engine NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual 350Z 2007 Z33 NISSAN NISSAN https://www.carmanualsonline.info/img/5/765/w960_765-0.png NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual

Page 77 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual CAMSHAFT
EM-77
C
D
E
F
G
H
I
J
K
L
MA
EM
Revision: 2006 November2007 350Z
INSTALLATION
1. Install timing chain tensioners (secondary) (1) on both sides of
cylinder head.
Install timing chain tensione

Page 79 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual CAMSHAFT
EM-79
C
D
E
F
G
H
I
J
K
L
MA
EM
Revision: 2006 November2007 350Z
5. Tighten camshaft bracket bolts in the following steps, in numeri-
cal order as shown in the figure.
a. Tighten No. 7 to 10

Page 80 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual EM-80
CAMSHAFT
Revision: 2006 November2007 350Z
4. Crank the engine, and then make sure that engine oil comes out
from valve timing control solenoid valve hole. End crank after
checking.
WARNING:
Be c

Page 81 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual CAMSHAFT
EM-81
C
D
E
F
G
H
I
J
K
L
MA
EM
Revision: 2006 November2007 350Z
In cases of removing/installing or replacing camshaft and valve-
related parts, or of unusual engine conditions due to changes

Page 82 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual EM-82
CAMSHAFT
Revision: 2006 November2007 350Z
By referring to the figure, measure the valve clearances at
locations marked “×” as shown in the table below (locations
indicated in the figure).

Page 83 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual CAMSHAFT
EM-83
C
D
E
F
G
H
I
J
K
L
MA
EM
Revision: 2006 November2007 350Z
By referring to the figure, measure the valve clearances at
locations marked “×” as shown in the table below (locations

Page 85 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual CAMSHAFT
EM-85
C
D
E
F
G
H
I
J
K
L
MA
EM
Revision: 2006 November2007 350Z
Thickness of new valve lifter can be identified by stamp marks
on the reverse side (inside the cylinder). 
Stamp mark 788T in

Page 86 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual EM-86
OIL SEAL
Revision: 2006 November2007 350Z
OIL SEALPFP:00100
Removal and Installation of Valve Oil SealNBS0000V
REMOVAL
1. Remove camshaft relating to valve oil seal to be removed. Refer to EM-72

Page 87 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual OIL SEAL
EM-87
C
D
E
F
G
H
I
J
K
L
MA
EM
Revision: 2006 November2007 350Z
Removal and Installation of Front Oil SealNBS0000W
REMOVAL
1. Remove the following parts:
Undercover
Drive belts: Refer to E

Page 88 of 148

NISSAN 350Z 2007 Z33 Engine Mechanical Repair Manual EM-88
OIL SEAL
Revision: 2006 November2007 350Z
4. Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage crankshaft and cylinder block.
INSTALLATION
1. Apply new engine oil to n