ABS NISSAN 350Z 2007 Z33 Power Supply, Ground And Circuit Workshop Manual

HARNESS
PG-67
C
D
E
F
G
H
I
J
L
MA
B
PG
Revision: 2006 November2007 350Z
Wiring Diagram Codes (Cell Codes) NKS000EH
Use the chart below to find out what each wiring diagram code stands for.
Refer to the wiring diagram code in the alphabetical index to find the location (page number) of each wiring
diagram.
Code Section Wiring Diagram Name
3METER DI Triple Meter
ABS BRC Anti-Lock Braking System
A/C ATC Air Conditioner
AF1B1 EC Air Fuel Ratio Sensor 1 (Bank 1)
AF1B2 EC Air Fuel Ratio Sensor 1 (Bank 2)
AF1HB1 EC Air Fuel Ratio Sensor 1 Heater (Bank 1)
AF1HB2 EC Air Fuel Ratio Sensor 1 Heater (Bank 2)
APPS1 EC Accelerator Pedal Position Sensor
APPS2 EC Accelerator Pedal Position Sensor
APPS3 EC Accelerator Pedal Position Sensor
ASC/BS EC Automatic Speed Control Device (ASCD) Brake Switch
ASC/SW EC Automatic Speed Control Device (ASCD) Steering Switch
ASCBOF EC Automatic Speed Control Device (ASCD) Brake Switch
ASCIND EC Automatic Speed Control Device (ASCD) Indicator
AT/IND DI A/T Indicator Lamp
AUDIO AV Audio
BACK/L LT Back-Up Lamp
BRK/SW EC Brake Switch
CAN AT CAN Communication Line
CAN EC CAN Communication Line
CAN LAN CAN System
CHARGE SC Charging System
CHIME DI Warning Chime
COMBSW LT Combination Switch
COMM AV Audio Visual Communication Line
COOL/F EC Cooling Fan Control
DEF GW Rear Window Defogger
D/LOCK BL Power Door Lock
DTRL LT Headlamp - With Daytime Light System
ECM/PW EC ECM Power Supply for Back-Up
ECTS EC Engine Coolant Temperature Sensor
EOTS EC Engine Oil Temperature Sensor
EPS STC Electric Controlled Power Steering System
ETC1B1 EC Electric Throttle Control Function (Bank 1)
ETC1B2 EC Electric Throttle Control Function (Bank 2)
ETC2B1 EC Electric Throttle Control Motor Relay (Bank 1)
ETC2B2 EC Electric Throttle Control Motor Relay (Bank 2)
ETC3B1 EC Electric Throttle Control Motor (Bank 1)
ETC3B2 EC Electric Throttle Control Motor (Bank 2)
EVCB1 EC Exhaust Valve Timing Control Magnet Retarder (Bank 1)
EVCB2 EC Exhaust Valve Timing Control Magnet Retarder (Bank 2)

PG-78
HARNESS CONNECTOR
Revision: 2006 November2007 350Z
HARNESS CONNECTOR (LEVER LOCKING TYPE)

Lever locking type harness connectors are used on certain control units and control modules such as
ECM, ABS actuator and electric unit (control unit), etc.

Lever locking type harness connectors are also used on super multiple junction (SMJ) connectors.

Always confirm the lever is fully locked in place by moving the lever as far as it will go to ensure full con-
nection.
CAUTION:
Always confirm the lever is fully released (loosened) before attempting to disconnect or connect these
connectors to avoid damage to the connector housing or terminals.
LKIA0670E
1. Control unit with single lever
A. Fasten
B. Loosen
C. Lever2. Control unit with dual levers
A. Levers
B. Fasten
C. Loosen3. SMJ connector
A. Lever
B. Fasten
C. Loosen