brake NISSAN 370Z COUPE 2014 Z34 Quick Reference Guide

6
REAR HATCH/TRUNk LID RELEASE
It is important to make sure the NISSAN Intelligent
key® is with you (that is, in your pocket or purse).

Unlock the rear hatch/trunk lid by pushing the
request switch
01 .

Once unlocked, push the opener switch
02 and

pull up to open the rear hatch/trunk lid.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”
of your Owner’s Manual.0102
SOFT TOP OPERATION ( Roadster models)
Before opening or closing your soft top, refer to the
Owner’s Manual for detailed warnings and cautions
regarding soft top operation.
Soft Top Operation
1. Make sure the area is clear of obstructions and
that there is at least 6 ft (2 m) of clearance above
the vehicle.
2. Apply the parking brake and move the shift lever to
the P (P ARk) position (automatic transmission) or
the N (N EUTRAL ) position (manual transmission).
3. Depress the brake pedal and the clutch pedal
(manual transmission).
4. Start the engine.
5. Push and hold the soft top operating switch,
located on the center console, to OPEN

01 or

CLOSE
02 until the top is fully opened or closed.

For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
01
02
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
first drive features

8
STARTING/STOPPING THE ENGINE
It is important to make sure the NISSAN Intelligent
key® is with you (that is, in your pocket or purse).
AUTOMATI c TRANSMISSION (if so equipped)

Depress the brake pedal.
• If the brake pedal is not depressed, pushing the
ignition switch once will activate the ACC mode.
• Pushing the ignition switch a second time will
activate the ON mode.

Move the shift lever to P (PAR k).

Press the ignition switch START/STOP button to start the engine.
MANUAL TRANSMISSION (if so equipped)

Depress the brake pedal.

Move the shift lever to N (NEUTRAL).

Depress the clutch pedal to the floor.
• If the clutch pedal is not depressed, pushing the ignition switch once will activate the
ACC mode.
• Pushing the ignition switch a second time will activate the ON mode.

Press the ignition switch START/STOP button to start the engine.
TURNING THE ENGINE OFF

For an automatic transmission, move the shift lever to the P (PAR k) position, apply the
parking brake and press the ignition switch START/STOP button to turn the engine off.

For a manual transmission, move the shift lever to the N (NEUTRAL) position, apply the
parking brake, place the vehicle in 1st gear and press the ignition switch START/STOP
button to turn the engine off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
first drive features

12
CRUISE CONTROL
The cruise control system enables you to set a
constant cruising speed once the vehicle has
reached 25 MPH (40 km/h).

The system will automatically maintain the set speed
until you tap the brake pedal, accelerate, cancel or
turn the system off.

To activate the cruise control, push the ON/OFF
01
switch. The CRUISE indicator light in the instrument
panel will illuminate.

To set cruising speed, accelerate the vehicle to the desired speed, push \
the COAST/SET


02 switch and release. Take your foot off the accelerator pedal. Your vehicle will maintain

the set speed.

To reset at a faster cruising speed, push and hold the ACCEL/RES
03 switch. When the
vehicle attains the desired speed, release the switch.

To reset at a slower cruising speed, push and hold the COAST/SET
02 switch. Release

the switch when the vehicle slows to the desired speed.

To cancel the preset speed, tap the brake pedal or push the CANCEL switch
04 .

To turn off cruise control, push the ON/OFF
01 switch. The CRUISE
indicator light in the
instrument panel will turn off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
03
02
04
01
02
03
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
first drive features
CLOCk SET/ADJUSTMENT
Adjust the clock
01 using the trip computer’s

switch
02 and
switch
03 :
1. Press

until the
SETTING mode appears in
vehicle information display.
2. Press

until
CLOCk is highlighted.
3. Press

. The clock mode setting menu appears.
4. Press

to enter the clock setting mode.
5. Press

to begin setting the clock.
6. Press

to select hours, then press
. Hours
is selected and minutes is highlighted.
7. Press

to set minutes, then press
to
complete the clock set procedure.
For more information, refer to the “Instruments and controls (section 2)”
of your Owner’s Manual.