ABS NISSAN 350Z 2007 Z33 Roof Workshop Manual
[x] Cancel search | Manufacturer: NISSAN, Model Year: 2007, Model line: 350Z, Model: NISSAN 350Z 2007 Z33Pages: 130, PDF Size: 5.4 MB
Page 122 of 130
RF-122
SOFT TOP
Revision: 2006 November2007 350Z
4. Open The Soft Top 5th Bow
Remove both shock absorber of soft top 5th bow.
Open the soft top 5th bow (approximate 90 degrees)
5. Open The Trunk Lid
Pull the emergency cable.
Open the trunk lid.
6. Open The Storage Lid
Remove floorboard inside of the trunk.
Disconnect the storage lid motor harness connector downward
which is in the right hand side of the trunk.
Pull down the storage lid lock release cable (right and left side of
the trunk).
Confirm a clicking sound of lock release.
Pull up the storage lid from the right and left sides of vehicle (two
people are required).
CAUTION:
The storage lid is extremely heavy. Pulling it up should be
done by two people. Use Hex-wrench to rotate the axis of
the gear, when storage lid does not move.
Disconnect roof actuator harness connector right and left side (disconnect top of roof actuator harness
connector right and left side).
7. Open The Soft Top
Lower the soft top 5th bow.
Unlock the front lock.
Open the soft top right and left side of the vehicle slowly by hand (two person job).
8. Close The Storage Lid
NOTE:
If necessary.
9. Close The Trunk Lid
NOTE:
If necessary.
PIIB1437E
Page 125 of 130
STORAGE LID
RF-125
C
D
E
F
G
H
J
K
L
MA
B
RF
Revision: 2006 November2007 350Z
9. Disconnect lock harness connector, and then remove lock from inspection cover. (j in the figure)
NOTE:
Turn lock catcher counterclockwise, and then face it to storage lid inspection hole side to remove because
it interferes with storage lid when removing.
10. Disconnect closure harness connector, and then remove closure from inspection cover. (k in the figure)
11. Disconnect unlock actuator, lock, and closure harness connectors from inspection cover.
(Push in harness connector clip tabs from back of storage lid using a screwdriver so as to remove.)
INSTALLATION
Install in the reverse order of removal.