BASIC OPERATIONS
NOTE:
Locations stored in the Address Book and other memory functions may be lost if the vehicle's battery is disconnected or is discharged. If
this occurs, service the vehicle's battery as necessary and re-enter the information in the Address Book.
VEHICLE MARKS
Symptom Possible cause Possible solution
No image is displayed.The brightness is at the lowest setting. Adjust the brightness of the display.
The display is turned off.Press and hold the button to turn on the
display.
No voice guidance is available. or
The volume is too high or too low.The volume is not set correctly, or it is turned
off.Adjust the volume of voice guidance.
No map is displayed on the
screen.The DVD-ROM is not inserted, or it is inserted
upside down.Insert the DVD-ROM correctly.
A screen other than map screen is displayed. Press the “MAP” button.
The pickup lens of the DVD unit is dirty.The pickup lens can become dirty depending
on how you use the vehicle. Contact a NIS-
SAN dealer or qualified workshop for pickup
lens cleaning.
The screen is too dim. The move-
ment is slow.The temperature in the interior of the vehicle is
low.Wait until the interior of the vehicle has
warmed up.
Some pixels in the display are
darker or brighter than others.This condition is an inherent characteristic of
liquid crystal displays.This is not a malfunction.
Some menu items cannot be
selected.Some menu items become unavailable while
the vehicle is driven.Park the vehicle in a safe location, then oper-
ate the navigation system.
Symptom Possible cause Possible solution
Names of roads and locations dif-
fer between plan view and BIRD-
VIEW
™ .This is because the quantity of the displayed
information is reduced so that the screen does
not become difficult to read. There is also a
chance that names of the roads or locations
may be displayed several times, and the names
appearing on the screen may be different
because of a processing procedure.This is not a malfunction.
The vehicle mark is not displayed
in the correct position.The vehicle was transported after the ignition
switch was turned off, for example, by a ferry or
car transporter.Drive the vehicle for a while on a road where
GPS signals can be received.
The position and direction of the vehicle mark
may be incorrect depending on the driving envi-
ronments and the levels of positioning accuracy
of the navigation system.This is not a malfunction. Drive the vehicle for
a while to automatically correct the position
and direction of the vehicle mark.
When the vehicle is travelling on a
new road, the vehicle mark is
located on another road nearby.The system automatically places the vehicle
mark on the nearest available road, because
the new road is not stored in the map data.Updated road information will be included in
the next version of the DVD-ROM.
The screen does not switch to the
night screen even after turning on
the headlights.The daytime screen was set the last time the
headlights were turned on.Set the screen to the night screen mode using
button when you turn on the headlights.
The map does not scroll even
when the vehicle is moving.The current location map screen is not dis-
played.Press the “MAP” button.
The vehicle mark is not displayed.The current location map screen is not dis-
played.Press the “MAP” button.