instrument panel NISSAN 350Z 2007 Z33 Lighting System Workshop Manual

LT-84
LIGHTING AND TURN SIGNAL SWITCH
Revision: 2006 November2007 350Z
LIGHTING AND TURN SIGNAL SWITCHPFP:25540
Removal and InstallationNKS004YK
REMOVAL
1. Remove steering column lower cover. Refer to IP-10, "INSTRU-
MENT PANEL ASSEMBLY" .
2. Remove column upper cover and combination meter assembly.
Refer to IP-10, "
INSTRUMENT PANEL ASSEMBLY" .
3. While pressing pawls in direction as shown in the figure, pull
lighting and turn signal switch toward driver door and disconnect
from the base.
INSTALLATION
Installation is the reverse order of removal.
PKIB4968E

HAZARD SWITCH
LT-85
C
D
E
F
G
H
I
J
L
MA
B
LT
Revision: 2006 November2007 350Z
HAZARD SWITCHPFP:25290
Removal and InstallationNKS004YL
HAZARD SWITCH (A/T MODELS)
Removal
1. Remove console finisher (1). Refer to IP-10, "INSTRUMENT
PANEL ASSEMBLY" .
2. Disconnect hazard switch connector (2).
3. Remove screw (A), and remove hazard switch (3).
Installation
Installation is the reverse order of removal.
HAZARD SWITCH (M/T MODELS)
Removal
1. Removal console boot (1). Refer to IP-10, "INSTRUMENT
PANEL ASSEMBLY" .
2. Disconnect hazard switch connector (2).
3. Remove screw (A), and remove hazard switch (3).
Installation
Installation is the reverse order of removal.
PKIC4854E
PKIC5287J

LT-154
INTERIOR ROOM LAMP
Revision: 2006 November2007 350Z
VANITY MIRROR LAMP
1. Insert a thin screwdriver in the lens end and remove lens.
2. Remove bulb.
3. Installation is the reverse order of removal.
LUGGAGE ROOM LAMP & TRUNK ROOM LAMP
Luggage Room Lamp (Coupe Models)
1. Remove luggage room lamp. Refer to LT- 1 5 5 , "Removal and Installation" .
2. Remove bulb.
3. Installation is the reverse order of removal.
Trunk Room Lamp (Roadster Models)
1. Unfold pawl A and remove lens.
2. Remove trunk room lamp while pressing pawl B in the direction
of the arrow.
3. Disconnect trunk room lamp connector.
4. Installation is the reverse order of removal.
IGNITION KEY HOLE ILLUMINATION
1. Remove instrument lower driver panel. Refer to IP-10,
"INSTRUMENT PANEL ASSEMBLY" .
2. Turn bulb socket to left to release lock and remove bulb socket
(1).
3. Remove ignition key illumination bulb (2) from its socket.
4. Installation is the reverse order of removal.Vanity mirror lamp : 12V - 1.32W
PKIA7806E
Luggage room lamp : 12V - 5W
PKIA1885E
Trunk room lamp : 12V - 3.4W
PKIA0182E
Ignition key hole illumination : 12V - 1.4W
PKIC4830J